Samsung Electronics Co SWCU200 WiMAX USB Modem User Manual Manual FCC SWC U200 v 1 2

Samsung Electronics Co Ltd WiMAX USB Modem Manual FCC SWC U200 v 1 2

Users Manual

User’s Guide MWiMAX USB dongle mWiMAX Connection Manager SWC-U200 Draft 2009.03.02
2/22 Contents 1. INSTALL/UNINSTALL MWIMAX U200 CONNECTION PROGRAM ......................................... 4 1.1. INSTALL MWIMAX U200 CONNECTION PROGRAM ........................................................................... 4 1.1.1. Installation Checkup .......................................................................................................... 7 1.2. UNINSTALL MWIMAX CONNECTION PROGRAM ................................................................................ 8 1.2.1. Uninstall on Start menu ..................................................................................................... 8 1.2.2. Uninstall on [Control Panel] .............................................................................................. 9 2. MWIMAX CONNECTION MANAGER ........................................................................................... 10 2.1. MWIMAX CONNECTION MANAGER OVERVIEW .............................................................................. 10 2.1.1 Product Mix ...................................................................................................................... 10 2.1.2. mWiMAX Connection Manager User Interface .............................................................. 11 2.2. TO USE MWIMAX CONNECTION MANAGER ................................................................................... 11 2.2.1. Run mWiMAX Connection Manager .............................................................................. 11 2.2.1.1 Run on [Start] Menu ...................................................................................................... 11 2.2.1.2. Run on Desktop ............................................................................................................ 12 2.2.2. Screen Configuration ....................................................................................................... 12 2.2.2.1. Main Screen .................................................................................................................. 12 2.2.2.2. Settings Screen ............................................................................................................. 13 2.2.2.3. Tray Screen ................................................................................................................... 14 2.2.3. Connect to mWiMAX ...................................................................................................... 15 2.2.4. Disconnect mWiMAX ..................................................................................................... 17 2.2.5. Show Settings .................................................................................................................. 18 2.2.6. Exit .................................................................................................................................. 18 2.2.7. Use Tray........................................................................................................................... 19 2.2.8. Tray Icon Description ...................................................................................................... 19 3. HEALTH AND SAFETY INFORMATION ....................................................................................... 20
3/22 Revision History Version Date Author Description 1.0 2007.12.28 Lee Myung-Hwan, Park Sea-hoon, Initial documentation (SWC-U100) 1.1 2008.09.29 Il Kwon Kim Revised into SWC-U200 1.2 2009.03.02 Il Kwon Kim Added SAR waring phrase.
4/22 1. Install/Uninstall mWiMAX U200 Connection Program 1.1. Install mWiMAX U200 Connection Program * Before installing SWC-U200 connection Program, insert USB dongle into USB port on your laptop. If new hardware detection pop-up window is appered, click “Cancel” button. - Click [Next] to start installation. - Please click [Install].
5/22 - mWiMAX PCMCIA device driver and mWiMAX virtual serial port driver are installed first. After this, mWiMAX Connection Manager is installed. * Driver installation process might cause some screen blinks.
6/22 - Click [Finish] to end installation.
7/22 1.1.1. Installation Checkup Select [Start] – [Control Panel] – [System] – [Hardware] – [Device Manager]. When mWiMAX Connection Program is normally installed, Device Manager is shown as the following picture.
8/22 1.2. Uninstall mWiMAX Connection Program 1.2.1. Uninstall on Start menu Click [Start] menu, then select [Program] – [SAMSUNG ELECTRONICS] – [mWiMAX CM Express] Æ [Uninstall mWiMAX CM Express].
9/22 1.2.2. Uninstall on [Control Panel] Select [Start] – [Control Panel]. On [Control Panel] menu, select [Add/Delete Program]. On [Add/Delete Program], select [mWiMAX Connection Manager] and hit [Delete] button on the right, then a message is displayed asking if you want to delete the program. By selecting [Yes], the program is deleted.
10/22 2. mWiMAX Connection Manager 2.1. mWiMAX Connection Manager Overview mWiMAX Connection Manager is Windows OS-based application supporting mWiMAX connection and features mWiMAX system connection and disconnection and other mWiMAX-related functions. mWiMAX systemConnection ConnectionConnectionmWiMAX connection managermWiMAX connection managermWiMAX connection manager 2.1.1 Product Mix - mWiMAX(Mobile WiMAX) USB dongle - Easy Installation Guide
11/22 2.1.2. mWiMAX Connection Manager User Interface OS Microsoft Windows XP, Vista CPU Intel Pentium 1.7 GHz or above recommended Memory 512MB or above recommended 2.2. To Use mWiMAX Connection Manager 2.2.1. Run mWiMAX Connection Manager 2.2.1.1 Run on [Start] Menu Click [Start] menu, then select [Program] Æ [SAMSUNG ELECTRONICS] Æ [mWiMAX CM Express] Æ [mWiMAX CM Express].
12/22 2.2.1.2. Run on Desktop Execute [mWiMAX CM] icon on Desktop. SWC-U200 mWiMAX CM 2.2.2. Screen Configuration 2.2.2.1. Main Screen Main screen appears when mWiMAX Connection Manager is run. - In the upper left is an antenna showing receive sensitivity and to its right is a message box informing connection status. At the right side of the screen there are [Connect], [Close] and [Settings] button for mWiMAX connection.
13/22 2.2.2.2. Settings Screen The following screen is displayed by clicking [Settings] button and it shows - [Configuration]. - [Connection Info]
