ShenZhen Fujikam Industry Development RF1 RF Peripheral Wireless Door / Window Sensor User Manual 2

ShenZhen Fujikam Industry Development Co., Ltd RF Peripheral Wireless Door / Window Sensor 2

user manual

Wireless Door Sensor Working with Vimtag cloud IP camera, RFC1 is a wireless door sensor which could detect the opening and closing of the doors and windows. It sends an alarm signal to the camera when it detects over 3 cm position offset between the signal transmission module and the magnetic box. Users could receive the alarm message on Vimtag application, and take immediate action to stop the intruders.IntroductionInstallation GuideAdd DeviceCAUTIONSpecifications Step 1: Stick the Transmission module and the Magnetic box on the door or the window, keeping them at a distance of 2 cm or less.Step 2: Close and open the door or window to see if the red light on the transmission module is on. If the light is on, installation succeeded. Please make sure you have added camerasto your account before adding the accessories.Adding Procedure:1. Log in to your account2. Enter the Settings interface of the camera3. Select Accessory4. Select Door Senor5. Follow the APP instruction to complete adding.RF Perpheral RF Perpheral Battery model: CR2032Service life: 2 yearsPower: 12dBmVoltage: 2.7V-3.3VWorking Distance: 80MTemperature: -10℃~55℃NOTE: This equipment has been tested and found to comply with the limits for aClass B digital device, pursuant to part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection against harmful interference in aresidential installation. This equipment generates uses and can radiate radiofrequency energy and, if not installed and used in accordance with the instructions,may cause harmful interference to radio communications. However, there is noguarantee that interference will not occur in a particular installation. If thisequipment does cause harmful interference to radio or television reception, whichcan be determined by tur ning the equipment off and on, the user is encouraged totry to correct the interference by one or more of the following measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.-Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected.-Consult the dealer or an experienced radio/TV technician for helpChanges or modifications not expressly approved by the party responsible forcompliance could void the user's authority to operate the equipment. This device complies with Part15 of the FCC Rules. Operation is subject to the following two conditions:(1) this device may not cause harmful interference, and(2) this device must accept any interference received, including interference that maycause undesired operation.

Navigation menu