Silex Technology OKILAN520W Wireless LAN Module User Manual
Silex Technology, Inc. Wireless LAN Module Users Manual
Users Manual
OkiLAN520w Users Manual December 09, 2011 OkiLAN520w Users Manual 1. Introduction/Overview 2. Block Diagram ...................................................2 ..................................................3 3. Hardware specifications ...................................................4 4.System Requirements ...................................................6 5.setup ...................................................6 6.Compliance ...................................................7 1/8 OkiLAN520w Users Manual 1.Introduction 本書は組込み型 Wireless BridgeTYPE-GJ1 について説明するものです。 OkiLAN520wについて説明しています。 This document describes about “embedded Wireless Bridge OkiLAN520w TYPE-GJ1. 2.Overview OkiLAN520w TYPE-GJ1 は Single Band IEEE802.11bgn 準拠のインテリジェントモジュールです。本モジュールは EU RoHS 指令 2009/95/EC(Lead Free)及び中国版 RoHS に適合しています。 本モジュールは MAC/BBP チップセット RTL8196C と RTL8188CE(Realtek 社)を採用しています。また、このモジュールは 1 ストリームの 11n システム及び 40MHz 帯域幅 モードをサポートしています。 OkiLAN520w TYPE-GJ1 is Single Band IEEE802.11bgn intelligent radio module. This module complies with EU RoHS Directive 2009/95/EC(Lead Free) and China RoHS with exemptions. This module has an MAC/BBP Chipset RTL8188CE (Realtek) internally. Also this module supports high speed one stream 11n technology and 40MHz band width mode. 機能 (Features): - IEEE802.11b/g/n 準拠(2.4GHz) IEEE 802.11b/g/n conformity (2.4GHz) - 1 ストリーム 1 x 1 11n システム及び 40MHz 帯域幅モード対応 (スループット理論値 150Mbps) Two stream 1 x 1 11n technology and 40MHz band width mode. (Throughput up to 150Mbps) - データレート 802.11b/g 1-54Mbps, 802.11n MCS0-15 対応 MCS0-7対応 Data rates of 1 - 54 Mbps for 802.11b/g and MCS0-15 802.11n. MCS0-7 for 802.11n - “Short Gard Interval”モード対応 Support “Short Gard Interval” mode. 2/8 RTL8196C and OkiLAN520w Users Manual 3.Block diagram DC/DC DC 5V in TRANS RJ45 LAN RTL8196C TRANS Realtek SoC RJ45 No use WAN PCIe RTL8188CE Realtek WLAN LED X 4(Not Populate) SW WPS/RESET FROM DDR 4MB 32MB 3/8 Chip Antenna 1X1 OkiLAN520w Users Manual 4-1.General specifications Item Specification Unit 電源コネクタ Power connector Micro B ( USB) - インターフェイス Device Interfaces IEEE802.3u 10/100BASE 2port - IEEE802.11b/g/n - 重さ Weight 13.8 寸法 Dimensions 54 x 37 x 18 MTBF 90,000 mm Note WAN、LAN port Typ W x H x D, PCB Thickness = 1.0mm * 7.項参照。See section 7. Min. 4-2.Environmental specifications Item Specification Unit 保存温度 Storage temperature -20 to +60 ℃ 保存湿度 Storage humidity Max 95% %RH 動作温度 Operating Temperature 0 to +55 ℃ 動作湿度 Operating humidity 10 to 90 %RH Item 電源電圧 Power supply voltage Specification Non condensing Ambient Non condensing Unit Min. Typ. Max. 4.75 5.0 5.25 4/8 Note Note 動作条件 Operating Conditions OkiLAN520w Users Manual 4-4.Radio configuration and general specifications Item Specification Unit Chipset SoC RTL8196C / WLAN RTL8188CE (Realtek) 中心周波数 Center frequency 11b 2412 – 2472 MHz 11g 2412 – 2472 MHz 11ng HT20 2412 - 2472 MHz 11ng HT40 2422 - 2462 MHz チャネル間隔 Channel spacing 11b/11g/11ng HT20/HT40 MHz 通信レート Rate スキームコード Scheme code 11b 1, 2, 5.5L, 5.5S, 11L, 11S Mbps 11g 6, 9, 12, 18, 24, 36, 48, 54 Mbps 11ng 1Stream MCS0, 1, 2, 3, 4, 5, 6, 7 - 11b DSSS(CCK,DQPSK,DBPS K) - 11g/11ng DSSS-OFDM (64QAM,16QAM,QPSK,BPS K) - 変調方式 Modulation type 5/8 Note - Ch.1~Ch.13 Ch.3~Ch.11 OkiLAN520w Users Manual 5. System Requirements (for the install) The configuration of this product uses a special protocol. The exhibition of those procedures is kept by contract. OS: Embedded Linux or Embedded windows PC H/W:Ethernet port is required 6. Setup TYPE-GJ1 connect to the Ethernet port of the END product. The END product can use the wireless LAN by setting it using a special protocol. EDN Product Ethernet 6/8 OkiLAN520w OkiLAN520w Users Manual 7. Compliance FCC ID:N6C-OKILAN520W IC No:4908A-OKILAN520W NOTICE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. This device complies with Part 15 of FCC Rules and Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of this device. Le présent appareil est conforme aux la partie 15 des règles de la FCC et CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65 and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment should be installed and operated keeping the radiator at least 20cm or more away from person’s body (excluding extremities: hands, wrists, feet and ankles). Cet équipement est conforme aux limites d’exposition aux rayonnements énoncées pour un environnement non contrôlé et respecte les règles les radioélectriques (RF) de la FCC lignes directrices d'exposition dans le Supplément C à OET65 et d’exposition aux fréquences radioélectriques (RF) CNR-102 de l’IC. Cet équipement doit être installé et utilisé en gardant une distance de 20 cm ou plus entre le dispositif rayonnant et le corps (à l’exception des extrémités : mains, poignets, pieds et chevilles). Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication. Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement d'une communication satisfaisante. 7/8 OkiLAN520w Users Manual This radio transmitter (identify the device by certification number, or model number if Category II) has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. Le présent émetteur radio (identifier le dispositif par son numéro de certification ou son numéro de modèle s'il fait partie du matériel de catégorie I) a été approuvé par Industrie Canada pour fonctionner avec les types d'antenne énumérés ci-dessous et ayant un gain admissible maximal et l'impédance requise pour chaque type d'antenne. Les types d'antenne non inclus dans cette liste, ou dont le gain est supérieur au gain maximal indiqué, sont strictement interdits pour l'exploitation de l'émetteur. Antenna information: Omni-directionalChip Antenna Peak Gain 0.5dBi FCC WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Manual and Product Labeling information To The End User The end user manual shall include all required regulatory information/warning as show in this manual. And when this module is installed in the host product, you must include a "Contain FCC ID : N6C-OKILAN520W" and a “Contain IC: 4908A-OKILAN520W” in the label of the host product. 8/8
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No Page Count : 8 Creator : Draw Producer : OpenOffice.org 3.3 Create Date : 2011:12:09 16:22:40+09:00EXIF Metadata provided by EXIF.tools