Schneider Electric Systems Canada EB450-XXF01 Remote Radio Data Modem Base/Repeater User Manual Trio Base Station EB450
Trio Datacom Pty Ltd (a wholly owned company of Schneider Electric) Remote Radio Data Modem Base/Repeater Trio Base Station EB450
Contents
Base Station EB
Digital Data Base Station - EB450 E Series Radio Diagnostics (Optional) Frequency Range: 380-520 MHz (various sub-frequency bands available) Network wide operation from any remote terminal. Frequency Splits: Various Tx/Rx frequency splits - programmable Non intrusive protocol - runs simultaneously with the application. Channel Selection: Dual synthesizer, 6.25 kHz channel step Over-the-air re-configuration of user parameters. Channel Spacing: 12.5 or 25 kHz Programmable exception reporting of alarms. Frequency Stability: ±1ppm (-30 to 60°C ambient, opt. -30 to 70°C) Higher frequency stability options are available (with external GPS reference) Aging: <= 1ppm/annum Full Duplex: Full duplex (optional internal or external duplexer available for single antenna operation) Configuration: All configuration via Windows based software Transmitter Tx Power: 5W (+37 dBm) ±1 dB software adjustable with overtemperature protection. 100% Duty Cycle. Modulation: Narrow band digital filtered binary GMSK Occupied Bandwidth: Designed to FCC, ETSI, ACA requirements Tx Keyup Time: < 1 mSecond Timeout Timer: Programmable 0-255 seconds responsibility of the buyer to confirm these regulatory conditions. Performance data indicates typical values related to the Antenna: 2 x N female bulkhead (separate Tx and Rx ports) 1 x N female bulkhead (with optional internal duplexer) Weight: 5 kg (excluding optional duplexer) LED Display: Multimode Indicators for Pwr, Tx, Rx, Sync, TxD and RxD data LEDs (for both port A and B) Receiver Data Serial Port #2: RS232, DCE, 30038,400 bps asynchronous AFC Tracking: Digital receiver frequency tracking versions in different countries. It is the Receive Current: < 150 mA Data Serial Port #1: RS232, DCE, 60076,800 bps asynchronous Spurious Response: Better than 80 dB the performance and suitability of individual System Port: RJ45 (front and rear) for diagnostics, configuration and programming PTT Control: Auto (on Data) / RTS line (Port A or B) / System Port (Override) Intermodulation: Better than 75 dB Mute: Programmable digital mute General Transmit Current: 1.3 A nominal @ 1 W 2.5 A nominal @ 5 W Power: 2 pin locking, mating connector supplied System Port: RS232, 19,200 bps asynchronous Flow Control: Selectable hardware/software/3 wire interface RF Channel Data Rate: 4800/9600/19,200 bps Full duplex E Series Firmware: Field upgradeable Flash memory Connections User Data Ports: 2 x DB9 female ports wired as DCE (modem) Digital Data Base Station - EB450 Data Turnaround Time: <10mS Power Supply: 13.8 Vdc nominal (11-16 Vdc) Modem Selectivity: Better than 80 dB Multistream™: Trio DataCom's unique simultaneous delivery of multiple data streams (protocols) In-built Error Rate testing capabilities. Tx Spurious: <= -37 dBm Sensitivity: -118 dBm for 12 dB SINAD Local regulatory conditions may determine Storage of data error and channel occupancy statistics. Collision Avoidance: Trio DataCom’s unique supervisory channel C/DSMA collision avoidance system Dimensions: 19” 2 RU rack mount 485 x 90 x 390 mm Options DUPLX450Bx Internal / External Duplexers, Band Reject and Band Pass EDOVM Digital Order Wire Voice Module TVIEW+™ Configuration, Network Management and Diagnostic GUI Software DIAGS/E Network Management and Remote Diagnostics Facilities per Radio Modem (E Series) Related Products EH450 Hot Standby Base Station ER450 Remote Data Radio 95MSR 6 and 9 Port Stream Router Multiplexer Data Buffer: 16 kbyte of on-board RAM Bit Error Rate: < 1x10-6 @ -110 dBm (4800 bps) < 1x10-6 @ -108 dBm (9600 bps) < 1x10-6 @ -106 dBm (19,200 bps) Features and Specifications Trio DataCom’s EB450 is an advanced Full Duplex Base / Repeater Station that complements the ER450 remote data radio modem. E Series data radio modems are suitable for the most complex and demanding digital high speed Point-to-Point and Point-to-Multipoint (Multiple Address Radio) SCADA and telemetry applications. Base stations and repeaters are key elements in data radio communication systems and are subject to heavy duty cycle operation. The EB450 delivers highly