Secure Wireless IJETV2 iJET Wireless RF Remote Control User Manual IJETV2 V1 0

Secure Wireless, Inc iJET Wireless RF Remote Control IJETV2 V1 0

Users Manual

CONGRATULATIONS ON YOUR PURCHASE OF THE iJET WIRELESS RF REMOTE CONTROL The iJet was designed to provide maximum control of your iPod from anywhere you choose to place it regardless of whether it is in your backpack or over a hundred feet away in a different room connected to your home stereo. Operation iPod RF receiver setup: (FIG 1) Plug the iJet into the dock connector located on bottom of your iPod. Please WAIT 30 seconds for the automatic self-diagnostic to run. Plug in your earbuds, speakers or connect to your home stereo through a set of RCA jacks (supplied in some iJet kits). To sync or charge the iPod, simply plug your USB/Firewire or charging device into the bottom of the iJet while it’s connected to the iPod. Advanced Low Power Mode (ALPM): The iJet uses an advanced power down mode which minimizes current draw on your iPod battery if you are not connected to a constant power source. After 20 minutes of sensing no music playing or no remote commands being sent, the iJet goes into a battery saving mode. The iJet receiver will automatically re-power itself when it detects music playing or a remote button being pressed for more than 0.6 seconds. Remote Control Functions Features • Pass-through 30-pin connector allows charge/sync. • Thin profile (only 0.55”). • Up to 150 ft range. • Supports iPod with dock connector from 3rd Gen forward. Optional iJet Accessories iJet Remote: Pair up to 10 iJet remotes with any iJet receiver. Place an iJet remote in each bedroom, out by pool or anywhere you choose to control your music. Pairing instructions: 1) Unplug iJet receiver from your iPod. 2) Make sure your iPod is sufficiently charged. 3) Plug the iJet receiver into the iPod dock connector. 4) Within 30 seconds of step 3, press and hold all four buttons simultaneously on the new remote for three seconds (Vol. +, Vol. -, FF, RW), release after three seconds. 5) The new remote has been paired. Technical Specifications Operating Range: Up to 150 ft. Transmission Method: Radio frequency Operating Frequency: 433.92 MHz Remote Power: (2) CR2025 3V Receiver Power: Powered from iPod with Advanced Low Power Mode (ALPM) Remote Dimensions/Weight: 2.2” x 1.3” x 0.43” / 0.7 oz Receiver Dimensions/Weight: 4.3” x 0.79” (w/o connector height) x 0.55” / 0.5 oz Contact ABT Advanced Bridging Technologies Toll Free 888-869-4737 5817 Dryden Place Ste. 104 Carlsbad, CA 92008 iPod is a registered trademark of Apple Computer, Inc. All rights reserved. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions. (1)This device may not cause harmful interference, and (2)This device must accept any interference received, including interference that may cause undesired operation. Per FCC 15.21, you are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. Rewind: Press and release this button to move track BACKWARDS. Press and HOLD this button to rewind through the track Volume Down: Press and HOLD this button to scroll volume down. Forward: Press and release this button to move track FORWARD. Press and HOLD this button to forward through the track. Volume Up: Press and HOLD this button to scroll volume up. Play/Pause/Sleep: Press and release to toggle between Pause and Play.* Press and HOLD for 2full seconds to put the iPod into sleep mode. If you press and hold this button for longer than 1second but less than 2 seconds, the iJet will ignore your request.

Navigation menu