Secure Wireless PAN319 Panic FOB User Manual

Secure Wireless, Inc Panic FOB

User Manual

SW-NAP-PAN Single Button Panic NAPCO CAMPATIBLE INSTALLATION MANUAL TECHNICAL SUPPORT Secure Wireless 866-908-Tech www.mysecurewireless.com KEYFOB ENROLLMENT PROGRAMMING For a detail programming guide, the instruction manual should be consulted for that panel. The below guide should only be used as a reference and not as a replacement for using the programming instructions. 1. ENTER Panel Programming 2. SELECT Zone # 3. ENTER 6 Digit Id Number ( located on back of unit) 4. ENTER Check sum (0-9 ; A-F) (located on back on unit. Digit that follows “:” on the Serial ID 5. ENTER Point “3” – for Panic 6. Push On/Off to Save Note : Panic trouble must reset at keypad after disarm Alpha Chart A - *0 C - *2 E - *4 B - *1 D- * 3 F - * 5 REPLACING THE BATTERY Open the case using a flathead screwdriver. (+) should be facing up. . Re-assembly by pressing the board into place firmly and re-attach with the screw. Snap case back together. FCC Compliance This device complies with Part 15 FCC Rules. Operation complies with the following 2 conditions (1) This device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation MODEL SW-NAP-PAN FCC ID QNP-PAN319 FREQUENCY 319.5 MHz WARRARTY Limited Life Time BATTERY CR2032 Replace with Panasonic MANUAL PART # 200-10002 Rev A USING PANIC ACCESSORIES The SW-NAP-PAN is equipped with an accessory pack to allow for a variety of uses for the SW-NAP-PAN. For WRIST-STRAP or NECK-STRAP: 1. Open the case with a flathead screw driver NECK-STRAP WRIST-STRAP 2. Choose NECK-STRAP or WRIST-STRAP case 3. Attach the new bottom case by pressing together firmly The other accessories can be used with the standard case bottom that is on the remote when taken out of the box.

Navigation menu