reliable, continuous full duplex operations at maximum (5W) output power. The high performance E Series data radio system products also include the EH450 Hot Standby Base / Repeater station. Features Radio and Modem - Fully integrated radio, modem and data multiplexer - True 19,200 bps over-air data rates - Fast data turnaround - Full Duplex Operation - Broad frequency range with fully synthesized all digital radio design - 5 watt transmitter output with 100% duty cycle up to maximum temperature specification (-30° to +60°C, +70°C option) - Housed in a rugged 19” rack mount enclosure - Insurance against obsolescence with field upgradeable firmware in flash memory - Extensive front panel LED diagnostic display - Internal (compact) or external duplexer options - Digital orderwire option Data Ports - Two independent data ports and separate system port - Compatible with most industry standard data protocols. eg: MODBUS, DNP-3, IEC 870 etc. - Selectable 300 - 76.8 k bps asynchronous RS-232 interface - Multistream™ simultaneous data streams allows for multiple vendor devices/protocols to be transported on the one radio network - Flexible data stream routing providing optimum radio channel efficiency - Internal repeater operation - buffered store and forward operation - Unique integrated C/DSMA collision avoidance technology permits simultaneous polling and spontaneous alarm reporting operation in the same system Network Management and Remote Diagnostic option (In conjunction with TView+™ GUI) - Exceptional network management tools - Over-the-air user configuration - Transparent Operation-simultaneous with user data - Separate isolated alarm inputs and outputs - Network wide operation from any radio terminal Information subject to change without notice. © Copyright 2002 Trio DataCom Pty Ltd. All rights reserved. Issue 05/02 Innovative and sophisticated 41 Aster Avenue, Carrum Downs Victoria, Australia 3201 Phone +613 9775 0505 Fax +613 9775 0606 sales@trio.com.au www.trio.com.au digital communications designs product s and solutions Digital Data Base Station - EB450 E Series Radio Diagnostics (Optional) Frequency Range: 380-520 MHz (various sub-frequency bands available) Network wide operation from any remote terminal. Frequency Splits: Various Tx/Rx frequency splits - programmable Non intrusive protocol - runs simultaneously with the application. Channel Selection: Dual synthesizer, 6.25 kHz channel step Over-the-air re-configuration of user parameters. Channel Spacing: 12.5 or 25 kHz Programmable exception reporting of alarms. Frequency Stability: ±1ppm (-30 to 60°C ambient, opt. -30 to 70°C) Higher frequency stability options are available (with external GPS reference) Aging: <= 1ppm/annum Full Duplex: Full duplex (optional internal or external duplexer available for single antenna operation) Configuration: All configuration via Windows based software Transmitter Tx Power: 5W (+37 dBm) ±1 dB software adjustable with overtemperature protection. 100% Duty Cycle. Modulation: Narrow band digital filtered binary GMSK Occupied Bandwidth: Designed to FCC, ETSI, ACA requirements Tx Keyup Time: < 1 mSecond Timeout Timer: Programmable 0-255 seconds System Port: RJ45 (front and rear) for diagnostics, configuration and programming Receive Current: < 230 mA Antenna: 2 x N female bulkhead (separate Tx and Rx ports) 1 x N female bulkhead (with optional internal duplexer) Weight: 5 kg (excluding optional duplexer) LED Display: Multimode Indicators for Pwr, Tx, Rx, Sync, TxD and RxD data LEDs (for both port A and B) PTT Control: Auto (on Data) / RTS line (Port A or B) / System Port (Override) Data Serial Port #1: RS232, DCE, 60076,800 bps asynchronous Receiver Data Serial Port #2: RS232, DCE, 30038,400 bps asynchronous Intermodulation: Better than 75 dB Spurious Response: Better than 80 dB AFC Tracking: Digital receiver frequency tracking Mute: Programmable digital mute the performance and suitability of individual versions in different countries. It is the responsibility of the buyer to confirm these regulatory conditions. Performance data indicates typical values related to the described unit. General Transmit Current: 1.3 A nominal @ 1 W 2.5 A nominal @ 5 W Power: 2 pin locking, mating connector supplied System Port: RS232, 19,200 bps asynchronous Flow Control: Selectable hardware/software/3 wire