Sintai Optical RC03 Remote Controller-B User Manual

Sintai Optical (Shenzhen) Co., Ltd. Remote Controller-B

User Manual

Remote Control-BOptional Accessory for SP360 4K© 2016 JK Imaging Ltd. All Rights Reserved.JK Imaging Ltd., 17239 So. Main Street, Gardena, CA 90248 USAJK Imaging Europe, 71 Clarendon Road, Watford, WD17 1DS, UKhttp://kodakpixpro.comPrinted in ChinaVR369086099-0Functionality Overview:1. Signal Indicator Lamp2. Signal Test Button3. Recording / Shooting Switch *4. Battery / Memory Card Indicator Light5. Recording / Shooting Button6. Shooting Status Indicator Light7. External Antenna8. Battery CoverIndudes:- Remote Control-B- Part No. RR-BK02- Accessories Tool- Button Cell Battery CR2450- External Antenna- Wrist StrapSpecifications:• Dimensions: 47×48×13.7mm (excluding external antenna)• Weight: 27g (battery included, excluding external antenna)• Temperature: -10 to 40°C• Humidity: 0~90%• Battery: Button Cell CR2450ENBattery Installation:Open the battery cover plate with the included accessories tool in a counter clockwise direction. Insert the battery with the anode facing upward. Replace cover plate over battery and turn clockwise to lock into place.CR245016752348 Recording / Shooting Switch xed in Global Mode.*
Federal Communication Commission Interference StatementThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.- Consult the dealer or an experienced radio/TV technician for help.FCC Caution: Any changes or modications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Navigation menu