Shure orporated UR1MB Micro Bodypack Transmitter User Manual

Download:
Mirror Download [FCC.gov]
Document ID	908037
Application ID	bw8+DZ57EUeGBY5CcqLf2A==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	29.96kB (374549 bits)
Date Submitted	2008-02-29 00:00:00
Date Available	2008-03-01 00:00:00
Creation Date	2008-02-19 14:32:13
Producing Software	Adobe PDF Library 8.0
Document Lastmod	2008-02-20 17:18:37
Document Title	User Manual
Document Creator	Adobe InDesign CS3 (5.0.2)

UR1M Micro Bodypack Transmitter
Addendum
Specifications:
Features
The following specifications
apply to the UR1M micro
bodypack only.
UR1M
Same audio performance as UR1
•
Rapid two-way infrared (IR) data transmission
•
User-adjustable RF output level (10 mW or 50 mW)
•
Operates with two type of primary batteries: alkaline or
lithium
•
Audio signal is input through a TA4F connector (UR1M) or
a LEMO connector (UR1MLEMO3)
•
Selectable battery metering by battery type
•
Audio metering on UR1M transmitter that is the same as
UR4 receiver
Battery Life (Typical):
Frequency Range
Band
•
Range
G1
470-530 MHz
H4, H4E
518-578 MHz
J5
578-608, 614-638 MHz
J5E
578-638 MHz
L3E, L3
638-698 MHz
Q5
740-814 MHz
Q6
740-752 MHz
Q9
740-806 MHz
R9
790-865 MHz
R16, R18
794-806 MHz
A24
779-788, 797-806 MHz
JBX
806-810 MHz
X1
944-952 MHz
RF Carrier Frequency Range
470-865, 944-952 MHz depending on region
Alkaline
5 hours (normal RF power)
3 hours (high RF power)
Lithium primary
9 hours, typical
NiMH
3 hours, typical
Select Battery Type:
Set the the micro bodypack transmitter switch to on
Press enter key, then scroll using
type. Press enter key to confirm.
button to select battery
Overall Dimensions
49 mm L x 60 mm W x 17 mm D (1.9 x 2.38 x 0.66 in.)
Net Weight
62 g (2.2 oz.) without batteries
Wiring
TA4F Connector
Microphone Element
TA4F
Connector
TA4M
Connector
UR1 MIC JACK BOARD
Working Range
150 m (500 ft.), under typical conditions
500 m (1600 ft.) line-of-sight, outdoors
for a single system
NOTE: Actual working range depends on RF signal absorption,
reflection and interference
RF Power Output
10 mW or 50 mW depending on region
Power Requirements:
Two 1.5V AAA alkaline, primary lithium, and NiMH batteries
Active Load
Audio
Ground
NOTE: LAVALIER MIC TIES PINS 3 AND 4 TOGETHER—GUITAR CABLE DOES NOT.
LEMO Connector
Microphone Element
UR1 LEMO BOARD
Current Drain:
Audio
130 mA max. at 3V (normal RF power setting)
200 mA max. at 3V (high RF power setting)
Ground
FVB.00.303
27A11964 (Rev. 1)
©2008 Shure Incorporated
XRB.00.303
Printed in U.S.A.
REPLACEMENT PARTS AND ACCESSORIES
UR1M Transmitter RF Output
Connector:
SMA
Actual Impedance:
50 Ω
Pin Assignments:
Shell = Ground
Center = Signal
UR1M Transmitter Audio Input
Connector:
4-Pin male mini connector
(TA4M)
3-Pin female mini connector
(LEMO XRB.00.303)
Input Configuration:
Unbalanced, active
Furnished Accessories
Antenna, 470-530 MHz........................................................UA701
Antenna, 518-578 MHz........................................................UA711
Antenna, 578-638 MHz .......................................................UA721
Antenna, 638-698 MHz .......................................................UA722
Antenna, 740-865 MHz .......................................................UA731
Antenna, 944-952 MHz .......................................................UA741
Optional Accessories
Bodypack Pouch (Black)................................................... WA581B
Bodypack Pouch (White)................................................. WA581W
3-Pin mini Lemo conversion kit...........................................WA335
3-Pin mini Lemo Jack for Lavalier.......................................WA336
Assembly Tool for WA336...................................................WA337
Maximum Input Level:(1 kHz, +5 dBu (sensitivity 0 dB)
1% THD)
+15 dBu (sensitivity –10 dB)
TA4M Connector Pin
Assignments:
Pin 1: Ground
Pin 2: +5 VDC bias
Pin 3: Audio
Pin 4: Tied through active load
(on main board) to ground.
(On instrument adapter cable,
