SZ DJI Osmo Technology OM1701711 OSMO MOBILE 2 User Manual Osmo Mobile 2 Quick Start Guide
SZ DJI Osmo Technology Co.,Ltd. OSMO MOBILE 2 Osmo Mobile 2 Quick Start Guide
Users Manual
Osmo Mobile 2 The OSMOTM Mobile 2 is an advanced gimbal that turnsyour mobile phone into a smart motion camera bystabilizing it while in motion. It is easy to use, and powerfulfeatures such as ActiveTrack and Motion Timelapse areavailable through the DJI GO app. 1. Mobile Phone Holder 2. Pan Motor 3. Joystick 4. Power/Mode Button 5. Charging Port (Micro USB) 6. Shutter/Record Button 7. System Status LED 8. Battery Level Indicators 9. Tilt Motor 10. Adjustable Arm 11. Balance Adjustment Knob 12. Holder Lock Knob 13. Roll Motor 14. USB Port 15. External Device Mount 16. Zoom In/Out Switch 1. Install the DJI GO App 2. Charging the Battery To charge the Osmo Mobile 2, connect theUSB adapter (not included) to the chargingport using the provided power cable. The battery is fully charged when thesystem status LED become solid white. USB Adapter Charging time : 2 hoursand 35 minutes ( when charging at 2 A) Max Run-time: 15 hours The Osmo Mobile 2 supports charging mobile device. 3. Mount and Balance the Mobile Phone Ensure to mount and balance the mobile phone with Osmo Mobile 2 powered off. Place the mobile phone in the mobile phone holder while pulling out the holder. The system is balanced if the mobile phone remainslevel when released, balanced only by the gimbal. Osmo Mobile 2 supports mount the mobile phone vertically and horizontally. To mount the mobile phone vertically, loosen the holder lock knob and adjust the mobile device holder to mount and balance the mobile device. 4. Connect to the DJI GO App To Power On: Press and hold the button Launch the DJI GO app and then followthe instructions to connect to the Osmo Mobile 2. Activate the Osmo Mobile 2 when using it for the firsttime. This requires an internet connection. 5. Controls Use the joystick to pan ortilt the mobile phone. Position the mobile phonedirectly by hand. Press once to start/stop recording or take a photo (depending the settings in the DJI GO app). Tap once to switch the follow mode. Tap twice to center the mobile phone. Tap three times to switch between the mobile phone’s front and rear cameras. Specifications Gimbal Name: OSMO MOBILE 2 Model: OM170 Dimensions: 295mm×113mm×72mm(folded) Weight: 410g Consumption:1.2W Angular Vibration Range:±0.03° Controllable RangePan: ±160°;Roll: ±25°;Tilt: ±160° Mechanical RangePan:±170°;Roll:-90°to +70°; Tilt:±170° Max Controllable Speed:120°/s Mobile Phone Width Range:58.6 mm-85 mm Wireless Mode Bluetooth Low Energy:4.0 Intelligent Battery Mode: l2ICR19/66 Type: 18650 LiPo Capacity: 2600mAh Energy: 18Wh Voltage: 3.6V Charging Temperature: 5℃to 40℃ Operating Temperature: 0℃to 45℃ Compliance Information FCC Compliance Notice This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. RF Exposure Information This equipment complies with FCC radiation exposurelimits set forth for an uncontrolled environment. This transmitter must not be co-located or operating inconjunction with any other antenna or transmitter. ISEDC RSS Warning This device complies with licence-exempt RSS standard (s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. ISEDC Radiation Exposure Statement: This equipment complies with ISEDC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Cet appareil est confforme aux lim mitesd'exposittion de rayon nnement RF ISEDC établiespou ur un environ nnement non conttrôlé. Cetéémetteur ne doit d pas être co‐implanté oufonctionne er en conjoncction avec tou ute autreante enne ou transmetteur r. KCC Warning Message “해당무선설비는운용중전파혼신가능성이있으므로인명안전과관련된서비스 는할수없습니다.” “해당무선설비는운용중전파혼신가능성이있음” EU Compliance Statement SZ DJI Osmo Technology Co.,Ltd. hereby declares that this device is in compliance with the essential requirements and other relevant provisions of the Directive 2014/53/EU. A copy of the EU Declaration of Conformity is available online atwww.dji.com/euro-compliance EU contact address: DJI GmbH, Industriestrasse. 12, 97618, Niederlauer, Germany Declaración de cumplimiento UE SZ DJI Osmo Technology Co.,Ltd. por la presente declara que este dispositivo cumple los requisitos básicos y el resto de provisiones relevantes de la Directiva 2014/53/EU. Hay disponible online una copia de la Declaración de conformidad UE enwww.dji.com/euro-compliance Dirección de contacto de la UE: DJI GmbH, Industriestrasse. 