Shure orporated UR1MD Wireless Microphone Transmitter User Manual
Shure Incorporated Wireless Microphone Transmitter
User Manual
UR1M Micro Bodypack Transmitter Addendum Features: Specifications: The following specifications apply to the UR1M micro bodypack only. UR1M Frequency Range Band Range G1 470-530 MHz H4, H4E 518-578 MHz J5 578-608, 614-638 MHz J5E 578-638 MHz L3, L3E 638-698 MHz Q5 740-814 MHz Q6 740-752 MHz Q9 740-806 MHz Q10A 740-787 MHz R9 790-865 MHz R16, R18 794-806 MHz A24 779-788, 797-806 MHz JBX 806-810 MHz X1 944-952 MHz • Same audio performance as UR1 • Rapid two-way infrared (IR) data transmission • User-adjustable RF output level (10 mW or 50 mW) • Operates with three types of primary batteries: alkaline, lithium or NiMH • Audio signal is input through a TA4F connector (UR1M) or a LEMO connector (UR1MLEMO3) • Selectable battery metering by battery type • Audio metering on UR1M transmitter Battery Life (Typical): Alkaline: 6 hours (normal RF power) 4 hours (high RF power) Lithium primary: 9 hours (normal RF power) 7 hours (high RF power) NiMH 1000 mAH: 6 hours (normal RF power) 4 hours (high RF power) Select Battery Type: Set the micro bodypack transmitter switch to on Press enterkey, then scroll using enterkey to confirm. button to select battery type. Press Note: For the most accurate battery metering and performance, make sure to select the correct battery type. To open the micro bodypack transmitter, see illustrations below: Slide arrow down RF Carrier Frequency Range 470-865, 944-952 MHz depending on region Working Range 150 m (500 ft.), under typical conditions 500 m (1600 ft.) line-of-sight, outdoors for a single system NOTE: Actual working range depends on RF signal absorption, reflection and interference RF Power Output Selectable 10 mW or 50 mW depending on region Power Requirements: Two 1.5V AAA alkaline, lithium primary, and NiMH batteries Current Drain: 130 mA max. at 3V (normal RF power setting) 200 mA max. at 3V (high RF power setting) Gain Adjustment Range –20 to +35 dB Transmitter LCD Interface and Controls: For additional information on the LCD Interface and controls, see UHF-R User Guide. 27A12268 (Rev. 1) ©2008 Shure Incorporated Printed in U.S.A. Overall Dimensions 49 mm L x 60 mm W x 17 mm D (1.9 x 2.38 x 0.66 in.) UR1M Transmitter Audio Input: Connector: Net Weight 62 g (2.2 oz.) without batteries 3-Pin female mini connector (LEMO XRB.00.303) Wiring TA4F Connector Microphone Element TA4F Connector 4-Pin male mini connector (TA4M) TA4M Connector UR1M MIC JACK BOARD Input Configuration: Unbalanced, active Maximum Input Level: +5 dBu (sensitivity 0 dB) (1 kHz, 1% THD) +15 dBu (sensitivity –10 dB) TA4M Connector Pin Pin 1: Ground Pin 2: +5 VDC bias Pin 3: Audio, 200 kΩ Pin 4: Tied through active load (on main board) to ground. (On instrument adapter cable, Pin 4 floats) Assignments: Active Load Audio Ground NOTE: LAVALIER MIC TIES PINS 3 AND 4 TOGETHER—GUITAR CABLE DOES NOT. LEMO Connector Pin Pin 1: Ground Assignments: Pin 2: +5 VDC bias Pin 3: Audio LEMO Connector Microphone Element (8.2 kΩ between pin 2 and 3, internal to UR1M) UR1M LEMO BOARD REPLACEMENT PARTS AND ACCESSORIES Audio Furnished Accessories Antenna, 470-530 MHz.....................................................................UA700 Antenna, 518-578 MHz.....................................................................UA710 Antenna, 578-698 MHz ....................................................................UA720 Antenna, 740-865 MHz ....................................................................UA730 Antenna, 944-952 MHz ....................................................................UA740 Ground Connector Connector Optional Accessories Bodypack Pouch (Black).............................................................. WA581B Bodypack Pouch (White).............................................................. WA581W 3-Pin mini Lemo conversion kit........................................................WA335 3-Pin mini Lemo plug for Lavalier.....................................................WA336 Assembly Tool for WA336................................................................WA337 UR1M Transmitter RF Output: