Safety Technology 34080 Transmitter for use in a wireless alert system User Manual
Safety Technology International, Inc. Transmitter for use in a wireless alert system
Contents
- 1. User Manual
- 2. User Manual Rev
User Manual
Rhein Tech Laboratories, Inc. 360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com Appendix L: Client: STI Model: STI-34080 Standards: FCC 15.231/IC RSS-210 ID’s: TXL34080/6335A-34080 Report #: 2013282 Manual Please refer to the following pages. 26 of 29 Euro Stopper® STI-15000 Series Alarm Current: 3V Battery 12V 24V - Standby 10µA 500µA 550µA - Low 40mA 38mA 22mA - High 105mA 125mA 95mA The Euro Stopper is a sleek protective cover that offers protection against tampering, vandalism and damage from accidental activation. Specifications • Input power 3V Lithium CR123A, 12-24 VDC - remote power • Flammability: UL94 V-2 • Temperature range: · Polycarbonate Rated: -40° to 121°C (-40° to 250°F) · Electronics Operating Range: -10° to 49°C (14 to 120° F) · Note: below -10°C a remote power source is recommended MOUNTING COLUMNS Description REMOTE INPUT POWER 12-24VDC COMMON NC: NORMALLY CLOSED NO: NORMALLY OPEN 1M (3 Ft) 72 dB 96 dB 3M (10 Ft) 64 dB 88 dB Form “C” Dry Contact Relay - 30VDC, 1A - 125VAC, 0.5A - 60VDC, 0.3A 4. The 32mm (1.25”) and 50mm (2”) surface spacer provides cable entry facilities for conduit, cable and trunking. 5. For surface installations, use the windows attached to the spacer to fill in any unused cable/conduit entry points. TEXT HERE WHEN USING ANCHORS, DRILL 1/4 in. (7mm) DIA. HOLES 1 1/4 in. (31.75mm) DEEP IF USING SCREWS ONLY, DRILL 9/64 in. (3.5mm) DIA. HOLES 1 1/4 in. (31.75mm) DEEP WINDOW FOR CONDUIT Fig. 2 Wire RED BLACK BLUE GREEN YELLOW Volume Distance Low High 152mm (6 in.) Circuit Board Operations 86mm (3.4 in.) WINDOW FOR SPACER (2) PROVIDED Fig. 3 EURO STOPPER ASSEMBLY ANCHORS (4) PROVIDED 32mm SPACER SCREWS (4) PROVIDED Fig. 1 #2 x .25 in. SMS (2) PROVIDED #4 x .312 in. HI-LOW SCREW (2) PROVIDED M272 HORNSHELL Mounting Instructions 1. 2. 3. Position the Euro Stopper® over the device to be protected, open the front cover of the Euro Stopper® and mark the position for the four (4) mounting screws. Drill holes and attach the Euro Stopper® to the wall using the screws provided. See Fig. 1 for drill sizes. If a surface spacer is included, ensure the isolated (inner) mounting columns are at the top (Fig. 2). VOLUME SWITCH HI/OFF/LO 1. On initial installation, activate the battery by removing the battery cover using a small Phillips screwdriver. Remove red tape. 2. To adjust the volume using the Hi/OFF/Lo switch, remove horn case (see Fig. 4 for location). 3. If using 12/24VDC & Relay Cord: a. Remove horn case or keep off after adjusting volume. b. Remove PCB by removing the two (2) screws as shown in Fig. 5. Lift PCB as far as the wires allow. c. Drill a 5mm hole (3/16”) at the witness point shown on Fig. 5. d. Then insert the wire harness cord into the socket as shown in Fig. 5. e. Leaving a small amount of slack, push the harness into the drilled outlet hole. f. Secure PCB into place and reattach horn case with two (2) provided screws. g. CAUTION: The relay will not operate with the service pin in place. M276 HORN CASE 34080 PCB SOUNDER SERVICE PIN (1) PROVIDED Fig. 4 Note: The spacer is not reversible; arrows are marked upwards on the removable plastic windows for your convenience (Fig. 2). STI (Europe) - Unit 49G Pipers Road, Park Farm Ind. Estate, Redditch, Worcs. UK Tel: +44 (0) 1527 520999 - Fax: +44 (0) 1527 501999 info@sti-europe.com - www.sti-europe.com STI (Europe) - Spain C/La Union 25, Altea, Alicante, Espana Telefono/Fax: +34 966 880785 - Movil: +34 664 828977 educardo@sti-europe.com - www.sti-europe.es STI, Inc. - 2306 Airport Rd., Waterford, Michigan 48237, USA Tel: 248-673-9898 - Fax: 248-673-1246 info@sti-usa.com - www.sti-usa.com 12/2013 A 37mm OPTIONAL 5 PIN 32mm (1.45 in.) CONNECTOR (1.25 in.) WIRE HARNESS 94mm 12/24 VDC (3.70 in.) 114mm (4.50 in.) #2 x .25 SMS (2) PROVIDED 34080 PCB SOUNDER SERVICE PIN Flush Mount M276 HORN CASE 94mm (3.70 in.) 115mm (4.53 in.) 185mm (7.30 in.) 135mm (5.30 in.) 104mm SERVICE PIN (4.11 (1) in.) PROVIDED SIDE VIEW CR123A BATTERY 3. 4. 2. 