Scientific Toys 5058-49P R/C VEHICLE User Manual OI 5978 97200 ENG for lab ai

Download:
Mirror Download [FCC.gov]
Document ID	3003158
Application ID	b1nCZa+a/5pqL7RvjYJ3Aw==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	9.93kB (124091 bits)
Date Submitted	2016-05-25 00:00:00
Date Available	2016-05-25 00:00:00
Creation Date	2016-05-19 17:11:11
Producing Software	Acrobat Distiller 6.0.1 for Macintosh
Document Lastmod	2016-05-19 17:11:11
Document Title	OI 5978(97200 ENG)for lab.ai
Document Creator	Illustrator
Document Author:	Scientific

OPERATING INSTRUCTIONS
KEEP PACKAGING AS IT CONTAINS IMPORTANT INFORMATION.
BATTERY INSTALLATION:
BATTERIES:
8 x AA(R6) batteries required
ATTENTION PARENTS
IT IS RECOMMENDED THAT THIS TOY AND ALL ACCESSORIES BE
PERIODICALLY EXAMINED FOR POTENTIAL HAZARDS AND THAT ANY
POTENTIALLY HAZARDOUS PARTS BE REPAIRED OR REPLACED.
CARE
Never drive the vehicle on a wet floor, on sand, grass, carpet, in mud, rain or
snow. These can cause damage to the vehicle.
Do not expose the vehicle to extreme temperatures.
To protect the vehicle’s wheel mechanisms from lint and hair, do not drive it
on carpet.
Occasionally wipe the vehicle with a damp cloth remove any dirt/dust
from wheels.
Do not use harsh chemicals to clean the vehicle.
Modifying or tampering with the vehicle or the transmitter’s internal components
can cause a malfunction.
HELPFUL HINTS
Running the vehicle continuously for long periods of time generates high levels
of heat.
Heat causes wear and tear on the motor. When the vehicle’s battery pack goes
flat, let the vehicle cool at least 10 minutes before installing a newly charged
battery pack. This helps keep heat levels down. If the vehicle’s motor runs but
does not respond to the transmitter, move the transmitter closer to the vehicle
and try again.
If a CB radio is used nearby, it might interfere with control of the vehicle. If this
happens, move the vehicle and transmitter away from the CB radio. The vehicle
cannot be operated near devices with transmitters that use the same frequency.
Check the packaging to see which frequency your vehicle uses.
If the vehicle moves slowly, and a recharged battery pack has been installed,
check the wheel mechanisms for lint, thread, hair or dust.
INSERTING BATTERIES
VEHICLE
1. Turn over the vehicle and push the ON/OFF to "OFF" position.
(See Diagram 1)
2. Open the battery cover. (See Diagram 1)
3. Insert 6 “AA” batteries by matching the (+) and (–) signs as indicated in the
battery compartment. (See Diagram 2)
4. Replace the battery cover.
TRANSMITTER
1. Slide open the battery cover at the back of the transmitter and insert
2 “AA” batteries batteries inside following the engraved sign. (See Diagram 3)
2. Replace the battery cover.
Note: Remove battery after you have finished using your vehicle.
HOW TO PLAY
START TO PLAY
1. Build up antenna by passing the cable through the antenna tube provided
and plug into the vehicle tightly. Otherwise, the vehicle will not work.
(See Diagram 4)
2. Push the ON/OFF switch to the "ON" position of the vehicle. (See Diagram 5)
OPERATION
1. Operate the vehicle with the transmitter (See Diagram 6).
2. Turn OFF the vehicle and the transmitter after playing and remove all
batteries from the transmitter and the car.
Keep packaging as it contains important information.
CAUTION: To prevent battery leakage:
Be sure to insert batteries correctly and always follow the product and
battery manufacturers' instructions.
Never mix old and new batteries (replace all batteries at the same time).
Never mix Alkaline, standard (Carbon Zinc) or rechargeable batteries.
Only batteries of the same or equivalent type as recommended are to be used.
Do not use RECHARGEABLE batteries, unless specified.
Non-rechargeable batteries are not to be recharged.
Rechargeable batteries are to be removed from the product before being
charged (if removable).
Rechargeable batteries are only to be charged under adult supervision (if
removable).
Always remove exhausted or dead batteries from the product.
Remove batteries from product before extended storage.
The supply terminals are not to be short-circuited.
Batteries are to be inserted with correct polarity.
Batteries may explode or leak if misused.
ATTENTION: Battery / Batteries should be installed by an adult only.
ATTENTION: User should remove the battery from the item before disposal.
AA/LR6 or AAA/LR03 Batteries may present a choking hazard - keep away
from young children.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
Unscrew to open
On/Off switch
6 x AA (R6) batteries
Battery cover
FCC Note: The antenna installed on the equipment is a unique one. Installation
of an unauthorized antenna on this equipment could void the user’s authority to
operate the equipment.
Cable
Back Panel of transmitter
• The WEEE symbol if present indicates that this item contains electrical or
electronic components which must be collected and disposed of separately.
• Never dispose of electrical or electronic waste in general municipal waste.
Collect and dispose of such waste separately.
• Make use of the return and collection systems available to you, or your local
recycling programme. Contact your local authority or place of purchase to
find out what schemes are available.
• Electrical and electronic equipment contains hazardous substances which,
when disposed of incorrectly, may leak into the ground. This can contribute
to soil and water pollution which is hazardous to human health, and endanger
wildlife.
• It is essential that consumers look to re-use or recycle electrical or electronic
waste to avoid it going to landfill sites or incineration without treatment.
FCC Information
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult your local retailer store or an experienced radio/TV technician for help.
If you cannot eliminate the interference, the FCC requires that you stop using
your product. Changes or modifications not expressly approved by the
Responsible Party may cause interference and void the user’s authority to
operate the equipment.
AA/LR6
Antenna tube
AA/LR6
2 x AA/LR6 batteries
Left/Right
On
Vehicle
Forwards/
Backwards
Transmitter
ENGLISH
Steering alignment lever
FRONT WHEELS STEERING ADJUSTMENT
1. If the vehicle does not run straight forwards, adjust the lever for satisfactory
alignment on the underside of the vehicle. (See Diagram 7)
2. If the vehicle runs towards left, turn "Steering Alignment Lever" towards "R"
3. If the vehicle runs towards right, turn "Steering Alignment Lever" towards "L"
© 2016 SCIENTIFIC TOYS LTD. 1108, TOWER B,
14 SCIENCE MUSEUM ROAD, TSIMSHATSUI, HONG KONG.
PRINTED IN CHINA
O.I. NO.5978
SIZE:210MM X 297MM
PN#65-5978-000-0100

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : Yes
Page Count                      : 1
XMP Toolkit                     : XMP toolkit 2.9.1-13, framework 1.6
About                           : uuid:a25393f2-1da1-11e6-be8a-001ec29f69d5
Producer                        : Acrobat Distiller 6.0.1 for Macintosh
Create Date                     : 2016:05:19 17:11:11+08:00
Modify Date                     : 2016:05:19 17:11:11+08:00
Creator Tool                    : Illustrator
Metadata Date                   : 2016:04:18 12:39:01+08:00
Thumbnail Format                : JPEG
Thumbnail Width                 : 256
Thumbnail Height                : 188
Thumbnail Image                 : (Binary data 21340 bytes, use -b option to extract)
Document ID                     : uuid:ed583668-f54d-11e5-aa3c-001ec29f69d5
Format                          : application/pdf
Creator                         : Scientific
Title                           : OI 5978(97200 ENG)for lab.ai
Author                          : Scientific

EXIF Metadata provided by EXIF.tools