SUPERSONIC GATE AND DOOR AUTOMATION 371LM Remote control User Manual 114A3092

Download:
Mirror Download [FCC.gov]
Document ID	3979252
Application ID	EBro5Ovx4cgJtcVO3LuY0A==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	22kB (275030 bits)
Date Submitted	2018-08-27 00:00:00
Date Available	2018-08-27 00:00:00
Creation Date	2005-01-12 08:44:48
Producing Software	Acrobat Distiller 6.0.1 for Macintosh
Document Lastmod	2018-08-24 11:33:19
Document Title	114A3092
Document Creator	QuarkXPressâ„¢: LaserWriter 8 8.7.1
Document Author:	The Chamberlain Group, Inc.

Models 371LM and 371LMC 315MHz Security✚ Single Button Remote Control
OWNER’S MANUAL
Only for use with 315MHz Security✚ garage door openers
and universal receivers that have a purple “learn” button.
Instructions are Described and Illustrated Below
KG
KG
WARNING
To prevent possible SERIOUS INJURY or DEATH from a moving
gate or garage door:
• ALWAYS keep remote controls out of reach of children. NEVER
permit children to operate, or play with remote control
transmitters.
• Activate gate or door ONLY when it can be seen clearly, is properly
adjusted, and there are no obstructions to door travel.
• ALWAYS keep gate or garage door in sight until completely closed.
NEVER permit anyone to cross path of moving gate or door.
CAUTION
———
The Remote Control Batteries
———
——
WARNING
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
CAUTION
1. Press and release the “learn” button on
the motor unit. The learn indicator light
will glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote.
3. Release the button when the motor unit
light blinks. It has learned the code. If
light bulbs are not installed, two clicks will
be heard.
To Erase All Codes From Motor Unit Memory
The lithium batteries should produce
power for up to 5 years. To replace,
pry open case with visor clip or
screwdriver, as shown. Insert
batteries positive side up (+).
Dispose of old batteries properly.
NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of
this receiver and/or transmitter are prohibited, except for changing the code setting or replacing
the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
To deactivate any unwanted remote, first erase all codes:
Press and hold the “learn” button on motor
unit until the learn indicator light goes out
(approximately 6 seconds). All previous
codes are now erased. Reprogram each
remote or keyless entry you wish to use.
Battery
positive
side up (+)
Replacement Parts
3V2032 Lithium battery
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be u
sed in portable exposure condition without restriction

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : No
XMP Toolkit                     : Adobe XMP Core 4.2.1-c041 52.342996, 2008/05/07-20:48:00
Producer                        : Acrobat Distiller 6.0.1 for Macintosh
Create Date                     : 2005:01:12 08:44:48-07:00
Modify Date                     : 2018:08:24 11:33:19+08:00
Creator Tool                    : QuarkXPress™: LaserWriter 8 8.7.1
Metadata Date                   : 2018:08:24 11:33:19+08:00
Document ID                     : uuid:e4c35b58-64b0-11d9-8c42-000a95c415b2
Instance ID                     : uuid:8ad1701e-ce37-4a15-8cfc-2ffa96de958d
Format                          : application/pdf
Title                           : 114A3092
Creator                         : The Chamberlain Group, Inc.
Page Layout                     : SinglePage
Page Mode                       : UseOutlines
Page Count                      : 2
Author                          : The Chamberlain Group, Inc.

EXIF Metadata provided by EXIF.tools