Seura BTM1 Bluetooth Receiver Module Board User Manual

Seura Inc Bluetooth Receiver Module Board

User Manual

User Manual For Bluetooth Board  1.  Function   Be  used  for  communicating  with  other  Bluetooth  device  (by  Bluetooth  mode)  or  other sound source device (by AUX Mode), transmitting audio signal to amplify borad  2.  Operation Track  playback  controller  connects  to  the  external  keypad  through  an  I2C  interface, enabling  play/pause,  last  song,  next  song,  volume  +,  volume  -,  Bluetooth  /AUX  to  be switched.  Through a 3-pin serial port, you can set the Bluetooth board broadcast name, password, address, etc.        Control  command,  refer  to“RS232  Commands  and  Responses  for  BlueTooth Receiver(20180428).xlsx”. and “CMD(20180503).TXT”. LINE OUT AUX in DC-in 24V DC-out 24V port I2C port  RS323port Reset
  3.  Statement   Federal Communications Commission (FCC) Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generate, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:   Reorient or relocate the receiving antenna.   Increase the separation between the equipment and receiver.
  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.   Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. RF exposure warning This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment must not be collocated or operating in conjunction with any other antenna or transmitter.    OEM Integration Instructions: This device is intended only for OEM integrators under the following conditions: The module can be used to installation in specific host (Host information as follows). The module shall be only used with the integral antenna(s) that has been originally tested and certified with this module. As long as 2 conditions above are met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance requirement with this module installed.
Host Product Name: Lighted Bluetooth Mirror Manufacturer: SEURA Model Name: S-S-2424-SA-VE.6-BLED-BT  IMPORTANT NOTE: In the event that these conditions cannot be met (for example certain laptop configuration or  co-location  with  another  transmitter),  then  the  FCC  authorization  for  this  module  in combination with the host equipment is no longer considered valid and the FCC ID of the module  cannot  be  used  on  the  final  product.  In  these  and  circumstance,  the  OEM integrator will be responsible for re-evaluating. The end product (including the transmitter) and obtaining a separate FCC authorization. The final end product must be labeled in a visible area with the following: “Contains Transmitter Module FCC ID: 2APLNBTM1 or Contains FCC ID: 2APLNBTM1”.

Navigation menu