Shantou City Hengdi Industry 1335W WiFi Camera User Manual

Download:
Mirror Download [FCC.gov]
Document ID	3160688
Application ID	DcvoSi4NC+LJkef/lYDHVQ==
Document Description	user manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	233.31kB (2916389 bits)
Date Submitted	2016-10-12 00:00:00
Date Available	2016-10-12 00:00:00
Creation Date	2016-09-30 14:33:15
Producing Software	Adobe Acrobat 7.0 Image Conversion Plug-in
Document Lastmod	2016-09-30 14:33:28
Document Title	user manual
Document Creator	Adobe Acrobat 7.0

FCC statement
This device complies with Part 15 of the FCC Rules: Operation is subject to
the following two conditions:
1. This device may not cause harmful interference and
2. This device must accept any interference that is received, including any interfer
ence that may cause undesired operation.
*RF warning for Portable device: The device has been evaluated to meet general
RF exposure requirement. The device can be used in portable exposure condition
without restriction.
This device is acting as slave and operating in the 2.4 GHz (2412 ~2462 MHz)
band.
Ad Hoc function is supported but not able to operate on non-US frequencies.
Do not use the device with the environment which below minimum -10 ”C or maximum
over 50°C .
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Picture 1 Picture 2 _ Picture 3
Picture 1. Press the HOVER button to start /
stop flying after establishing connection.
Picture 2. 8t 3. Push the stick as pict—ures, it
can also start / stop flying.
STARTIFLY
After establishing connection, press the HOVER
button, the motors start to work. When pushing
the left stick upward. the quadcopter ascends.
When the quadcopter ascends upto the target
altitude, release the left stick, it will hold the
altitude and achieve hover flying. Then you can
control the direction with the right stick.
ASCEND
When pushing the left stick downward, the
quadcopter descends.
When the quadcopter descends downto the
target altitude, release the left stick, it will
hold the altitude and achieve hover flying.
Then you can control the direction with the
right stick.
DESCEND
When the quadcopter landing on
the ground, pushing the left stick
downward for 3 seconds, the
motors stop working . Pressing Ease-f
the HOVER button again can also
stop flying.
STOP FLYING
Use the right stick,(direc-
tional Stick) to fly left, fifth
right, move forward or «,M ->
backward. Normally, the Q3 I .53
Quadcopter's "front" is
the cockpit.
FLYING,
DIRECTIONS,
& TURNING
Turn left : Push the left
throttle stick towards left ((9 ii ‘23)
Turn right : Push the left Q 9
throttle stick towards right “
Can alao link the Junior: line with
computer again to refrnh after the
pond and the 083 data line.
(A: Pleural).
ACAUTION
When charging thru the included USB cable:
LED light is red indicating it is charging
LED light is out Indicating charging is done
ENVIRONMENT FOR FLIGHT
1.Always fly on a sunny. bright day with as little wind as possible.
Flying in extreme heat or cold can adversely affect your flying
control and response of the drone.
2.After connecting the battery. lay the SKY HAWKEYE on the
ground. Please wait for approximately 5-7 seconds to allow the
digital gyro to electronically stabilize. Push the throttle up and
then back down to pair the radio control transmitter to
the SKY HAWKEYE. The lights will stop blinking and now you
are all set to fly.
CONTROL METHOD
HUME. ' * ‘ write...
'nentrm >.
By default. the clearly marked cockpit on the unit is considered
the front. When flying the unit, your movements with the remote
control will work according to the direction of the cocpit. However,
this makes the unit very hard to fly at long range as it becomes
difficult to tell which direction the cockpit is pointing.
SmartFly is a mode which makes YOU the center of the unit. so the
vehicle will respond to directions as if it's facing the way you are
facing. Your left, right, up, and down also become that
for the quadcopter.
At anytime, press and hold the beacon button for
three seconds until you hear three “Ticks". If the unit
was headed away from you, when you hear the ticks,
the unit will head back in the opposite direction of
which it was headed and return to the general
vicinity of the radio transmitter.
Tech headless flight Auto-back beacon
MADEINCHINA E @® ® c€
SKY
HA WK E YE
YDUFI VIEW IN THE SK Y
WARNING
Suitable for Children 14+. Adult supervision is always recommended.