Pin 4 floats)
LEMO Connector Pin
Pin 1: Ground
Assignments:
Pin 2: +5 VDC bias
Pin 3: Audio
(8.2 kΩ between pin 2 and 3
internal to UR1M)
Certification
UR1M: Type Accepted under FCC Parts 74 (FCC ID: DD4UR1MA, DD4UR1MB, DD4UR1MC, DD4UR1MF, DD4UR1MG). Certified by
IC in Canada under RSS-123 and RSS-102 (IC: 616A-UR1MA, 616A-UR1MB, 616A-UR1MC). Meets the essential requirements of the
European R&TTE Directive 99/5/EC (ETSI EN 300-422 Parts 1 & 2, EN 301 489 Parts 1 & 9) and is eligible to carry the CE marking.
The “EU Declaration of Conformity” can be obtained from Shure Inc. or any of its European representatives. For contact information
please visit www.shure.com
LICENSING INFORMATION:
Licensing: A ministerial license to operate this equipment may be required in certain areas. Consult your national authority for possible
requirements.
Changes or modifications not expressly approved by Shure Incorporated could void your authority to operate the equipment. Licensing
of Shure wireless microphone equipment is the user’s responsibility, and licensability depends on the user’s classification and application, and on the selected frequency. Shure strongly urges the user to contact the appropriate telecommunications authority concerning
proper licensing, and before choosing and ordering frequencies.
Information to User
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Operation of this device is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Note: EMC conformance testing is based on the use of supplied and recommended cable types. The use of other cable types may
degrade EMC performance.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : No
Encryption                      : Standard V2.3 (128-bit)
User Access                     : Print, Extract, Print high-res
XMP Toolkit                     : 3.1-702
About                           : uuid:47dbabb3-9526-4be0-bb56-4c034ad2cb7d
Producer                        : Adobe PDF Library 8.0
Trapped                         : False
Create Date                     : 2008:02:19 14:32:13-06:00
Metadata Date                   : 2008:02:20 17:18:37-06:00
Modify Date                     : 2008:02:20 17:18:37-06:00
Creator Tool                    : Adobe InDesign CS3 (5.0.2)
Thumbnail Format                : JPEG
Thumbnail Width                 : 256
Thumbnail Height                : 256
Thumbnail Image                 : (Binary data 11844 bytes, use -b option to extract)
Instance ID                     : uuid:31a03169-b2f7-457a-80b0-1545e187f824
Rendition Class                 : proof:pdf
Document ID                     : adobe:docid:indd:16204d36-c9e1-11dc-a17e-806c96074dbb
Derived From Instance ID        : 16204d35-c9e1-11dc-a17e-806c96074dbb
Derived From Document ID        : adobe:docid:indd:b790a766-70f5-11dc-8bfe-928fac9da395
Manifest Link Form              : ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream
Manifest Placed X Resolution    : 72.00, 72.00, 72.00, 72.00, 72.00, 72.00, 72.00, 72.00
Manifest Placed Y Resolution    : 72.00, 72.00, 72.00, 72.00, 72.00, 72.00, 72.00, 72.00
Manifest Placed Resolution Unit : Inches, Inches, Inches, Inches, Inches, Inches, Inches, Inches
Manifest Reference Instance ID  : uuid:0BB51F253EDBDC11809388AD0609DF71, uuid:206901357735DC1194AEDEF7FE02C1FF, uuid:E16B4C1377D6DC11886BACAE5421A752, uuid:466CA41860CBDC11AC87FC606179B15C, uuid:466CA41860CBDC11AC87FC606179B15C, uuid:206901357735DC1194AEDEF7FE02C1FF, uuid:E16B4C1377D6DC11886BACAE5421A752, uuid:466CA41860CBDC11AC87FC606179B15C
Manifest Reference Document ID  : uuid:FFB50B2135DBDC11809388AD0609DF71, uuid:612B51F5492EDC11808FEEE36C2789D2, uuid:456CA41860CBDC11AC87FC606179B15C, uuid:456CA41860CBDC11AC87FC606179B15C, uuid:612B51F5492EDC11808FEEE36C2789D2, uuid:456CA41860CBDC11AC87FC606179B15C
Format                          : application/pdf
Has XFA                         : No
Page Count                      : 2
Creator                         : Adobe InDesign CS3 (5.0.2)

EXIF Metadata provided by EXIF.tools