Secure Wireless 915RPT DEVICE CONTROLLER User Manual 234732X1 indd

Secure Wireless, Inc DEVICE CONTROLLER 234732X1 indd

USERS MANUAL

Product DescriptionThe AT&T model number SW-ATT-RPTR9 is a proprietary 915MHz wireless repeater. Once it is installed and discovered, it will perform the repeating function automatically by determining which 915MHz transmissions are not being received by the DLC and will automatically repeat those 915MHz transmissions.The 915MHz Repeater is a fully supervised peripheral device that communicates with the DLC through a two-way proprietary 915MHz short range radio interface. The 915MHz Repeater receives and recognizes messages from other 915MHz devices (including the keypad, siren and DLC) and automatically repeats those messages from devices that are not being received by the DLC to extend the range of these devices.Installing/Replacing BatteriesThe 915MHz Repeater has two (2) non-rechargeable 3V CR123 batteries that provide twenty-four (24) hour battery backup. The batteries can be replaced by opening the battery compartment located on the rear of the unit.Installing the 915MHz RepeaterInstall the 915MHz Repeater by plugging the grounded plug into a single socket on a wall AC outlet. Then install the retaining screw into the plastic tab located at the top of the unit to secure the unit to the AC outlet.Discovering and Registering the 915MHz RepeaterFollow these steps to discover and register the 915MHz repeater: 1. Place the DLC into Discovery Mode in DLD.2. Make the 915MHz repeater discoverable by pressing the learn button.3. Confi rm that the 915MHz repeater has been discovered in DLD.4. Label the 915MHz repeater in DLD.This equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.• Reorient or relocate the receiving antenna• Increase the separation between the equipment and receiver• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected• Consult the dealer or an experienced radio/TV technician for help.Any changes or modifi cations not expressly approved by the party responsible for compliance could void the user’sauthority to operate the equipment.Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. exploitation est autorisée aux deux conditions suivantes: (1) appareil ne doit pas produire de brouillage, et (2) utilisateur de appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible en compromettre le fonctionnement.Copyright © 2013 Linear LLC. 234732X1FCC Compliance StatementThis device complies with FCC Rules and Regulations as Part 15 devices as well as Industry Canada license exempt RSS Rules and Regulations. Operation is subject to the following two (2) conditions: This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired operation.LISTEDSW-ATT-RPTR9 RTL 41809 Installation Instructions

Navigation menu