Secure Wireless 915RPT DEVICE CONTROLLER User Manual 234732X1 indd

Download:
Mirror Download [FCC.gov]
Document ID	1866037
Application ID	El1sy7Yt1uqQ0y9jLjBQJA==
Document Description	USERS MANUAL
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	8.67kB (108363 bits)
Date Submitted	2012-12-21 00:00:00
Date Available	2012-12-21 00:00:00
Creation Date	2012-10-17 10:39:11
Producing Software	Acrobat Distiller 10.1.4 (Windows)
Document Lastmod	2012-10-17 10:40:06
Document Title	234732X1.indd
Document Creator	PScript5.dll Version 5.2.2
Document Author:	Copyright © 2013 Linear LLC

SW-ATT-RPTR9
RTL 41809
Product Description
The AT&T model number SW-ATT-RPTR9 is a proprietary
915MHz wireless repeater. Once it is installed and discovered,
it will perform the repeating function automatically by
determining which 915MHz transmissions are not being
received by the DLC and will automatically repeat those
915MHz transmissions.
The 915MHz Repeater is a fully supervised peripheral
device that communicates with the DLC through a two-way
proprietary 915MHz short range radio interface. The 915MHz
Repeater receives and recognizes messages from other
915MHz devices (including the keypad, siren and DLC) and
automatically repeats those messages from devices that are
not being received by the DLC to extend the range of these
devices.
Installing/Replacing Batteries
The 915MHz Repeater has two (2) non-rechargeable 3V CR123
batteries that provide twenty-four (24) hour battery backup.The
batteries can be replaced by opening the battery compartment
located on the rear of the unit.
Installation Instructions
Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. exploitation est
autorisée aux deux conditions suivantes: (1) appareil ne doit pas
produire de brouillage, et (2) utilisateur de appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible
en compromettre le fonctionnement.
FCC Compliance Statement
LISTED
This device complies with FCC Rules and
Regulations as Part 15 devices as well as
Industry Canada license exempt RSS Rules
and Regulations. Operation is subject to the
following two (2) conditions: This device
may not cause harmful interference. This
device must accept any interference received,
including interference that may cause
undesired operation.
Installing the 915MHz Repeater
Install the 915MHz Repeater by plugging the grounded plug
into a single socket on a wall AC outlet. Then install the
retaining screw into the plastic tab located at the top of the
unit to secure the unit to the AC outlet.
Discovering and Registering the 915MHz Repeater
Follow these steps to discover and register the 915MHz
repeater:
1. Place the DLC into Discovery Mode in DLD.
2. Make the 915MHz repeater discoverable by pressing the learn
button.
3. Confirm that the 915MHz repeater has been discovered in DLD.
4. Label the 915MHz repeater in DLD.
This equipment has been tested and found to comply with
the limits for Class B Digital Device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures.
• Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and
receiver
•
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected
•
Consult the dealer or an experienced radio/TV technician
for help.
Any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
Copyright © 2013 Linear LLC.
234732X1

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
XMP Toolkit                     : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26
Format                          : application/pdf
Title                           : 234732X1.indd
Creator                         : Copyright © 2013 Linear LLC
Create Date                     : 2012:10:17 10:39:11-07:00
Creator Tool                    : PScript5.dll Version 5.2.2
Modify Date                     : 2012:10:17 10:40:06-07:00
Metadata Date                   : 2012:10:17 10:40:06-07:00
Producer                        : Acrobat Distiller 10.1.4 (Windows)
Keywords                        : 
Document ID                     : uuid:03995bad-c957-4ac3-88da-362a07f9540c
Instance ID                     : uuid:35d7e2f6-c1f0-4bcb-ae13-ffbae97e9d9b
Startup Profile                 : Print
Page Count                      : 1
Author                          : Copyright © 2013 Linear LLC
Warning                         : [Minor] Ignored duplicate Info dictionary

EXIF Metadata provided by EXIF.tools