Sato SMP-WL Wireless LAN Board User Manual Installation Manual MB200i
Sato Corporation Wireless LAN Board Installation Manual MB200i
Sato >
Contents
- 1. Installation Manual_MB200i
- 2. User Manual 1
- 3. User Manual 2
Installation Manual_MB200i
MB200i INSTALLATION MANUAL(WLAN BOARD) July 22, 2011
１ REMOVE CAP AND REMOVE SCREW.
CAP
SCREW
SCREW
CAP
SCREW
２ REMOVE SCREW AND REMOVE TOP COVER AND FRONT COVER.
TOP COVER
FRONT COVER
３ REMOVE SCREW AND REMOVE SIDE COVER.
SCREW
SCREW
※PULL OUT SCREW ABOUT 1cm.
SIDE COVER
※ PULL OUT SCREW ABOUT 1cm.
ROTATE SIDE COVER AS SHOWN FIGURE ABOVE
UNTIL INSIDE CAN BE SEEN.
４ SET WLAN BOARD AND TIGHTEN THE SCREW.
FINALLY CONNECT FFC CABLE TO CONNECTOR AND LOCK THE CONNECTOR.
SCREW FFC CABLE
５ FOLLOW PROCEDURE 3→2→1 IN ORDER TO INSTALL BACK THE PRINTER.
※(CASE PARTS ARE EASY TO COME OFF).
※
BEWARE AND MAKE SURE THE CABLE DO NOT
STUCK WHEN PUTTING BACK SIDE COVER.
SPRING GEAR
End Product Labeling
The final end product must be labeled in a visible area with the
following "Contains FCC ID：MMFSMP-WL".