SendFar Technology HAB-03002 Wireless Access Bridge User Manual SF 300 user s manu Rev 1120

SendFar Technology Co., Ltd. Wireless Access Bridge SF 300 user s manu Rev 1120

Contents

Manual 2 revised

SF-300CB8/14Copyright © 2002 SendFar Technology. All rights reserved.SendFar is the registered trademark of SendFar Technology Co., Ltd..5. Product Specifications5.1 GeneralRadio Data Rate 11, 5.5, 2 and 1 Mbps, Auto Fall-BackClient Interface 10/100Base-T EthernetRange (open environment) 300m @ 11.0Mbps400m @ 05.5Mbps500m @ 02.0Mbps800m @ 01.0MbpsEMC Certifications FCC Part 15ETSI 300/328Compatibility Fully interoperable with IEEE802.11bcompliant productsPower Supply AC/DC Adapter：24V / 0.83A(via AC power outlet 100~240V, 50~60Hz)PoE：16 ~ 32V5.2 Network InformationNetwork Architecture Infrastructure (via SendFar AP/RB-8110AP or Bridge)Drivers Windows 95/98/ME/2000/NT 4.0/XPAccess Protocol CSMA/CARoaming IEEE802.11b compliantSecurity 64-/128-bit data encryption5.3 Radio SpecificationsFrequency Band 2.4 – 2.4835 GHzRadio Type Direct Sequence Spread Spectrum(DSSS)Modulation CCK (11, 5.5Mbps)DQPSK (2Mbps)DBPSK (1Mbps)Operation Channels North America：11Japan：14Europe：13Spain：2France：4Available Transmit Power Settings <30dBm (<1W) For FCC<20dBm (<100mW) For CEAntenna One detachable 5dBi omni-directionrubber antenna with RP-SMA (FCC) orSMA (ETSI) connector & 12dBi patchAntenna ( Option)Sensitivity @ FER=0.08 11.0 Mbps < -85dBm5.5 Mbps < -88dBm02.0 Mbps < -91dBm01.0 Mbps < -93dBm
SF-300CB9/14Copyright © 2002 SendFar Technology. All rights reserved.SendFar is the registered trademark of SendFar Technology Co., Ltd..5.4 EnvironmentalTemperature Range -20 to 55℃ (operating)-20 to 75℃ (storage)Humidity (non-condensing) 5% to 95% typical5.5 Physical SpecificationsDimensions 138.7mm x 104.0mm x 38.0mmWeight 600g
SF-300CB10/14Copyright © 2002 SendFar Technology. All rights reserved.SendFar is the registered trademark of SendFar Technology Co., Ltd..6. Software SpecificationsProtocol TCP/IP NAT/NAPT DHCP Client Virtual Server Mapping (NAT inbound server) 802.1d Transparent BridgingSecurity 64-/128-bit WEP encryption MAC address based access control User authentication in Web-based ManagerManagement Web-based Manager Telnet configuration Console (RS-232) configuration SNMP v1 SNMP MIB-II Private MIBMisc supports VLAN pass throughFirmware upgrade TFTP (Trivial FTP) Xmodem, 1K Xmodem Zmodem
SF-300CB11/14Copyright © 2002 SendFar Technology. All rights reserved.SendFar is the registered trademark of SendFar Technology Co., Ltd..7. Product Block Diagram[Blank]
SF-300CB12/14Copyright © 2002 SendFar Technology. All rights reserved.SendFar is the registered trademark of SendFar Technology Co., Ltd..8. Regulatory Compliance InformationFCC Part 15 Notice (Applicable to use within the USA)CAUTION: FCC Radio-Frequency Exposure NoticeThis device generates and radiates radio-frequency energy. In order to comply withFCC radio-frequency radiation exposure compliance requirements, a separationdistance of at least 20 cm must be maintained between the antenna of the deviceand all persons. This product does not contain any user serviceable components. Anyunauthorized product changes or modifications will invalidate SendFar’s warranty andall applicable regulatory certifications and approvals. This transmitter must not be co-located or operating in conjunction with any otherantenna or transmitter.Unintentional RadiatorWARNING: This equipment has been tested and found to comply with the limits for aClass B digital device as applicable, pursuant to Part 15 of the FCC Rules. These limitsare designed to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses and can radiate radiofrequency energy and, if not installed and used in accordance with the instructions,may cause harmful interference to radio communications. However, there is noguarantee that interference will not occur in a particular installation. If this equipmentdoes cause harmful interference to radio or television reception, which can bedetermined by turning the equipment off and on, the user is encouraged to try tocorrect the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected. Consult the dealer or an experienced radio/TV technician for help.This device complies with part 15 of the FCC Rules. Operation is subject to thefollowing two conditions:1 This device may not cause harmful interference, and (2) this device must acceptany interference received, including interference that may cause undersiredoperation.2 The user may find the following booklet prepared by the Federal CommunicationsCommission helpful:The Interference HandbookThis booklet is available from the U.S. Government Printing Office, Washington, D.C.20402. Stock No. 004-000-00345-4.
SF-300CB13/14Copyright © 2002 SendFar Technology. All rights reserved.SendFar is the registered trademark of SendFar Technology Co., Ltd..Appendix AThe purpose of this Appendix is to describe a SNMP proprietary MIB for the SendFar SF-300 Wireless Access Bridge.This MIB Module defines SendFar implementation-specific metrics useful in managingIEEE 802.11 on SendFar boxes. This is to be used as a supplement to the standard 802.11MIB proposed by IEEE.Information contained in the MIB elements defined in this module is affected by the Webconfiguration, except where it is explicitly noted to the contrary.Parameter Definition Table:Name Syntax AccessStatus InformationConnectedToSSID Octet String read-onlyUsingChannel Integer read-onlyAccessPointMACAddress Octet String read-onlyCurrentTransmissionRate Integer read-onlyCurrentLinkQuality Integer read-onlyClientBridgeMACAddress Octet String read-onlyCurrentIPAddress IP Address read-onlyLinkUpIndicator Integer read-onlyFirmware Version Octet String read-onlyCountersReceivedPacketsGoodCount Counter 32 read-onlyReceivedPacketsBadCount Counter 32 read-onlySentPacketsGoodCount Counter 32 read-onlySentPacketsBadCount Counter 32 read-onlyBootCount Counter 32 read-onlyPrivacy SettingsWEPEnabled Integer read-writeWEPKeyLength Integer read-writeWEPKey Octet String read-writeWEPKeyNumber Integer read-writeDenyUnencriptedData Integer read-writeSystem / IP settingsOperationMode Integer read-writeIPAddress IP Address read-writeSubnetMask IP Address read-writeIpGateway IP Address read-writeDeviceName Octet String read-writeWEB Administrator SettingsUserName Octet String read-writePassword Octet String read-writeSystem ManagementSysConfigSave Integer read-write
SF-300CB14/14Copyright © 2002 SendFar Technology. All rights reserved.SendFar is the registered trademark of SendFar Technology Co., Ltd..SysReboot Integer read-writeSysConfigApply Integer read-writeResetToFactoryDefaults Integer read-writeClearCounters Integer read-writeBridge TableBridgeTabeMACAddress Octet String read-only

Navigation menu