”This product contains small parts which are a choking hazard. Keep away from small children.
*Keep Quadcopter at least 10 feet away during use.
‘Correctly install the Quadcopter and fly it under the guidelines of the instruction manual. small parts should be
assembled by an adult.
"Manufacturers and dealers disclaim all responsibility for damage caused by misuse.
‘Keep hands, hair, and loose clothing away from rotors when powered on to prevent damage to the helicopter
or serious injury to self.
'This QUAD should not be flown IN HIGH WINDS(5+Mph) or near a pool.
‘Never leave a charging battery unattended.
”When cleaning it, ensure that the helicopter is disconnected from the charger.
'To prevent injury, do not point the antenna directly to faces, eyes, or other people.
NOTE ON THE BATTERY
This product ls fumlshed with a battery pack, please pay attention to the following safety Instructions:
® Only use the charger provided by the factory for charging.
@When charging the battery: If the battery is too hot. it means the battery is overcharged. In such case,
users should stop charging the battery immediately. Overcharging could damage the battery etemally.
@After flying the helicopter, the battery temperature may be relatively high. Users are advised to wait
about 10 minutes until the battery has cooled before recharging.
@ Turn off the helicopter whenever it is not in use. If you don't plan on flying the helicopter for along time,
charge the battery for about 1 hour before storing it.
Caution: Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the local laws in your state
.1.
NEVER LEAVE IT UNATTENDED WHILE CHARGING THIS CAN BE A FIRE HAZARD.
WE ARE NOT RESPONSIBLE FOR MISUSE.
Batteries:
'Use "AA" non-rechargeable battery or “AA" rechargeable battery.
*Only use batteries of the same or equivalent type as recommended
*Batteries are to be inserted with correct polarity.
'Do not short cut the supply terminals.
*Lithium-ion battery could be flammable if misused.
*Do not mix old and new batteries.
'00 not mix alkaline batteries. standard (carbon-zinc), or rechargeable (Nickel-Cadmium) batteries.
*Remove exhausted batteries.
*Take out the batteries when not in use.
'Rechargeable batteries are to be removed from the toy before being charged.
*If you do not fly the Quadcopter for a long time. take out the batteries inside the controller to avoid battery
leakage which would damage the product.
“Photos are for reference only; the appearance of the actual product is based on what it is.
‘When the controller/helicopter is underpowered, the control distance will be shortened. This will also result
in difficulty of taking off and low flight altitude.
'Do not crash or allow helicopter to fall from high altitude. Helicopter will break and service life may be
reduced
Please retain this information for future reference
Throttle stick 7 Direction control stick
Video u
photo(do(wfi; ,
Direction trim l ,« 5 ¥ * 3'“ trim
Power swrtch 41;, .. J
Speed setting 3 files T ' ‘ 360 ° flip (press once)
Smart fly Auto-back beacon
Tech headless flight
Hold altitude mode Auto hover
.2.
TRANSMITTER BATTERY INSTALLATION
Battery lid
ACAUTION If transmitter is not to be used for a long
duration,please remove batteries for storage.
Warning: if the AA batteries are left in the transmitter, potential leakage could
A WARNING: occur which may damage the transmitter,and create fire hazards.
Very Carefully remove battery from slot as pictured being
careful not to pull battery by the wires otherwise you could
disconnect or break one of the wires (As PictureZ).
Carefully Disconnect the Battery wires from the battery
also note that battery might be not if removing afler use,
in this case wait a few minutes before charging again.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
XMP Toolkit                     : 3.1-701
Modify Date                     : 2016:09:30 14:33:28+08:00
Create Date                     : 2016:09:30 14:33:15+08:00
Metadata Date                   : 2016:09:30 14:33:28+08:00
Creator Tool                    : Adobe Acrobat 7.0
Format                          : application/pdf
Document ID                     : uuid:8c2b5357-3ef9-4857-993a-b63338dae45a
Instance ID                     : uuid:2f3f6bf9-11c0-4778-9081-7857f18f2e23
Producer                        : Adobe Acrobat 7.0 Image Conversion Plug-in
Page Count                      : 1
Creator                         : Adobe Acrobat 7.0

EXIF Metadata provided by EXIF.tools