Connector: SMA Actual Impedance: 50 Ω Pin Assignments: Shell = Ground Center = Signal Note To fully interact with the Receiver, it is recommended to upgrade the UR4 firmware to 1.50 or higher and Shure Wireless Workbench to 5.0 Certification: UR1M: Type Accepted under FCC Parts 74 (FCC ID: DD4UR1MA, DD4UR1MB, DD4UR1MC, DD4UR1MD, DD4UR1MF, DD4UR1MG). Certified by IC in Canada under RSS-123 and RSS-102 (IC: 616A-UR1MA, 616A-UR1MB, 616A-UR1MC-616A, 616A-UR1MD). Meets the essential requirements of the European R&TTE Directive 99/5/EC (ETSI EN 300-422 Parts 1 & 2, EN 301 489 Parts 1 & 9) and is eligible to carry the CE marking. The “EU Declaration of Conformity” can be obtained from Shure Inc. or any of its European representatives. For contact information please visit www.shure.com LICENSING INFORMATION: Licensing: A ministerial license to operate this equipment may be required in certain areas. Consult your national authority for possible requirements. Changes or modifications not expressly approved by Shure Incorporated could void your authority to operate the equipment. Licensing of Shure wireless microphone equipment is the user’s responsibility, and licensability depends on the user’s classification and application, and on the selected frequency. Shure strongly urges the user to contact the appropriate telecommunications authority concerning proper licensing, and before choosing and ordering frequencies. Information to User: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. Operation of this device is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Note: EMC conformance testing is based on the use of supplied and recommended cable types. The use of other cable types may degrade EMC performance. SHURE Incorporated http://www.shure.com United States, Canada, Latin America, Caribbean: 5800 W. Touhy Avenue, Niles, IL 60714-4608, U.S.A. Phone: 847-600-2000 U.S. Fax: 847-600-1212 Int’l Fax: 847-600-6446 Europe, Middle East, Africa: Shure Europe GmbH, Phone: 49-7131-72140 Fax: 49-7131-721414 Asia, Pacific: Shure Asia Limited, Phone: 852-2893-4290 Fax: 852-2893-4055
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : No Encryption : Standard V2.3 (128-bit) User Access : Print, Extract, Print high-res Page Count : 2 XMP Toolkit : XMP toolkit 2.9.1-14, framework 1.6 About : uuid:7b336ee8-ed6e-4a02-8240-9fd44be4ded7 Producer : Adobe PDF Library 8.0 Trapped : False Create Date : 2008:05:12 17:21:54-05:00 Metadata Date : 2008:05:15 11:28:36-05:00 Modify Date : 2008:05:15 11:28:36-05:00 Creator Tool : Adobe InDesign CS3 (5.0.2) Thumbnail Format : JPEG Thumbnail Width : 256 Thumbnail Height : 256 Thumbnail Image : (Binary data 10668 bytes, use -b option to extract) Instance ID : uuid:604a84c9-981e-471f-b82e-78c2f5334d39 Rendition Class : proof:pdf Document ID : adobe:docid:indd:a185c671-f6b3-11dc-9566-df088414d0ce Derived From Instance ID : a185c670-f6b3-11dc-9566-df088414d0ce Derived From Document ID : adobe:docid:indd:16204d36-c9e1-11dc-a17e-806c96074dbb Manifest Link Form : ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream Manifest Placed X Resolution : 72.00, 72.00, 72.00, 72.00, 72.00, 72.00, 72.00, 72.00, 72.00 Manifest Placed Y Resolution : 72.00, 72.00, 72.00, 72.00, 72.00, 72.00, 72.00, 72.00, 72.00 Manifest Placed Resolution Unit : Inches, Inches, Inches, Inches, Inches, Inches, Inches, Inches, Inches Manifest Reference Instance ID : uuid:0BB51F253EDBDC11809388AD0609DF71, uuid:a4e03a0e-a6a4-41f1-8dc6-cb2720a73f0f, uuid:AC589CF6ECEEDC119C71B6603DB1D45F, uuid:1F1701A452E1DC119A52FD98B9F71171, uuid:466CA41860CBDC11AC87FC606179B15C, uuid:206901357735DC1194AEDEF7FE02C1FF, uuid:2BF591894906DD119652DA16775AC11E, uuid:49e2a1de-5397-40f7-a158-1e58d05c8398, uuid:F07FCEB96B2EDC1185948431B213AD4D Manifest Reference Document ID : uuid:FFB50B2135DBDC11809388AD0609DF71, uuid:D1ECD97E19E6DC11A964CA030C8668D1, uuid:8B6D74ADCBE0DC119E65A170AB2CB07D, uuid:896D74ADCBE0DC119E65A170AB2CB07D, uuid:456CA41860CBDC11AC87FC606179B15C, uuid:612B51F5492EDC11808FEEE36C2789D2, uuid:A1C6478F1FC8DB11AA94F1FB977AD001, uuid:EF7FCEB96B2EDC1185948431B213AD4D Format : application/pdf Creator : Adobe InDesign CS3 (5.0.2)EXIF Metadata provided by EXIF.tools