Selex ES 774-0850 VS3000 GTW/ 806-870 User Manual VS3000 FPG3 MAN 0205 01 QRG A4 pm6

Selex ES SPA VS3000 GTW/ 806-870 VS3000 FPG3 MAN 0205 01 QRG A4 pm6

Contents

safety instructions

P/N MAN-0698/01.01 P/N MAN-0698/01.01
Safety recommendations
Carefully read all of the cautions and warnings before using the
radio:
•Do not use the radio equipment for uses different than
those indicated in the manual.
•For a correct use of the radio equipment, read what
is listed in this user's guide.
•Protect the radio from sprinklings of water and/or other
liquids and from dust.
•Be careful not to damage the vehicular radio when
cleaning the vehicle.
•Do not place the audio accessories above the airbags
or in their area of action. If the airbag is activated, it
may not swell correctly and/or hurl the audio acces-
sories, with great force, inside the passenger compart-
ment where the vehicle occupants are located.
•Do not use the vehicular radio if the antenna and/or the
antenna cable are damaged.
•The electronic devices are sensitive to electromagne-
tic interference (EMI) if not adequately shielded, desi-
gned or configured differently for electromagnetic fields
immunity.
If electromedical equipment (ex. pace-makers, acou-
stical equipment, etc.) is used together with the vehi-
cular radio, make sure that it is adequately shielded
from external electromagnetic fields.
•Install the vehicular radio following the instructions
given in the installation guide. The mounting screws
can damage cables and wires that run under some
mounting surfaces in the vehicle. Be careful to avoid
mounting the bracket above these locations. The equi-
pment must be installed in such a way that it complies
with the national regulations in effect.
•Carry out the maintenance interventions on the vehi-
cular radio following the instructions given in the tech-
nical handbook.
•Follow all accident prevention standards when car-
rying out maintenance/installation interventions on the
vehicular equipment and use the proper tools (span-
ners, screwdrivers).
•First and second maintenance level interventions on
the equipment are to be carried out by authorized
technicians only.
Third maintenance level interventions are to be carried
out by SELEX technicians only. The maintenance le-
vels are defined in the technical manual.
WARNING
This equipment is marked
According to the requirements specified in the R&TTE directive
1999/5/EC and the Commission Decision 6th April 2000, the
EC marking is accompanied by the Class II equipment class
identifier.
The equipment (in the 380÷430 MHz and 410÷470 MHz
versions) is intended for sell and use in AT, BE, CY, CZ, DK, EE,
FI, FR, DE, GR, HU, IE, IT, LV, LT, LU, MT, NL, PL, PT, SK, SI, ES,
SE, GB.
This equipment requires authorization or license for use.
This equipment operates on frequency bands non-harmonised
in the EU.
This equipment can also be used worldwide where the
equipment is approved for use.
FCC APPROVAL
For US owners only
FCC approval
VS3000 GTW/806-870 vehicular equipment complies with
Part 15 of the FCC/Federal Communication Commission
regulations.
Operation is governed by the following:
FCC ID: X5Y774-0850
FCC ID: X5Y774-0850NB
These devices comply with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- these devices may not cause harmful interference, and
- these devices must accept any interference received,
including interference that may cause undesired
operation.
Any unauthorized modifications or changes to these
devices could void the user's authority to operate these
devices.
Note:
FCC ID X5Y774-0850 and FCC ID X5Y774-0850NB apply to
VS3000 GTW/806-870 versions only.
P/N MAN-0698/01.01 P/N MAN-0698/01.01
•Use only original accessories and spare parts, or
approved by the manufacturer, suitable for the vehicu-
lar radio.
The use of different accessories and/or spare parts
(earphone, antenna, etc.) makes the safety and
electromagnetic compatibility certifications to be valid
no more and it could lower the user safety level and/
or generate electromagnetic fields that exceed the
accepted limits.
•The emergency call is a priority type call.
The vehicular radio, like all mobile telephony equip-
ment, operates with radio frequency signals, therefore,
the forwarding of the call depends on the network
coverage at the moment of the call.
•If you need send an emergency call, keep pressed the
emergency button for at least 2 seconds, when the
radio is switched on.
Relating to the radio setting (from PRP), two cases
may occur if the transmission is inhibit:
a) the emergency call is not sent; it is necessary to
disable the Tx Inhibit function from radio menu to
forward a call (even if the call is an emergency
call).
b) the emergency call is sent and automatically the Tx
Inhibit function is disabled; from radio menu it is
possible to recover the Tx Inhibit function again.
•The E-WHERE is only suitable for vehicles with the
negative pole of the battery earthed to bodywork. In-
stallation on other vehicles can cause faults and dama-
ge/fire to cables.
• Do not take the radio into environments that have a
potentially explosive atmosphere (ex. fuel storage si-
tes, filling stations, etc.).
•After the radio has been trasmitting for a long period,
it may reach high temperatures: in such a case avoid
touching the radio shell.
The radio complies with all product specifications and great
care is taken by the manufacturer so that user safety, as far
as the effects of electromagnetic waves on health are concer-
ned, is guaranteed within the limits established by the interna-
tional specifications.
WARNING
WARNING
To comply with FCC RF exposure compliance require-
ments, a separation distance of at least 72 cm must be
maintained between the antenna of this device and all
persons. This device must not be co-located or ope-
rating in conjunction with any other antenna or tran-
smitter.”

Navigation menu