Samson Electronics BPS-8 ACTIVE SPEAKER User Manual

Samson Electronics Inc. ACTIVE SPEAKER

User manual

Model: BPS-8
User Manual
ENGLISH
Safety Precautions
Fitting and installation of this speaker cabinet must be carried out by qualified personnel following
the approved safety standards.
Do not attempt to clean the plastic enclosure with solvents or petrochemical based cleaners.
Do not place objects which are sources of heat on the speaker cabinet such as lighting equipment
or smoke machines.
Do not expose the speaker cabinet to direct rain or stand in water. Liquid getting into the box will
risk a short circuit and will be hazardous.
Do not stack the speaker cabinet in a manner that could cause injury should a cabinet become
dislodge.
Additional precautions forAuto-amplified devices of the series.
Before installation, ensure that the voltage and frequency of power outlet match the power
requirements of the loudspeaker.
Disconnect from main power before to make connections in the loudspeaker.
Make sure that the power-cord is never crimped or damaged by sharp edges. Never let the
power-cord come into contact with other cables. Only handle the power-cord by the plug.
In case to replace the fuse, it must be changed by identical rate and dimensions.
Attention
Before connecting or operating your new loudspeaker, please study the accompanying
instruction manual paying special attention to the operating precautions and wiring procedure.
This symbol on the product or on Its packaging indicates that this product shall not be treated as
household waste. Instead it shall be handed over to the applicable collection point for the recycling of
electrical an electronic equipment By ensuring this product is disposed of correctly, you will
help prevent potential negative consequences for the environment and human health, which could
otherwise be caused by inappropriate waste handling of this product The recycling of materials will
help to conserve natural resources. For more detailed information about recycling of this product,
please contact your local city office, your household waste disposal service or the shop where you
purchased the product.
User Manual Pag. 1
User Manual Pag. 2
Functions
1. USB Player
2. Master volume: it controls all the volume.
3. Power switch
4. USB/TF card input
5. Aux input
6. Treble: to control the tone level of high frequency at range -12dB to +12dB
7. MIC priority button
8. Bass: to control the tone level of low frequency at range -12dB to +12dB
9. MIC volume: it controls the volume of Microphone
10. Adapter charging
11. ECHO controller
12. 6.35 jack for MIC input
13. 12V power supply
14. Led light charging indication
15. Antenna: to strengthen radio signal
User Manual Pag. 3
MODE Exchange between USB / TF / FM / BT
Play/Pause
Last
Next
RECORD Record acoustical signal into TF card
FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modification warning
Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
Information to the user.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between thee quipment and receiver.
-Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
* RF warning:
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.

Navigation menu