ST Engineering Telematics Wireless 2WREP1 ALLEGRO REPEATER User Manual Allegro Repeater Installation instructions

Telematics Wireless Ltd. ALLEGRO REPEATER Allegro Repeater Installation instructions

Contents

User manual

Arad Technologies Ltd. Yokneam Elite 20692, Israel Tel:(972)49935222, Fax:(972)49935227 Allegro Repeater Installation Instructions 31-Mar-14 www.aradtec.com Allegro Repeater (2WREP)Installation Instructions FCC ID: NTA2WREP1 (2WREP)
Arad Technologies Ltd. Yokneam Elite 20692, Israel Tel:(972)49935222, Fax:(972)49935227 Compliance with FCC Regulations CAUTION The User and the Installer should be aware that changes and modifications to the equipment not expressly approved by Master Meter could void warranty and the user's authority to operate the equipment. Professionally trained personnel should install the eq ATTENTION The digital portion of the transceiver has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful iin a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is noguarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1) Reorient or relocate the receiving antenna.2) Increase the separation between the equipment and receiver.3) Connect the equipment into an outlet on a circuit different from that to wthe receiver is connected.4) Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful (2) This device must accept any interference received, including interference that may cause undesired operation. www.aradtec.com Compliance with FCC RegulationsThe User and the Installer should be aware that changes and modifications to the equipment not expressly approved by Master Meter could void warranty and the user's authority to operate the equipment. Professionally trained personnel should install the equipment.The digital portion of the transceiver has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful iin a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is noguarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to ect the interference by one or more of the following measures: ) Reorient or relocate the receiving antenna. ) Increase the separation between the equipment and receiver.) Connect the equipment into an outlet on a circuit different from that to wthe receiver is connected. ) Consult the dealer or an experienced radio/TV technician for help.This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. The User and the Installer should be aware that changes and modifications to the equipment not expressly approved by Master Meter could void warranty and the user's authority to operate the equipment. uipment.The digital portion of the transceiver has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to ect the interference by one or more of the following measures: ) Increase the separation between the equipment and receiver. ) Connect the equipment into an outlet on a circuit different from that to which ) Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of FCC Rules. Operation is subject to the (2) This device must accept any interference received, including interference that
Arad Technologies Ltd. Yokneam Elite 20692, Israel Tel:(972)49935222, Fax:(972)49935227 Table ofContent 1. INTRODUCTION ................................2. ABOUT 2WREP ................................2.1. 2WREP EXTERNAL PICTURE2.2. 2WREP INTERNAL PICTU2.3. FCC LABEL ................................2.4. ENVIRONMENTAL CONDITIONS3. INSTALLATION INSTRUC www.aradtec.com ................................................................................................................................................................................................PICTURE................................................................................................2WREP INTERNAL PICTURE ................................................................................................................................................................................................................................ONDITIONS ................................................................................................INSTALLATION INSTRUCTION ................................................................................................ .............................................................................. 4 ............................................................................... 4 ............................................................ 4 ............................................................ 5 ....................................................... 5 ..................................................... 6 ........................................................ 6
Arad Technologies Ltd. Yokneam Elite 20692, Israel Tel:(972)49935222, Fax:(972)49935227 1. Introduction The Allegro repeater (“2WREP”) transceiver unit operates at 450 The 2WREP unit is designated to transceiver/ collects wireless transmissions of water meter. The 2WREP send the collected data 2. About 2WREP 2.1. 2WREP external picture www.aradtec.com ntroduction The Allegro repeater (“2WREP”) is a plug and play multi-channel/ frequency RF transceiver unit operates at 450 – 470MHz ISM band. designated to transceiver/ collects wireless transmissions of 2WREP send the collected data through internal/ external antenna.About 2WREP external picture Figure 1 channel/ frequency RF designated to transceiver/ collects wireless transmissions of internal/ external antenna.
Arad Technologies Ltd. Yokneam Elite 20692, Israel Tel:(972)49935222, Fax:(972)49935227 2.2. 2WREP internal 2.3. FCC Label www.aradtec.com internal picture Figure 2 Figure 3
Arad Technologies Ltd. Yokneam Elite 20692, Israel Tel:(972)49935222, Fax:(972)49935227 2.4. Environmental Conditions Operating Temperature: Storage Temperature: Humidity: Up to 95% 3. Installation instructionThe 2WREP can be installedAttach the relevant hanging kitFigure 4, Figure 5) to the back of the 2WREP according to required hanging destination. Figure www.aradtec.com Environmental Conditions Operating Temperature: -40° C to + 70° C Storage Temperature: -40 °C to + 70 °C Humidity: Up to 95% Installation instruction The 2WREP can be installed on both walls and light poles. Attach the relevant hanging kit (see to the back of the 2WREP according to required hanging Figure 4 – Light pole hanging kit to the back of the 2WREP according to required hanging
Arad Technologies Ltd. Yokneam Elite 20692, Israel Tel:(972)49935222, Fax:(972)49935227 Open the 2WREP box by pushing the locking tab and make sure that Antenna connected properly. Do not open the repeater with strength, push the www.aradtec.com Figure 5 – Wall hanging kit Open the 2WREP box by pushing the locking tab and make sure that Antenna Figure 6 Pay attention!! Do not open the repeater with strength, push the locking tabs and pull the hinges Open the 2WREP box by pushing the locking tab and make sure that Antenna Do not open the repeater with strength, push the locking tabs and pull the hinges.
Arad Technologies Ltd. Yokneam Elite 20692, Israel Tel:(972)49935222, Fax:(972)49935227 Connect the 2WREP to power source (110VAC) and change the transceiver switch into “ON” state, see Figure Working 2WREP indicates with green and orange blinking LED’s. Close the 2WREP box it is now ready to collect water meters. www.aradtec.com Connect the 2WREP to power source (110VAC) and change the transceiver switch Figure 7. Figure 7 Working 2WREP indicates with green and orange blinking LED’s. Close the 2WREP box it is now ready to collect water meters. Connect the 2WREP to power source (110VAC) and change the transceiver switch Working 2WREP indicates with green and orange blinking LED’s. Close the 2WREP box it is now ready to collect water meters.

Navigation menu