Sensys Networks FLEXRAD FLEXRADIO CABINET User Manual Quick Start Guide

Sensys Networks, Inc. FLEXRADIO CABINET Quick Start Guide

Quick Start Guide

1608 4th Street Suite 200 Berkeley CA 94710 | info@sensysnetworks.com | P 510.548.4620 F 510.548.8264 Assemble1Quick Start Guide: FlexRadio CabinetA FlexRadio Cabinet assembly requires a single FlexRadio Cabinet module, omni directional antenna, 6 foot coaxial cable, and the bracket/DIN mount kit.FlexRadio Cabinet Installation PartsFlexRadio Cabinet requires the following tools for installation:• #2 Phillips bit screwdriver• 0.75” ( 1.9 cm) hole saw or step drill bit with power drill• Hand wrenchTools RequiredM3x4 mm screw x 4Rail x 2Use the Sensys Networks provided DIN or bracket mounts to install the FlexRadio Cabinet inside the trac cabinet.Refer to Assembly Instructions Bracket and DIN Mounts for more information.Install FlexRadio CabinetM3x4 mm screw x 4Rail x 2Install FlexRadio Cabinet2DRAFT
1608 4th Street Suite 200 Berkeley CA 94710 | info@sensysnetworks.com | P 510.548.4620 F 510.548.8264 Quick Start Guide: FlexRadio CabinetInstall the plastic washer (a) onto the threaded ferrule. Ensure the ange on the washer is seated on the ¾ inch hole. The at side of the washer contacts the nut.Add Washer Drill a hole ¾ inches ( 1.9 cm) diameter for aluminum ferrule antenna on top of the at surface of the trac cabinet with a hole saw or a step drill bit where the omni directional antenna will be installed.Note: Ensure the antenna hole location will not interfere with the trac cabinet inside.Drill a Hole in Trafc Cabinet3Install Omni Directional AntennaPass the connectors through the hole. Pull the cable until the threaded end of the antenna ferrule appears in the hole. DO NOT pull on connectors. Pulling on the connectors may cause them to detach or may cause internal damage to the cable connection.Thread Connectors into CabinetaPlease refer to Bolt-On Antenna Installation Guide - Slotted Washer & Nut that is provided in the antenna packaging for more details.Omni Directional Antenna InstallationDRAFT
Sensys Networks and the Sensys Networks logo are trademarks of Sensys Networks, Inc. All other trademarks are the property of their respective owners.Information contained herein is believed to be reliable, but Sensys Networks makes no warranties as to its accuracy or completeness. Copyright © 2017 Sensys Networks, Inc. • ALL RIGHTS RESERVED • P/N 152-240-XXX-XXX Rev ALocal DistributorQuick Start Guide: FlexRadio CabinetInstall Omni Directional Antenna (cont.)3Connect Cables to the FlexRadio Cabinet4Connect the RP TNC male end to the FlexRadio cabinet.WARNING: DO NOT OVER BEND CABLE. Do not bundle excess cable; only loop with bend radius no smaller than 6 inches (15.2 cm).Connect the Antenna to FlexRadio CabinetConnect FlexRadio Cabinet module to FlexControl Module using CAT5 (or better) straight-through cables via TO: SPP PORT on the FlexRadio Cabinet module and the SPP-0 (or SPP-1) port on the FlexControl Module. Power FlexRadio CabinetInstall nut on threaded ferrule. Hand tighten the nut until it contacts the plastic washer. Use a wrench to tighten the nut two more turns to secure the antenna and to seat the antenna’s gasket.Secure NutNotice: Any changes or modications not expressly approved by Sensys Networks could void the user’s authority to operate the equipment. The external antenna must have gain less than +6dBi to meet regulatory requirements.DRAFT

Navigation menu