SUPERSONIC GATE AND DOOR AUTOMATION 371LM Remote control User Manual 114A3092

SUPERSONIC GATE AND DOOR AUTOMATION CO.,LIMITED Remote control 114A3092

User Manual

1. Press and release the “learn” button onthe motor unit. The learn indicator lightwill glow steadily for 30 seconds.2. Within 30 seconds, press and hold thebutton on the hand-held remote. 3. Release the button when the motor unitlight blinks. It has learned the code. Iflight bulbs are not installed, two clicks willbe heard.To Erase All Codes From Motor Unit MemoryTo deactivate any unwanted remote, first erase all codes:Press and hold the “learn” button on motorunit until the learn indicator light goes out(approximately 6 seconds). All previouscodes are now erased. Reprogram eachremote or keyless entry you wish to use.Models 371LM and 371LMC 315MHz Security✚Single Button Remote ControlOWNER’S MANUAL — — —        — — —        — —KG13975KG13975Instructions are Described and Illustrated BelowTo prevent possible SERIOUS INJURY or DEATH from a movinggate or garage door:• ALWAYS keep remote controls out of reach of children. NEVERpermit children to operate, or play with remote controltransmitters.• Activate gate or door ONLY when it can be seen clearly, is properlyadjusted, and there are no obstructions to door travel.• ALWAYS keep gate or garage door in sight until completely closed.NEVER permit anyone to cross path of moving gate or door.WARNINGCAUTION WARNINGWARNINGThe Remote Control BatteriesThe lithium batteries should producepower for up to 5 years. To replace,pry open case with visor clip orscrewdriver, as shown. Insertbatteries positive side up (+).Dispose of old batteries properly.Replacement Parts3V2032 Lithium battery To prevent possible SERIOUS INJURY or DEATH:• NEVER allow small children near batteries.• If battery is swallowed, immediately notify doctor.WARNINGCAUTION WARNINGWARNINGNOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications ofthis receiver and/or transmitter are prohibited, except for changing the code setting or replacingthe battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this devicemust accept any interference received, including interference that may cause undesired operation.Battery positive side up (+)Only for use with 315MHz Security✚garage door openersand universal receivers that have a purple “learn” button.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction

Navigation menu