Skyrocket Toys 01942RX24G DASH Nano Drone User Manual 01942 SVNano Production Z

Skyrocket Toys LLC DASH Nano Drone 01942 SVNano Production Z

User Manual

LAUNCHAUTOMANUALFLYING MODERLLAUNCHLANDOFF ON01942FrontBAABPOWERING UP AND PAIRING REMOTE• Reset controller to factory settings: Hold F Trim, B Trim, and Power for 3 seconds.Forward/Back ward TrimPower Stunt ButtonAuto Mode IndicatorManual Mode IndicatorRotation TrimLeft/Right TrimFLIGHT BASICSPress LAUNCH to automatically launch a few feet off the ground.Move LEFT (Throttle) thumbstick up or down to make drone fly higher or lower and left or right to rotate.Use RIGHT (Directional) thumbstick to fly forward, backward, left or right.Press LAND to automatically land.Rotate LeftRotate RightUpDownFLIGHT CONTROLSONE TOUCH STUNTSFly RightFly LeftFly ForwardFly BackwardREPLACING DAMAGED BLADESAUTO AND MANUAL FLIGHT MODESUsing a fork or tool, gently pry the blade from the motor shaft.To make flying easier, place the drone on the ground in front of you with the drone facing away from you (green blades forward). You should be facing the same way the drone is facing.Turn on controller. (Before initial use, install new batteries into controller. See Rever se.) FLYING GUIDENANO DRONEDASHPlace the drone on level surface for calibration.RLAUTOMANUALFLYING MODELAUNCHLANDWhen LEDs turn solid, the drone is ready to fly. AUTO mode is best for new pilots. Begin by pressing the LAUNCH button for takeoff. The drone will hold its altitude, and gradually fly up or down when you press up or down on the left thumbstick.MANUAL mode is better for experienced pilots. When the left thumbstick is pushed all the way up the drone will spin its motors as fast as it can while maintaining stability, and when the left thumbstick is pushed all the way down the motors will stop spinning completely. Turn the drone on. (Be sure that drone is completely charged. See reverse.)NOTE: Once a stunt has been initiated, DO NOT adjust Throttle or press any other controls until the stunt has been completed.CAUTION!The drone should be flying at least 6 feet in the air with a minimum clearance of 6 feet in all directions before attempting stunt functions.FLIP IN 4 DIRECTIONS1 Bring the drone to a mid-air hover without flying in any direction. Remove finger from the RIGHT thumbstick. 2 While hovering, press and hold the STUNT button.3 Then quickly tap the RIGHT thumbstick in the direction you want the drone to flip. BARREL ROLL LEFT OR RIGHTWhile flying forward (or reverse), tap the STUNT button.RRLLAUNCHLANDRLAUTOMANUALFLIGHT MODELAUNCHLANDRLAUTOMANUALFLIGHT MODELAUNCHLANDFlight ModeLAUNCH/LAND BUTTONPRESS TO LANDPRESS TO LAUNCHIf for any reason you need to immediately stop the drone, hold down the stunt button (for drones that don't have a stunt button, use the video button) and move both thumbsticks down and away from the center of the controller.Alternatively you can use the left thumbstick to land the drone. Hold the left thumbstick all the way down for about 2.5 seconds after the drone has safely reached the ground, and the motors will stop spinning.To change the speed of the drone, hold STUNT, , and . The LED on the controller will blink once for slow, twice for medium, and three times for fast.
AAA BATTERY CAUTIONS• Do not use rechargeable batteries.• Different types of batteries or new and old batteries are not to be mixed.• Batteries are to be inserted using correct polarity.• Remove exhausted batteries as soon as possible and discard properly.• Remove all batteries from compartment if toy is not used for a long period of time.• Never throw batteries in a fire or attempt to open the outer casing.• Non-rechargeable batteries are not to be recharged.• The supply terminals are not to be short circuited.• Batteries should be replaced by an adult.WARNING:Batteries are harmful if swallowed. Please keep away from children.Battery Disposal: Dispose of batteries according to the local laws and regulations of your region. Some batteries may be recycled, and may be accepted for disposal at your local recycling center. If you are not able to identify the applicable rules in your area, please check the instructions of the battery manufacturer.THIS PRODUCT CONTAINS A LITHIUM-POLYMER BATTERY3.7V 100mAh:LiPo batteries have a severe risk of fire and injury if they are improperly handled or misused. They may explode, overheat or ignite.Read all following precautions and instructions regarding the care and use of LiPo batteries. The LiPo battery is only to be used with the drone and charger included with this product. • Keep away from flammable materials.• Do not expose to direct sunlight.• Do not place in fire or leave in hot places.• Do not drop or make subject to strong impact.• Keep dry and away from water.• Remove exhausted battery as soon as possible and discard properly.• Remove battery from the compartment if toy is not used for a long period of time.• The supply terminals are not to be short circuited.• Never throw battery in a fire or attempt to open outer casing.• Do not leave battery connected to drone when not in use.