Salto Systems S L ABXW XS4 serie Access Control Electronic Lock BLE capable User Manual User Guide Note

Salto Systems S.L XS4 serie Access Control Electronic Lock BLE capable User Guide Note

Contents

User Guide Note

Download: Salto Systems S L ABXW XS4 serie Access Control Electronic Lock BLE capable User Manual User Guide Note
Mirror Download [FCC.gov]Salto Systems S L ABXW XS4 serie Access Control Electronic Lock BLE capable User Manual User Guide Note
Document ID2958882
Application ID9DGNDLzwRkV21E0GjjeBeg==
Document DescriptionUser Guide Note
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize4.04kB (50548 bits)
Date Submitted2016-04-14 00:00:00
Date Available2016-04-15 00:00:00
Creation Date2015-12-15 14:16:54
Producing SoftwarePDFCreator 2.1.1.0
Document Lastmod2015-12-15 14:16:54
Document TitleUser Guide Note
Document CreatorPDFCreator 2.1.1.0
Document Author: j.gutierrez

FCC Compliance Statements
(FCCID: UKCAE9, UKCAE9W, UKCL90, UKCG90, UKCRPOE, UKCNRF, UKCA9XX, UKCA9XW,
UKCCLAYIQ, UKCABXW, UKCABXX, UKCWRDB)
This device complies with Part 15 of the FCC Rules.Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. Changes or
modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
•
•
•
•
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Canadian Compliance Statement
(IC: 10088A-AE9, 10088A-AE9W, 10088A-L90, 10088A-G90, 10088A-RPOE, 10088A-NRF, 10088AA9XX, 10088A-A9XW, 10088A-CLAYIQ, 10088A-ABXW, 10088A-ABXX, 10088A-WRDB)
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes: (1) l’appareil ne doit pas
produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
Distance between 10088A-CLAYIQ and human body must be higher than 20cm. Distance entre le
10088A-CLAYIQ et le corps humain doit être supérieure à 20 cm.
EU Compliance Statement
(Products: All Salto Systems S.L. products with RFID/Wireless capability)
EN
Hereby, Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun– Spain), declares
that this access
control equipment is in compliance with the essential requirements and
other relevant provisions of Directive 1999/5/EC
(R&TEE). You will be able to find a copy of the original declaration of conformity at the
following Internet address:
http://www.saltosystems.com/certificate
ES
Por medio de la presente Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180
Oiartzun– Spain) declara que
este equipo de control de accesos cumple con los requisitos
esenciales y cualesquiera otras disposiciones aplicables
o exigibles de la Directiva 1999/5/CE
(R&TEE). Podrá encontrar una copia de la declaración de conformidad original en
la
siguiente dirección de internet:
http://www.saltosystems.com/certificate
FR
Par la présente Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun– Spain)
déclare que l’appareil
équipement pour le con trôle d’accès est conforme aux exigences essentielles et aux autres
dispositions pertinentes
de la directive 1999/5/CE (R&TEE). Vous pouvez télécharger une
copie de la déclaration de conformité originale à travers
l’adresse suivante:
http://www.saltosystems.com/certificate
DE
Hiermit erklärt Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun– Spain),
dass sich das Gerät
Zutrittskontrollgeräte in Übereinstimmung mit den grundlegenden
Anforderungen und den übrigen einschlägigen
Bestimmungen der Richtlinie 1999/5/EG
(R&TEE) befindet. Eine Kopie der originalen Konformitätserklärung finden Sie auf
der
folgenden Internetseite:
http://www.saltosystems.com/certificate
NL
Hierbij verklaart Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun–
Spain)dat het toestel
toegangscontroleapparatuur in overeenstemming is met de
essentiële eisen en de andere relevante bepalingen
van richtlijn 1999/5/EG
(R&TEE). u kunt een kopie van de originele verklaring van overeenstemming vinden op het
volgende internetadres:
http://www.saltosystems.com/certificate
EU Compliance Statement
(Products: All Salto Systems S.L. products without RFID/Wireless capability)
EN
Hereby, Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun– Spain), declares
that this access
control equipment is in compliance with the essential requirements and
other relevant provisions of Directive 2004/108/
EC (EMC) and Directive 2006/95/EC
(Electrical Safety). You will be able to find a copy of the original declaration of
conformity at the following Internet address:
http://www.saltosystems.com/certificate
ES
Por medio de la presente Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180
Oiartzun– Spain) declara que
este equipo de control de accesos cumple con los requisitos
esenciales y cualesquiera otras disposiciones aplicables o
exigibles de la Directiva
