Sato SMP-WL Wireless LAN Board User Manual Installation Manual MB200i

Sato Corporation Wireless LAN Board Installation Manual MB200i

Contents

Installation Manual_MB200i

MB200i INSTALLATION MANUAL(WLAN BOARD) July 22, 2011 １ REMOVE CAP AND REMOVE SCREW. CAP SCREW SCREW CAP SCREW
２ REMOVE SCREW AND REMOVE TOP COVER AND FRONT COVER. TOP COVER FRONT COVER
３ REMOVE SCREW AND REMOVE SIDE COVER. SCREW SCREW ※PULL OUT SCREW ABOUT 1cm. SIDE COVER ※ PULL OUT SCREW ABOUT 1cm. ROTATE SIDE COVER AS SHOWN FIGURE ABOVE UNTIL INSIDE CAN BE SEEN.
４ SET WLAN BOARD AND TIGHTEN THE SCREW. FINALLY CONNECT FFC CABLE TO CONNECTOR AND LOCK THE CONNECTOR. SCREW FFC CABLE
５ FOLLOW PROCEDURE 3→2→1 IN ORDER TO INSTALL BACK THE PRINTER. ※(CASE PARTS ARE EASY TO COME OFF). ※BEWARE AND MAKE SURE THE CABLE DO NOT STUCK WHEN PUTTING BACK SIDE COVER. SPRING GEAR End Product Labeling The final end product must be labeled in a visible area with the following "Contains FCC ID：MMFSMP-WL".

Navigation menu