ShenZhen Zhongherong Electric Technology SZESKY001 Remote Control Toy Transmitter User Manual I

ShenZhen Zhongherong Electric Technology Co., Ltd. Remote Control Toy Transmitter I

Contents

User Manual I

Caution Please read this manual carefully before operationand keep the manual for after reference2.4G2.4G 2.4G TRANSMITTER INSTRUCTION MANUAL2.4G Remote control system adopts Advanced Spread Spectrum Technology and digital FSK (frequency shift key) Coding Technology.
CatalogueEK2-0404G EK2-0406G4CH Transmitter 6CH Transmitter2.4G2.4G TRANSMITTER INSTRUCTION MANUAL12.4G Remote control system adopts Advanced Spread Spectrum Technology and digital FSK (frequency shift key) Coding Technology. Meaning of special markingsProhibitedntroduction to 2.4G systemRegulation and operating procedure of 2.4G RC SystemRemarksTransmitter operation and the work of helicopterName and operation of each partThrottle/pitch curve diagramHovering pitch knobPitch Trim knobAdjustment procedureNi-cd/Ni-mh battery chargingNi-CD/Ni-MH battery charging precautionsGLOSSARYEK2-0406H6CH TransmitterEK2-04246CH Receiver12
Symbol: Prohibited MandatoryDANGERWARNINGCAUTION,,To ensure safe use, observe the following precautions.MEANING OF SPECIAL MARKINGSPay special attention to the safety at the parts of this manual that are indicated by the following marks.Procedures which may lead to a dangerous condition and cause death or serious injury to the user if not carried out properly.Procedures which may lead to a dangerous condition or cause death or serious injury to the user if not carried out properly, or procedures where the probability of superficial injury or physical damage is high.Procedures where the possibility of serious injury to the user is small, but there is a danger of injury, or physical damage if not carried out properly.2.4G2.4G TRANSMITTER INSTRUCTION MANUAL22.4G Remote control system adopts Advanced Spread Spectrum Technology and digital FSK (frequency shift key) Coding Technology.,,
Do not fly in rainy or windy days, or at night. Water will penetrate into the transmitter and cause faulty operation, or loss of control, and cause a crash.Wind NightBefore starting the engine, check the direction of control leverwhich matched to each servo. If the servo does not move in theproper direction or the operation is abnormal, please do not operate.The flight Range ability and performance will be in the groove when the transmitter is placed at 45 degree to the plane. 2.4G2.4G TRANSMITTER INSTRUCTION MANUAL32.4G Remote control system adopts Advanced Spread Spectrum Technology and digital FSK (frequency shift key) Coding Technology.Please confirm that the LED indicator on receiver and 4 in 1 mix controller are in normal operation after the code binding completed.
2.4GIntroduction to 2.4G system*2.4 G *2.4G FSK*2.4G*2.4G 1/4 2.4GhzTWF Company newly designed 2.4G frequency band, 2.4G RC system with advanced Spread Spectrum Technology and digital FSK (frequency shift key) Coding Technology, which manifested tremendous vantage compared to traditional transmitter.Traditional remote control distance is about 250meters, required a transmitter with 750mW transmitting power consumption, but 2.4G transmitter just need 4mW power consumption.2.4G Channel with wide use, can generate corresponding frequency through binding or FSK, there will be no frequency interfering when fly simultaneously.2.4G remote control system adopts superintegrated frequency synthesis and FSK(frequency shift key) technology, which can automatically program and set the working frequency under the supporting of microprocessor. Flyers would enjoy a free flight without changing crystal. With dual transmission characteristic, the data will be in dual transmission & confirmation between transmitter and receiver. So probabilize many extended functions.With the characteristics of quick response, high precision and non servo quiver.2.4G RC System frequency wave range is 1/4 of the usual used frequency wave range, because 2.4Ghz device with high frequency, short wave range, so the transmitter antenna is just 14.5cm in length.2.4G2.4G TRANSMITTER INSTRUCTION MANUAL42.4G Remote control system adopts Advanced Spread Spectrum Technology and digital FSK (frequency shift key) Coding Technology.
