SendFar Technology HAB-03002 Wireless Access Bridge User Manual SF 300 user s manu Rev 1120
SendFar Technology Co., Ltd. Wireless Access Bridge SF 300 user s manu Rev 1120
Contents
- 1. Manual 1 revised
- 2. Manual 2 revised
Manual 2 revised
SF-300CB 5. Product Specifications 5.1 General Radio Data Rate Client Interface Range (open environment) EMC Certifications Compatibility Power Supply 11, 5.5, 2 and 1 Mbps, Auto Fall-Back 10/100Base-T Ethernet 300m @ 11.0Mbps 400m @ 05.5Mbps 500m @ 02.0Mbps 800m @ 01.0Mbps FCC Part 15 ETSI 300/328 Fully interoperable with IEEE802.11b compliant products AC/DC Adapter:24V / 0.83A (via AC power outlet 100~240V, 50~60Hz) PoE:16 ~ 32V 5.2 Network Information Network Architecture Drivers Access Protocol Roaming Security Infrastructure (via SendFar AP/RB-8110 AP or Bridge) Windows 95/98/ME/2000/NT 4.0/XP CSMA/CA IEEE802.11b compliant 64-/128-bit data encryption 5.3 Radio Specifications Frequency Band Radio Type Modulation Operation Channels Available Transmit Power Settings Antenna Sensitivity @ FER=0.08 2.4 – 2.4835 GHz Direct Sequence Spread Spectrum (DSSS) CCK (11, 5.5Mbps) DQPSK (2Mbps) DBPSK (1Mbps) North America:11 Japan:14 Europe:13 Spain:2 France:4 <30dBm (<1W) For FCC <20dBm (<100mW) For CE One detachable 5dBi omni-direction rubber antenna with RP-SMA (FCC) or SMA (ETSI) connector & 12dBi patch Antenna ( Option) 11.0 Mbps < -85dBm 5.5 Mbps < -88dBm 02.0 Mbps < -91dBm 01.0 Mbps < -93dBm Copyright © 2002 SendFar Technology. All rights reserved. SendFar is the registered trademark of SendFar Technology Co., Ltd.. 8/14 SF-300CB 5.4 Environmental Temperature Range Humidity (non-condensing) -20 to 55℃ (operating) -20 to 75℃ (storage) 5% to 95% typical 5.5 Physical Specifications Dimensions Weight 138.7mm x 600g 104.0mm x Copyright © 2002 SendFar Technology. All rights reserved. SendFar is the registered trademark of SendFar Technology Co., Ltd.. 38.0mm 9/14 SF-300CB 6. Software Specifications Protocol Security Management Misc supports Firmware upgrade TCP/IP NAT/NAPT DHCP Client Virtual Server Mapping (NAT inbound server) 802.1d Transparent Bridging 64-/128-bit WEP encryption MAC address based access control User authentication in Web-based Manager Web-based Manager Telnet configuration Console (RS-232) configuration SNMP v1 SNMP MIB-II Private MIB VLAN pass through TFTP (Trivial FTP) Xmodem, 1K Xmodem Zmodem Copyright © 2002 SendFar Technology. All rights reserved. SendFar is the registered trademark of SendFar Technology Co., Ltd.. 10/14 SF-300CB 7. Product Block Diagram [Blank] Copyright © 2002 SendFar Technology. All rights reserved. SendFar is the registered trademark of SendFar Technology Co., Ltd.. 11/14 SF-300CB 8. Regulatory Compliance Information FCC Part 15 Notice (Applicable to use within the USA) CAUTION: FCC Radio-Frequency Exposure Notice This device generates and radiates radio-frequency energy. In order to comply with FCC radio-frequency radiation exposure compliance requirements, a separation distance of at least 20 cm must be maintained between the antenna of the device and all persons. This product does not contain any user serviceable components. Any unauthorized product changes or modifications will invalidate SendFar’s warranty and all applicable regulatory certifications and approvals. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Unintentional Radiator WARNING: This equipment has been tested and found to comply with the limits for a Class B digital device as applicable, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undersired operation. The user may find the following booklet prepared by the Federal Communications Commission helpful:The Interference Handbook This booklet is available from the U.S. Government Printing Office, Washington, D.C. 20402. Stock No. 004-000-00345-4. Copyright © 2002 SendFar Technology. All rights reserved. SendFar is the registered trademark of SendFar Technology Co., Ltd.. 12/14 SF-300CB Appendix A The purpose of this Appendix is to describe a SNMP proprietary MIB for the SendFar SF300 Wireless Access Bridge. This MIB Module defines SendFar implementation-specific metrics useful in managing IEEE 802.11 on SendFar boxes. This is to be used as a supplement to the standard 802.11 MIB proposed by IEEE. Information contained in the MIB elements defined in this module is affected by the Web configuration, except where it is explicitly noted to the contrary. Parameter Definition Table: Name Syntax Status Information ConnectedToSSID Octet String UsingChannel Integer AccessPointMACAddress Octet String CurrentTransmissionRate Integer CurrentLinkQuality Integer ClientBridgeMACAddress Octet String CurrentIPAddress IP Address LinkUpIndicator Integer Firmware Version Octet String Access read-only read-only read-only read-only read-only read-only read-only read-only read-only Counters ReceivedPacketsGoodCount ReceivedPacketsBadCount SentPacketsGoodCount SentPacketsBadCount BootCount Counter 32 Counter 32 Counter 32 Counter 32 Counter 32 read-only read-only read-only read-only read-only Privacy Settings WEPEnabled WEPKeyLength WEPKey WEPKeyNumber DenyUnencriptedData read-write read-write read-write read-write read-write OperationMode IPAddress SubnetMask IpGateway DeviceName read-write read-write read-write read-write read-write UserName Password SysConfigSave Integer Integer Octet String Integer Integer System / IP settings Integer IP Address IP Address IP Address Octet String WEB Administrator Settings Octet String Octet String System Management Integer read-write read-write read-write Copyright © 2002 SendFar Technology. All rights reserved. SendFar is the registered trademark of SendFar Technology Co., Ltd.. 13/14 SF-300CB SysReboot SysConfigApply ResetToFactoryDefaults ClearCounters BridgeTabeMACAddress Integer Integer Integer Integer Bridge Table Octet String read-write read-write read-write read-write read-only Copyright © 2002 SendFar Technology. All rights reserved. SendFar is the registered trademark of SendFar Technology Co., Ltd.. 14/14
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No Create Date : 2003:11:20 14:49:02Z Modify Date : 2003:11:20 23:01:33+08:00 Page Count : 7 Creation Date : 2003:11:20 14:49:02Z Mod Date : 2003:11:20 23:01:33+08:00 Producer : Acrobat Distiller 5.0 (Windows) Author : Stephanie Metadata Date : 2003:11:20 23:01:33+08:00 Creator : Stephanie Title : Microsoft Word - SF-300 user's manu_Rev_1120.doc Has XFA : NoEXIF Metadata provided by EXIF.tools