37mm 32mm (1.45 in.) is(1.25 capable of transmitting in.) in.) The(1.25 supervised wireless sounder version a 433MHz alert to any STI Receiver (range up to 500 ft.) 86mm 94mm (3.39 (3.70 Euro in.) When lifting the cover, the wireless Stopper® will send an alert to in.) an STI receiver. For 81mm 114mm (3.2 in.) enrolling this device, refer to STI receiver installation instructions. (4.50 in.) 76mm On closing the cover, the wireless Euro Stopper® will send (3 in.)a restore signal to an STI receiver. 94mm 50mm CAUTION: This device will transmit an alert even (1.97 in.) with the service pin in place. (3.70 in.) 115mm (4.53 in.) 94mm (3.70 in.) 116mm The Euro Stopper® sounder will emit an audible beep when the battery becomes low. 94mm (14.56 in.) Lift cover and insert the service pin. (3.70 in.) 116mm Using a small Phillips screwdriver, remove the battery cover. (14.56 in.) Replace 3V CR123A Lithium battery, taking care to observe the polarity as marked. Reassemble the battery cover and screws, then remove the service pin to arm. (5.30 in.) 1.4mm (4.11 in.) 185mm (7.30 in.) 135mm (5.30 in.) 81mm (3.2 in.) 86mm (3.39 in.) Rinse with warm water mild detergent. Concentrated solutions and those including 68mm to remove dust and dirt. Wash with soap or 76mm 68mm (3 in.) (2.68 in.) strong acids, ethers, amines, aromatic 63mm to) (but not limited alkalis, hydrocarbons and alcohols can cause considerable harm to 50mm in.) 63mm (2.68 (2.48 in.) 58mm this product. Rinse once more then dry with58mm a soft (2.48 clothin.) or (1.97 chamois. DO NOT use sharp objects that may scratch the surface. in.) (2.30 in.) 32mm Exercise caution86mm when using water inside enclosure and ensure the unit is completely dry inside before reassembling. (2.30 in.) 32mm the 94mm (1.26 in.) (3.39 in.) (1.26 in.) (3.70 in.) 116mm (14.56 in.) 94mm Three 76mm(3) year guarantee against breakage of polycarbonate (3.70 in.) (3 in.) 115mm 50mm Warranty form at www.sti-usa.com/wc14 (4.53 in.) (1.97 in.) 81mm Warranty (3.2 in.) in normal use (one (1) year on electronic components). IMPORTANT NOTICE This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement. Contains FCC ID: TXL34080 IC: 6335A-34080 Model: STI-34080 135mm (5.30 in.) STI (Europe) - Unit 49G Pipers Road, Park Farm Ind. Estate, Redditch, Worcs. UK Tel: +44 (0) 1527 520999 - Fax: +44 (0) 1527 501999 info@sti-europe.com - www.sti-europe.com 135mm (5.30 in.) 1.4mm (4.11 in.) Caring for Polycarbonate There are two (2) locking tabs, one (1) on each side of the frame. Choose which side the break seal is to be located, close the cover and carefully drill a 3mm (.118”) diameter hole 185mm at the witness point. 185mm (7.30 in.) Once the device is ready to be protected, remove the service pin (if applicable), close the (7.30 in.) D lock the break seal in place. cover and 135mm 1.4mm (4.11 in.) (4 Fig. 7 Optional Break Seals 1. 135mm 1.4mm (5.30 in.) (4.11 in.) Replacing the Battery 1. 2. 3. 4.C 5. 104mm (4.11 in.) 86mm (3.39 in.) 185mm (7.30 in.) Fig. 6 37mm 2. 94mm 116mm (3.70 in.) (14.56 in.) 81mm 68mm (3.2 in.) 76mm(2.68 in.) 63mm in.) (2.48(3in.) 58mm 50mm in.) in.) 32mm (2.30 (1.97 (1.26 in.) 94mm (3.70 in.) 185mm (7.30 in.) 135mm (5.30 D in.) 104mm (4.11 in.) 135mm (5.30 in.) 115mm (4.53 in.) 185mm (7.30 in.) 185mm (7.30 in.) Optional Wireless 32mm (1.45 in.)Transmitter Version .) 1.4mm (4.11 in.) #2 x .25 in. SMS 1. M277 BATTERY COVER Surface Mount 50mm 135mm (5.30 in.) 185mm (7.30 in.) 104mm (4.11 in.) 94mm (3.70 in.) Fig. 5 94mm in.) Mount (3.70 32mm 114mm (4.50 in.) 68mm 63mm (2.68 in.) 58mm (2.48 in.) 32mm (2.30 in.) (1.26 in.) 37mm 32mm (1.45 in.) (1.25 in.) END VIEW 114mm (4.50 in.) 94mm (3.70 in.) Surface DRILL 3/16 in. (5mm) HOLE THRU #4 x .312 HI-LOW SCREW (2) PROVIDED 37mm 32mm (1.45 in.) (1.25 in.) DIMENSIONAL DRAWINGS STI (Europe) - Spain C/La Union 25, Altea, Alicante, Espana Telefono/Fax: +34 966 880785 - Movil: +34 664 828977 educardo@sti-europe.com - www.sti-europe.es STI, Inc. - 2306 Airport Rd., Waterford, Michigan 48237, USA Tel: 248-673-9898 - Fax: 248-673-1246 info@sti-usa.com - www.sti-usa.com 12/2013
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : Yes Author : Rick McMurray Create Date : 2013:12:31 08:25:46-07:00 Modify Date : 2013:12:31 08:26:42-07:00 Has XFA : No XMP Toolkit : Adobe XMP Core 5.4-c005 78.147326, 2012/08/23-13:03:03 Metadata Date : 2013:12:31 08:26:42-07:00 Creator Tool : Microsoft® Word 2010 Format : application/pdf Creator : Rick McMurray Document ID : uuid:98b86191-ac07-4421-98cb-a1bcf78e47fa Instance ID : uuid:3464986e-2177-4708-bfa2-96c83f5ffb62 Producer : Microsoft® Word 2010 Page Count : 3EXIF Metadata provided by EXIF.tools