2.4GRegulation and operating procedure of 2.4G RC SystemBinding for RC System of each model has been completed in factory, without needing to debug again.Normal operation manifested as below:Power on the transmitter, the indicator of 2.4G transmitter will twinkle for 3 seconds, which indicates that transmitter is sending code binding information. After 3 seconds, the twinkling 2.4G transmitter indicator becomes solid, Then connect the receiver or 4in 1 mix controller, observe the receiver or 4 in 1 mix controller, 2.4G transmitter indicator twinkles two times and gets solid, which indicates that the reception of the channel data is successful and are ready to fly. Turn on the transmitter and power on the helicopter. LED indicator of receiver or 4 in 1 mix controller go out after twinkling two times, indicating that binding is failing and need to unbind firstly and rebind.State indicator Bind keystoke How to unbind? Turn off the transmitter Connecting the battery to receiver, Press the bind keystoke for 1 or 2 seconds LED indicator of Receiver will twinkle constantly, which indicates that unbinding has completed. (As shown in the right picture)RebindFirstly disconnect the receiver and 4 in 1 mix controller, then connect the receiver or 4 in 1 mix controller to the power the state indicator twinkles slowly, which indicates that receiver is receiving signal. Then Power on the transmitter if the indicator of RX display from slow twinkling to rapid twinkling, then solid, which indicate the binding is successful.(Note: transmitter just will transmit code in first 3 seconds, if receiver can not receive code within 3 seconds, please turn on the transmitter again.)2.4G2.4G TRANSMITTER INSTRUCTION MANUAL52.4G Remote control system adopts Advanced Spread Spectrum Technology and digital FSK (frequency shift key) Coding Technology.
Remarks:Power on the transmitter, indicator twinkles 50times within 3 seconds of binding period, the indicator get solid after the binding.(Please note that in the process of binding, first connect the receiver or 4 in 1Mix controller before powering on the transmitter)If binding is not successful, the indicator of receiver or 4 in 1 mix controller will twinkle two times then go out.Since different manufacturers have different frequency band, channel and different coding and decoding method, so different products are incompatible, all RC system should be under the original trademark. Do turn on the transmitter once again in each binding.2.4G2.4G TRANSMITTER INSTRUCTION MANUAL62.4G Remote control system adopts Advanced Spread Spectrum Technology and digital FSK (frequency shift key) Coding Technology.
TRANSMITTER OPERATION AND THE WORK OF HELICOPTERBefore using ,please know the operation of transmitter and the movement of each servo carefully. The following instruction take the transmitter as the keystone .1Model 1 (right throttle)When the aileron stick is moved to the left,the swashplate also tilt to the left, and the helicopter moves to the left.When the aileron stick is moved to the right, the swashplate also tilt to the right, and the helicopter moves to the right. When the throttle stick is pushed upward, the speed of the motor and main rotor increases , as a result, the helicopter lifts up. When the throttle stick is pushed downward,the speed of motor and main rotor decreases, as a result, the helicopter descends.2.4G2.4G TRANSMITTER INSTRUCTION MANUAL72.4G Remote control system adopts Advanced Spread Spectrum Technology and digital FSK (frequency shift key) Coding Technology.
When the elevator stick is pushed forward, the nose of helicopter will tilt downward, asa result, the helicopter moves forward andits speed decreases. When the elevator stick is pushed backward, the nose of the helicopter will tilt upward,then the helicopter moves backward and its speed increases.When the rudder stick is moved to the right,the tail of helicopter moves to the left and the nose of the helicopter turns to right.Please pay attention to the nose of helicopter. When the rudder stick is moved to the left,the tail of helicopter moves to the right andthe nose of the helicopter turns to left. Please pay attention to the nose of helicopter. 2.4G2.4G TRANSMITTER INSTRUCTION MANUAL82.4G Remote control system adopts Advanced Spread Spectrum Technology and digital FSK (frequency shift key) Coding Technology.
When the throttle stick is pushed downward.the speed of the motor and main rotor increases, as a result, the helicopter descends.When the throttle stick is pushed upward,the speed of the motor and main rotor increases, as a result, the helicopter lifts up. When the aileron stick is moved to the right, the swashplate also tilt to the right, and the helicopter moves to the right. When the aileron stick is moved to the left, the swashplate also tilt to the left, and the helicopter moves to the left.2Model 2 (left throttle)2.4G2.4G TRANSMITTER INSTRUCTION MANUAL92.4G Remote control system adopts Advanced Spread Spectrum Technology and digital FSK (frequency shift key) Coding Technology.

Navigation menu