Scientific Toys 4795-24B2 R/C Car User Manual OI 6126 99100F Mini Flip eng only ai

Scientific Toys Ltd R/C Car OI 6126 99100F Mini Flip eng only ai

User Manual

CAUTION: BUILT-IN BATTERY SAFETY INFORMATION1. The Mini Flip Buggy includes a non-replaceable battery. Do not open, disassemble or alter the Mini Flip Buggy in any way.2. Adult supervision is required when charging the Mini Flip Buggy.3. Charge battery in an isolated area. Keep away from flammable materials.4. Do not expose to direct sunlight.5. Do not recharge the toy if it is hot. Allow it to cool before recharging.6. Do not allow the batteries to get wet.7. Carefully read the insturction guide and charge the batteries correctly.8. Rechargeable batteries are only to be charged under adult supervision.9. Routinely examine for damage to the plug, enclosure and other parts. In the event of any damage, the toy must not be used with a USB port until the damage has been repaired.HOW TO PLAYTO BEGIN1. Turn “ON” the controller.2. Turn “ON” the vehicle.RUNNING FORWARD1. Press both control buttons forward at the same time for forward running. (See Diagram #5)RUNNING REVERSE1. Press both control buttons backward at the same time for reverse running. (See Diagram #6)TURNING1. Press the right button forward while pressing the left button backward at the same time to turn left. (See Diagram #7)2. Press the left button forward while pressing the right button backward at the same time to turn right. (See Diagram #8)STOP OPERATIONTo stop the vehicle, release both control buttons. (See Diagram #9)SIZE: 391 X 241mm PN#65-6126-000-0100BACKWARDFORWARD TURN LEFTOPERATING INSTRUCTIONS:MINI FLIP BUGGYThe Mini Flip Buggy is powered by a built-in non-replaceable rechargeable battery. The includedrechargeable battery is not charged prior to shipmentand must be charged before the first use. INSTALL BATTERIES IN THE CONTROLLER1. Unscrew the battery compartment cover to open. (See Diagram #1) 2. Insert four AAA/LR3 batteries by matching (+) and (–) signs as indicated in the battery compartment. (See Diagram #2) 3. Replace the battery compartment cover, and screw it closed.CHARGING THE MINI FLIP BUGGY1. Make sure the Mini Flip Buggy’s ON/OFF switch is in the OFF position.2. Open the controller's top. Push the button to CHARGE/ON. (See Diagram #3)3. Align the car's metal contact point (on the bottom) with the controller and snap the car in place. (See Diagram #4) 4. The RED light will stay ON to show it is charging.5. Once the light turns from RED to GREEN, the Mini Flip Buggy is fully charged. It takes about 30 minutes.6. Press the RELEASE button on the top of the left hand corner of the controller to release your car from the controller.Caution: After charging the Mini Flip Buggy, take it out from the controller. Overcharging could damage the car and the controller.PERFORMANCE TIPS FOR VEHICLE• For maximum performance, drive vehicle on smooth ground.• Avoid driving on uneven surfaces- this could cause damage to vehicle.• Do not drive car on grass, sand or carpet.• Do not drive car through water.• Be sure to rest your vehicle for at least 30 minutes after every 15 minutes of operation.• Make sure ON/OFF switch on your vehicle is in the “OFF” position when it is not in use.• Do not bend the antenna.• Electrical, CB interference, mobile phones, air conditioning, elevators and steel girders in buildings will affect the operation of your vehicle.• Do not leave the vehicle or transmitter near sources of heat or in direct sunlight for long periods of time.• Remove the batteries from the vehicle and transmitter when they are not in use.O.I. NO. 6126 #AD154542017ATTENTION PARENTS:IT IS RECOMMENDED THAT THIS TOY ANDALL ACCESSORIES BE PERIODICALLYEXAMINED FOR POTENTIAL HAZARDS ANDTHAT ANY POTENTIALLY HAZARDOUS PARTS BE REPAIRED OR REPLACED.MINI FLIP BUGGYDIAGRAM 1DIAGRAM 2 DIAGRAM 3 DIAGRAM 4DIAGRAM 5DIAGRAM 6DIAGRAM 7TURN RIGHTDIAGRAM 8CHARGE / ON / OFFCHARGE / ON / OFFOFF ONSTOPDIAGRAM 94 X AAA BATTERIESBATTERY COVERUNSCREW TO OPEN4NOT INCLUDEDOFF ON

Navigation menu