14/22 - [Network Info] - [About mWiMAX CM]. 2.2.2.3. Tray Screen When you click [Close] or [Minimize] button in the top-right corner on Main Screen, Main screen disappears and the program runs as a Tray icon.
15/22 2.2.3. Connect to mWiMAX On the Main screen, press [Connect] button. Connecting to mWiMAX’ message is displayed as in the following picture. * For maximum performance, please upright antenna from USB dongle. - Connection Success If the connection to mWiMAX succeeds, the following screen is displayed.
16/22 - Connection Failure If the connection to mWiMAX fails, the following screen is displayed.
17/22 2.2.4. Disconnect mWiMAX When you press [Disconnect] button on Main screen, connection is cut off and the status changes to ‘waiting for connection’.
18/22 2.2.5. Show Settings Select [Settings] on Main screen. - Then [Configuration], [Connection Info], [Network Info], [About mWiMAX CM] tabs are appeared same as in Settings Screen on page 15. 2.2.6. Exit Right-click on Tray screen to see a pop-up menu. Select [Exit].
19/22 2.2.7. Use Tray Switch Tray screen to Main screen Right-click on Tray screen to see a pop-up menu. Select [mWiMAX View]. 2.2.8. Tray Icon Description Signal strength is low Standby Signal strength is weak Signal strength is good Signal strength is very good Signal strength is best Signal strength is low Online Signal strength is weak Signal strength is good Signal strength is very good Signal strength is best No service area
20/22 3. Health and safety information Exposure to Radio Frequency (RF) Signals Certification Information (SAR) Your SWC-U200 dongle is a radio transmitter and receiver. It is designed and manufactured not to exceed the exposure limits for radio frequency (RF) energy set by the Federal Communications Commission (FCC) of the U.S. government. These FCC exposure limits are derived from the recommendations of two expert organizations, the National Counsel on Radiation Protection and Measurement (NCRP) and the Institute of Electrical and Electronics Engineers (IEEE). In both cases, the recommendations were developed by scientific and engineering experts drawn from industry, government, and academia after extensive reviews of the scientific literature related to the biological effects of RF energy. The exposure limit set by the FCC for wireless USB dongles employs a unit of measurement known as the Specific Absorption Rate (SAR). The SAR is a measure of the rate of absorption of RF energy by the human body expressed in units of watts per kilogram (W/ kg). The FCC requires wireless USB dongles to comply with a safety limit of 1.6 watts per kilogram (1.6 W/kg). The FCC exposure limit incorporates a substantial margin of safety to give additional protection to the public and to account for any variations in measurements. SAR tests are conducted using standard operating positions accepted by the FCC with the wireless USB dongle transmitting at its highest certified power level in all tested frequency bands. Although the SAR is determined at the highest certified power level, the actual SAR level of the wireless USB dongle while operating can be well below the maximum value. This is because the wireless USB dongle is designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you are to a wireless base station antenna, the lower the power output. Before a new model wireless USB dongle is available for sale to the public, it must be tested and certified to the FCC that it does not exceed the exposure limit established by the FCC. Tests for each model wireless USB dongle are performed in positions and locations (e.g. worn on the body) as required by the FCC. The highest SAR values for this model wireless USB dongle as reported to the FCC are:
21/22 SAR(Body-worn): 1.18 W/Kg. For body worn operation, the SWC-U200 USB dongle must be 0.5 cm or more from users during operation, to satisfy FCC RF exposure requirements and has been tested and meets the FCC RF exposure limits in laptop configurations with all sides (bottom, top, and sides). Non-compliance with the above restrictions may result in violation of FCC RF exposure guidelines. SAR information on this and other model wireless USB dongles can be viewed on-line at www.fcc.gov/oet/fccid. This site uses the wireless USB dongle FCC ID number, A3LSWCU200. Once you have the FCC ID number for a particular wireless USB dongle, follow the instructions on the website and it should provide values for typical or maximum SAR for a particular wireless USB dongle. Additional product specific SAR information can also be obtained at www.fcc.gov/cgb/ sar. Restricting Children's access to your Wireless USB dongle Your wireless USB dongle is not a toy. Children should not be allowed to play with it because they could hurt themselves and others, damage the wireless USB dongle or make calls that increase your wireless USB dongle bill. Cautions Changes or modifications made in the radio USB dongle, not expressly approved by Samsung, will void the user’s authority to operate the equipment. Only use approved batteries, antennas and chargers. The use of any unauthorized accessories may be dangerous and void the wireless USB dongle warranty if said accessories cause damage or a defect to the wireless USB dongle. Although your wireless USB dongle is quite sturdy, it is a complex piece of equipment and can be broken. Avoid dropping, hitting, bending or sitting on it. Other Important Safety Information Only qualified personnel should service the wireless USB dongle or install the wireless USB dongle in a vehicle. Faulty installation or service may be dangerous and may invalidate any warranty applicable to the device. Check regularly that all wireless USB dongle equipment in your vehicle is mounted and operating properly. Do not store or carry flammable liquids, gases or explosive materials in the same compartment as the wireless USB dongle, its parts or accessories. For vehicles equipped with an air bag, remember that an air bag inflates with great
22/22 force. Do not place objects, including both installed and portable wireless equipment in the area over the air bag or in the air bag deployment area. If wireless equipment is improperly installed and the air bag inflates, serious injury could result. The use of wireless USB dongle in aircraft is illegal and may be dangerous to the aircraft's operation. Failure to observe these instructions may lead to the suspension or denial of USB dongle services to the offender, or legal action, or both.

Navigation menu