ST Engineering Telematics Wireless 2WREP1 ALLEGRO REPEATER User Manual Allegro Repeater Installation instructions

Telematics Wireless Ltd. ALLEGRO REPEATER Allegro Repeater Installation instructions

Contents

User manual

Arad Technologies Ltd.
Yokneam Elite 20692, Israel
Tel:(972)49935222, Fax:(972)49935227
Allegro Repeater
Installation
Instructions
31-Mar-14
www.aradtec.com
Allegro Repeater
(2WREP)
Installation
Instructions
FCC ID: NTA2WREP1
Arad Technologies Ltd.
Yokneam Elite 20692, Israel
Tel:(972)49935222, Fax:(972)49935227
Compliance with FCC Regulations
CAUTION
The User and the Installer should be aware that changes and
modifications to the equipment not expressly approved by Master Meter
could void warranty and the user's authority to operate the equipment.
Professionally trained personnel should install the eq
ATTENTION
The digital portion of the transceiver has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful i
in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to corr
ect the interference by one or more of the following measures:
1
) Reorient or relocate the receiving antenna.
2
) Increase the separation between the equipment and receiver.
3
) Connect the equipment into an outlet on a circuit different from that to w
the receiver is connected.
4
) Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
(2) This device must accept any interference received, including interference that
may cause undesired operation.
www.aradtec.com
Compliance with FCC Regulations
The User and the Installer should be aware that changes and
modifications to the equipment not expressly approved by Master Meter
could void warranty and the user's authority to operate the equipment.
Professionally trained personnel should install the eq
uipment.
The digital portion of the transceiver has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful i
in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
ect the interference by one or more of the following measures:
) Reorient or relocate the receiving antenna.
) Increase the separation between the equipment and receiver.
) Connect the equipment into an outlet on a circuit different from that to w
the receiver is connected.
) Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
The User and the Installer should be aware that changes and
modifications to the equipment not expressly approved by Master Meter
could void warranty and the user's authority to operate the equipment.
uipment.
The digital portion of the transceiver has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful i
nterference
in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
ect the interference by one or more of the following measures:
) Increase the separation between the equipment and receiver.
) Connect the equipment into an outlet on a circuit different from that to w
hich
) Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of FCC Rules. Operation is subject to the
(2) This device must accept any interference received, including interference that
Arad Technologies Ltd.
Yokneam Elite 20692, Israel
Tel:(972)49935222, Fax:(972)49935227
Table ofContent
1.
INTRODUCTION
................................
2.
ABOUT 2WREP
................................
2.1.
2WREP EXTERNAL
PICTURE
2.2.
2WREP INTERNAL PICTU
2.3.
FCC LABEL
................................
2.4.
ENVIRONMENTAL C
ONDITIONS
3.
INSTALLATION INSTRUC
www.aradtec.com
................................
................................
................................
................................
................................
................................
PICTURE
................................................................
................................
2WREP INTERNAL PICTU
RE ................................................................
................................
................................
................................................................
................................
ONDITIONS
................................................................
................................
INSTALLATION INSTRUC
TION ................................................................
................................
................................
.............................................. 4
................................
............................................... 4
................................
............................ 4
................................
............................ 5
................................
....................... 5
................................
..................... 6
................................
........................ 6
Arad Technologies Ltd.
Yokneam Elite 20692, Israel
Tel:(972)49935222, Fax:(972)49935227
1. I
ntroduction
The Allegro repeater (“2WREP”)
transceiver unit operates at 450
The 2WREP unit is
designated to transceiver/ collects wireless transmissions of
water meter.
The
2WREP send the collected data
2.
About 2WREP
2.1. 2WREP
external picture
www.aradtec.com
ntroduction
The Allegro repeater (“2WREP”)
is a plug and play multi-
channel/ frequency RF
transceiver unit operates at 450
– 470MHz ISM band.
designated to transceiver/ collects wireless transmissions of
2WREP send the collected data
through
internal/ external antenna.
About 2WREP
external picture
Figure 1
channel/ frequency RF
designated to transceiver/ collects wireless transmissions of
internal/ external antenna.
Arad Technologies Ltd.
Yokneam Elite 20692, Israel
Tel:(972)49935222, Fax:(972)49935227
2.2. 2WREP
internal
2.3. FCC Label
www.aradtec.com
internal
picture
Figure 2
Figure 3
Arad Technologies Ltd.
Yokneam Elite 20692, Israel
Tel:(972)49935222, Fax:(972)49935227
2.4.
Environmental Conditions
Operating Temperature:
Storage Temperature:
Humidity: Up to 95%
3.
Installation instruction
The 2WREP can be installed
Attach the relevant hanging kit
Figure
4
, Figure 5)
to the back of the 2WREP according to required hanging
destination.
Figure
www.aradtec.com
Environmental Conditions
Operating Temperature:
-40° C to + 70° C
Storage Temperature:
-40 °C to + 70 °C
Humidity: Up to 95%
Installation instruction
The 2WREP can be installed
on both walls and light poles.
Attach the relevant hanging kit
(see
to the back of the 2WREP according to required hanging
Figure
4 – Light pole hanging kit
to the back of the 2WREP according to required hanging
Arad Technologies Ltd.
Yokneam Elite 20692, Israel
Tel:(972)49935222, Fax:(972)49935227
Open the 2WREP box by pushing the locking tab and make sure that Antenna
connected properly.
Do not open the repeater with strength, push the
www.aradtec.com
Figure 5 – Wall hanging kit
Open the 2WREP box by pushing the locking tab and make sure that Antenna
Figure 6
Pay attention!!
Do not open the repeater with strength, push the
locking tabs and pull the hinges
Open the 2WREP box by pushing the locking tab and make sure that Antenna
Do not open the repeater with strength, push the
locking tabs and pull the hinges
.
Arad Technologies Ltd.
Yokneam Elite 20692, Israel
Tel:(972)49935222, Fax:(972)49935227
Connect the 2WREP to power source (110VAC) and change the transceiver switch
into “ON” state, see
Figure
Working 2WREP indicates with green and orange blinking LED’s.
Close the 2WREP box it is now ready to collect water meters.
www.aradtec.com
Connect the 2WREP to power source (110VAC) and change the transceiver switch
Figure
7.
Figure 7
Working 2WREP indicates with green and orange blinking LED’s.
Close the 2WREP box it is now ready to collect water meters.
Connect the 2WREP to power source (110VAC) and change the transceiver switch
Working 2WREP indicates with green and orange blinking LED’s.
Close the 2WREP box it is now ready to collect water meters.

Navigation menu