interface RF Channel Data Rate: 4800/9600/19,200 bps Full duplex E Series Firmware: Field upgradeable Flash memory Connections User Data Ports: 2 x DB9 female ports wired as DCE (modem) Digital Data Base Station - EB450 Data Turnaround Time: <10mS Power Supply: 13.8 Vdc nominal (11-16 Vdc) Modem Selectivity: Better than 80 dB Multistream™: Trio DataCom's unique simultaneous delivery of multiple data streams (protocols) In-built Error Rate testing capabilities. Tx Spurious: <= -37 dBm Sensitivity: -118 dBm for 12 dB SINAD Local regulatory conditions may determine Storage of data error and channel occupancy statistics. Collision Avoidance: Trio DataCom’s unique supervisory channel C/DSMA collision avoidance system Dimensions: 19” 2 RU rack mount 485 x 90 x 420 mm Options DUPLX450Bx Internal / External Duplexers, Band Reject and Band Pass EDOVM Digital Order Wire Voice Module TVIEW+™ Configuration, Network Management and Diagnostic GUI Software DIAGS/E Network Management and Remote Diagnostics Facilities per Radio Modem (E Series) Related Products EH450 Hot Standby Base Station ER450 Remote Data Radio 95MSR 6 and 9 Port Stream Router Multiplexer Data Buffer: 16 kbyte of on-board RAM Bit Error Rate: < 1x10-6 @ -110 dBm (4800 bps) < 1x10-6 @ -108 dBm (9600 bps) < 1x10-6 @ -106 dBm (19,200 bps) Features and Specifications Trio DataCom’s EB450 is an advanced Full Duplex Base / Repeater Station that complements the ER450 remote data radio modem. E Series data radio modems are suitable for the most complex and demanding digital high speed Point-to-Point and Point-to-Multipoint (Multiple Address Radio) SCADA and telemetry applications. Base stations and repeaters are key elements in data radio communication systems and are subject to heavy duty cycle operation. The EB450 delivers highly reliable, continuous full duplex operations at maximum (5W) output power. The high performance E Series data radio system products also include the EH450 Hot Standby Base / Repeater station. Features Radio and Modem - Fully integrated radio, modem and data multiplexer - True 19,200 bps over-air data rates - Fast data turnaround - Full Duplex Operation - Broad frequency range with fully synthesized all digital radio design - 5 watt transmitter output with 100% duty cycle up to maximum temperature specification (-30° to +60°C, +70°C option) - Housed in a rugged 19” rack mount enclosure - Insurance against obsolescence with field upgradeable firmware in flash memory - Extensive front panel LED diagnostic display - Internal (compact) or external duplexer options - Digital orderwire option Data Ports - Two independent data ports and separate system port - Compatible with most industry standard data protocols. eg: MODBUS, DNP-3, IEC 870 etc. - Selectable 300 - 76.8 k bps asynchronous RS-232 interface - Multistream™ simultaneous data streams allows for multiple vendor devices/protocols to be transported on the one radio network - Flexible data stream routing providing optimum radio channel efficiency - Internal repeater operation - buffered store and forward operation - Unique integrated C/DSMA collision avoidance technology permits simultaneous polling and spontaneous alarm reporting operation in the same system Network Management and Remote Diagnostic option (In conjunction with TView+™ GUI) - Exceptional network management tools - Over-the-air user configuration - Transparent Operation-simultaneous with user data - Separate isolated alarm inputs and outputs - Network wide operation from any radio terminal Information subject to change without notice. © Copyright 2002 Trio DataCom Pty Ltd. All rights reserved. Issue 08/02 Innovative and sophisticated 41 Aster Avenue, Carrum Downs Victoria, Australia 3201 Phone +613 9775 0505 Fax +613 9775 0606 sales@trio.com.au www.trio.com.au digital communications designs product s and solutions
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No Encryption : Standard V1.2 (40-bit) User Access : Print, Copy, Annotate, Fill forms, Extract, Assemble, Print high-res Create Date : 2002:05:22 10:30:10Z Modify Date : 2002:08:21 09:59:44+10:00 Page Count : 2 Creation Date : 2002:05:22 10:30:10Z Producer : Acrobat Distiller 4.05 for Macintosh Mod Date : 2002:08:21 09:59:44+10:00 Metadata Date : 2002:08:21 09:59:44+10:00 Title : Trio Base Station - EB450EXIF Metadata provided by EXIF.tools