12, 97618, Niederlauer, Germany EU-verklaring van overeenstemming SZ DJI Osmo Technology Co.,Ltd. verklaart hierbij dat dit apparaat voldoet aan de essentiële vereisten en andere relevante bepalingen van Richtlijn 2014/53/EU. De EU-verklaring van overeenstemming is online beschikbaar op www.dji.com/euro-compliance Contactadres EU: DJI GmbH, Industriestrasse. 12, 97618, Niederlauer, Germany Declaração de conformidade da UE SZ DJI Osmo Technology Co.,Ltd. declara, através deste documento, que este dispositivo está em conformidade com os requisitos essenciais e outras disposições relevantes da Diretiva 2014/53/EU. Existe uma cópia da Declaração de conformidade da UE disponível online emwww.dji.com/euro-compliance Endereço de contacto na UE: DJI GmbH, Industriestrasse. 12, 97618, Niederlauer, Germany Dichiarazione di conform mità UE SZ DJI Osmo Technology Co.,Ltd. dichiara che c il pressente dispossitivo è confforme ai reqquisiti essen nziali e alle altre dispossizioni rilev vanti dellla direttiva 2014/53/EU U. Unaa copia dellaa dichiaraziione di confformità UE è disponibille online alll'indirizzo Webbwww.dji.ccom/euro-coompliance Indiirizzo di conntatto UE: DJI GmbH, Inddustriestrassse. 12, 976118, Niederlaauer, Germaany Dééclaration de d conform mité UE : Paar la présennte, SZ DJI Osmo Technology Co.,Ltd. déclaree que cet apppareil est coonforme aux prrincipales exxigences et autres clausses pertinenntes de la dirrective euroopéenne 2014/53/EU. Unee copie de laa déclaration de conforrmité UE esst disponiblee sur le sitew www.dji.coom/euro-com mpliance Adrresse de conntact pour l'U UE : DJI GmbH, Inddustriestrassse. 12, 976118, Niederlaauer, Germaany EU--Compliance: Hiermitt erklärt SZ DJI Osmo Technology Co.,Ltd. , dass diesess Gerrät den weseentlichen Annforderungeen und andeeren einschllägigen Besstimmungen n der EU--Richtlinie 2014/53/EU U entsprichtt. Einee Kopie derr EU-Konfoormitätserkläärung findeen Sie onlinee auf www w.dji.com/eeuro-compliiance. Konntaktadressee innerhalb der EU: DJI GmbH, Inddustriestrassse. 12, 976118, Niederlaauer, Germaany CAU UTION: RIISK OF EXPLOSION IF BATTER RY IS REPLACED BY Y AN OF USED BATTERI IES IN NCORRECT T TYPE. DIISPOSE AC CCORDING G TO THE INSTRUCT TIONS Envvironmentally friendly disposal Oldd electrical appliances m not be disposed off together with must w the residual waste, but haave to be dissposed of seeparately. Th he disposal at the comm munal collecting poiint via privaate persons is i for free. The T owner oof old appliances is responsible e to bring the appliancees to these coollecting po oints or to similar collection pooints. With this little peersonal effoort, you valuuable raw materials andd the treatm ment of toxicc contribute to recycle subbstances. Thaailand Warrning messaage เครือ ่ งโทรคมนาคมและอุปกรณนีม ้ ค ี วามสอดคลองตามขอกําหนดของกทช. Mexico Warning message “La operación de este equipo está sujeta a las siguientes dos condiciones: (1) es posible que este equipo o dispositivo no cause interferencia perjudicial y (2) este equipo o dispositivo debe aceptar cualquier interferencia, incluyendo la que pueda causar su operación no deseada.” Brazil Warning message Este equipamento opera em caráter secundário, isto é, não tem direito a proteção contra interferência prejudicial, mesmo de estações do mesmo tipo, e não pode causar interferência a sistemas operando em caráter primário “해당 무선설비는 운용 중 전파혼신 가능성이 있음” 인증받은자의 상호 : SZ DJI Osmo Technology Co.,Ltd. 제품명 / 모델명 : 특정소출력무선기기(무선데이터통신시스템용무선기기 ) /OM170 제조자 및 제조국가 : SZ DJI Osmo Technology Co.,Ltd./China 제조년월 : 2017 .03 인증번호 : MSIP-CRM-dji-OM170 해당 무선설비는 전파혼신 가능 성이 있으므로 인명안전과 관련된 서비스는 할 수 없음
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : No Author : DG06139 Create Date : 2017:11:28 19:47:26+08:00 Modify Date : 2017:12:11 14:54:06-08:00 XMP Toolkit : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26 Creator Tool : PScript5.dll Version 5.2.2 Metadata Date : 2017:12:11 14:54:06-08:00 Producer : Acrobat Distiller 9.0.0 (Windows) Format : application/pdf Title : Microsoft Word - Osmo Mobile 2 Quick Start Guide Creator : DG06139 Document ID : uuid:ee838cad-a241-461e-b527-efa0a2ec4bb4 Instance ID : uuid:6302db0e-8058-4913-b7a4-b74741e866ab Page Count : 10EXIF Metadata provided by EXIF.tools