2004/108/CE (EMC) y la Directiva 2006/95/CE (Seguridad Eléctrica). Podrá encontrar una copia
de la declaración de conformidad original en la siguiente dirección de internet:
http://www.saltosystems.com/certificate
FR
Par la présente Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun– Spain)
déclare que l’appareil
équipement pour le contrôle d’accès est conforme aux exigences
essentielles et aux autres dispositions pertinentes de
la directive 2004/108/CE,
2006/95/CE. Vous pouvez télécharger une copie de la déclaration de conformité originale à
travers l’adresse suivante:
http://www.saltosystems.com/certificate
DE
Hiermit erklärt Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun– Spain),
dass sich das Gerät
Zutrittskontrollgeräte in Übereinstimmung
mit den grundlegenden
Anforderungen und den übrigen einschlägigen
Bestimmungen der Richtlinie 2004/108/EG,
2006/95/EG befindet. Eine Kopie der originalen Konformitätserklärung finden
Sie auf der
folgenden Internetseite:
http://www.saltosystems.com/certificate
NL
Hierbij verklaart Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun–
Spain)dat het toestel
toegangscontroleapparatuur in overeenstemming is met de
essentiële eisen en de andere relevante bepalingen van
richtlijn 2004/108/EG, 2006/95/EG. u
kunt een kopie van de originele verklaring van overeenstemming vinden op het
volgende
internetadres:
http://www.saltosystems.com/certificate
Electrical Warnings
Caution: Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries
according to the instructions.
Recommended batteries:
•
•
•
•
•
•
•
•
•
•
•
•
Duracell Plus Power AAA (MN2400)
Simply Duracell AAA (MN2400)
Varta High Energy AAA (04903)
Varta Longlife AAA (04103)
Varta Industrial AAA (04003)
Simply Duracell AA (MN1500)
Varta High Energy AA (04906)
Duracell Plus Power AA (MN1500)
Varta Industrial AA (04006)
Varta Longlife AA (04106)
Varta Professional Lithium CR2 (6206)
Duracell Ultra CR2 Lithium (DLCR2)
Mechanical Warnings
In order to confirm the correct operation of this electronic device, Salto recommends using it in
combination with a lock destined for that use (door mass, frequency of use, fire door, etc) and that is
in good operational conditions. The SALTO product should be treated with care during the installation
process to avoid any aggressive contact that may damage the unit. It may be necessary to loosen the
trims mounting during installation. Do not bring the device into contact with oil, paints or acids. Do
not paint the door with the mortise lock or electronic device already mounted on the door. CLEANING
THE ELECTRONIC DEVICE: a damp cloth with mild soapy water can be used. Never use abrasive soaps
or sprays. For best performance, stainless steel should be cleaned regularly.
Legal Warnings
SALTO shall not be liable for any losses, personal damages or claims arising from, or in connection
with the incorrect installation of the cylinders/lockers and/or improper programming that may result
blocked entry and/or exit.
Note that when the door is closed without the lock having been already programmed, the lock will
automatically lock and can only be opened with a Portable Programing Device (PPD). If you have
questions or doubts on this, please contact your authorized SALTO supplier. In accordance with the
SALTO SYSTEMS LIMITED WARRANTY, the warranty does not cover product failures due to repairs,
modifications or product manipulations performed by anyone other than authorized SALTO dealers
or personnel. Likewise, the warranty is also made null and void if the inner electromechanical
structure is in any way manipulated (for instance, loosening the screws) by anyone other than SALTO
personnel.

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : Yes
Create Date                     : 2015:12:15 14:16:54+01:00
Modify Date                     : 2015:12:15 14:16:54+01:00
Author                          : j.gutierrez
Subject                         : 
Page Count                      : 4
Page Layout                     : SinglePage
Page Mode                       : UseNone
XMP Toolkit                     : XMP toolkit 2.9.1-13, framework 1.6
About                           : uuid:9c05095e-a589-11e5-0000-98c3d55ae4b3
Producer                        : PDFCreator 2.1.1.0
Keywords                        : 
Creator Tool                    : PDFCreator 2.1.1.0
Document ID                     : uuid:9c05095e-a589-11e5-0000-98c3d55ae4b3
Format                          : application/pdf
Title                           : User Guide Note
Creator                         : j.gutierrez
Description                     : 
EXIF Metadata provided by EXIF.tools
FCC ID Filing: UKCABXW

Navigation menu