ST Engineering Telematics Wireless WB2 Water meter booster User Manual Booster Ins For FCC

Telematics Wireless Ltd. Water meter booster Booster Ins For FCC

user manual

101 REGENCY PARKWAY MANSFIELD, TX 76063 817-842-8000 FAX 817-842-8100 Dialog - Booster Installation Instructions FCC ID: NTAWB2
101 REGENCY PARKWAY MANSFIELD, TX 76063 817-842-8000 FAX 817-842-8100 Field Operations Factory Default Parameters Magnet initialization Position the magnet on the Booster cone for 5 seconds Booster Status FH Tx On Buzzer Off Magnet Activation On Learning the Pit 3G Meters Install the Booster into the pit within 30 seconds Booster is Ready to Transmit This process is done automatically. After 6-10 minutes the Booster is ready to transmit FCC ID NTAWB2 Magnet Positioning
101 REGENCY PARKWAY MANSFIELD, TX 76063 817-842-8000 FAX 817-842-8100 CAUTION The User and the Installer should be aware that changes and modifications to the equipment not expressly approved by Master Meter could void warranty and the user's authority to operate the equipment. Professionally trained personnel should install the equipment. The antenna used for this transmitter must be installed to normally provide minimum separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter ATTENTION The digital portion of the transceiver has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1.) Reorient or relocate the receiving antenna. 2.) Increase the separation between the equipment and receiver. 3.) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 4.) Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Note: Dialog Booster is designed only for Master Meter meters with Dialog registers.
101 REGENCY PARKWAY MANSFIELD, TX 76063 817-842-8000 FAX 817-842-8100 Installation 1. Remove the Pit-Set Lid 2. Insert and Install the Booster into the Pit-Set Lid
101 REGENCY PARKWAY MANSFIELD, TX 76063 817-842-8000 FAX 817-842-8100 3. Locate the Booster Unit near the Pit-Set. Face the Magnet on the Booster Cone Wait for 5 seconds until its Beep 4. Position the assembled Pit-Set Lid with the Booster unit back on the Pit (after the Beep)

Navigation menu