• Do not stress, press or drop the battery. • Never charge battery unattended. When charging battery you should always remain in constant observa-tion to monitor the charging process and react to potential problems that may occur. • Disconnect with the charging wire if the battery is fully charged. • Never store or charge battery inside the car in extreme temperatures, since extreme temperature could ignite fire. • Use caution to avoid puncture of the battery. Puncture of battery may cause a fire. LiPo Battery Disposal: LiPo batteries must be recycled or disposed of properly. They should not be disposed of with other household waste. Check your local laws and regulations for correct recycling and/or battery disposal. • Nano Drone• USB Charging Cable• Controller• 4 Replacement BladesBefore each use, an adult should check this product and the LiPo battery to ensure no damage or hazards exist. Drone has rotating blades that move at high speed, posing danger of damage and injury. Pilots are responsible for any actions that result in damage or injury from the improper operation of drone. Adequate flying space is required. Avoid flying near interior fans and/or vents as they may make flying difficult to control. Keep a safe distance away from streets, public thoroughfares and power lines. Never attempt to retrieve drone from any location higher than your reach (such as rooftops or trees) or from any location that poses a safety hazard. Never fly drone at night. Keep drone in sight at all times during operation. Discontinue operation immediately if drone flies out of your field of view. Do not fly near spectators or animals. Keep spinning rotors away from fingers, hair, eyes and other body parts. Always launch from a flat surface. Never leave drone unattended while it is turned on. Read all enclosed information before operating.ADULT SUPERVISION REQUIRED3 x1.5 V AAA (LR03)_ AAA/LR03/R03 1.5V +_ AAA/LR03/R03 1.5V ++ AAA/LR03/R03 1.5V _INSTALLING BATTERIES IN THE CONTROLLER CHARGING THE DRONECHARGING PRECAUTIONS:• After use, allow drone (battery on bottom) to cool down to room temperature before charging again.• Charge battery in an isolated area, away from excessive heat or moisture.• If you suspect that the battery is damaged or swelling, discard the battery in accordance with your country’s recycling laws.• Do not modify, heat, or wet the battery in any way. Only recharge with provided charger.Red light = chargingGreen light = fully chargedWE’RE HERE TO HELPOnline Video Instructions & Flying Tips available now at SKYVIPER.COMFor questions about this product:Online: skyviper.com/supportEmail: support@skyrockettoys.comPhone: 1-888-674-5650M-F 9am to 6pm PST*Screwdriver not included. *Batteries not included.TRIM ADJUSTMENTS IF THE DRONE DRIFTS FORWARD: Press "B" button several times until the drone stops drifting forward.IF THE DRONE DRIFTS BACKWARD: Press "F" button several times until the drone stops drifting backward.IF THE DRONE DRIFTS LEFT: Press "R" button several times until the drone stops drifting left.IF THE DRONE DRIFTS RIGHT: Press "L" button several times until the drone stops drifting right.IF THE DRONE SPINS COUNTER-CLOCK-WISE (VIEWED FROM ABOVE): Press the button several times until the drone stops spinning.IF THE DRONE SPINS CLOCKWISE (VIEWED FROM ABOVE): Press the button several times until the drone stops spinning.Computer or charging block.Insert charging cable.Turn the drone off.MAINTENANCENANO DRONEDASHOFF ONFAILSAFE GUIDEWhen the drone's battery is depleted, the drone will automatically land itself in its current position. This automatic landing cannot be interrupted with the controller.When the drone's battery is at 10% or less, the LEDs on the drone will begin to blink rapidly until the drone is turned off.If the drone detects that no input has been received by the controller for 15 seconds, the drone will automatically land itself in its current position.When the drone goes out of range of the controller, it will automatically land itself in its current position. If the controller comes back into range before the drone lands, it is possible to cancel this automatic landing by pressing up on the left thumbstick.When the drone turns upside down, the motors will stop spinning.To change the speed of the drone, hold STUNT, , and . The LED on the controller will blink once for slow, twice for medium, and three times for fast.CONTENTSIf one or more of your drone's propellers will not spin, check for foreign objects on or around the motor and propeller. Remove the propeller with a fork or tweezers, clear debris, and then replace the propeller. Do not use excessive force when putting the propeller on the motor.Propellers Not Spinning?When the controller is OFF, press and hold the flight mode button, LAUNCH/LAND button, and POWER button for three seconds to toggle between mode 1 and mode 2.Mode 2 (default, most commonly used)LEFT thumbstick makes the drone go up/down, and rotate clockwise/counter-clockwise. RIGHT thumbstick makes the drone fly forward, backward, left, and right.Mode 1 (used in Australlia and most Asian & European countries)LEFT thumbstick makes the drone fly forward/backward, and rotateclockwise/counter-clockwise. RIGHT thumbstick makes the drone go up/down, and fly left and right.CONTROLLER MODE SET-UPTIPS:#1: When the controller LED flashes 3 times quickly, the trim is at middle of trim range.#2: If you are uncomfortable trimming the drone in flight, you can land onto a flat surface and make your trim adjustments.#3: To reset trim adjustments, hold theand the buttons down for 2 seconds.RGoogle Play and the Google Play logo are trademarks of Google Inc.Apple and the Apple logo are trademarks of Apple Inc., registered in the U.S. and other countries. App Store is a service mark of Apple Inc., registered in the U.S. and other countries.©2018 Skyrocket LLC, Los Angeles CA 90066 USA. All Rights Reserved. Sky Viper and Skyrocket and their respective logos are trademarks and/or registered trademarks of Skyrocket Toys LLC. All other trademarks, logos and copyrights are the property of their respective owners, and there is no relationship express or implied with Skyrocket Toys LLC.MADE IN CHINA.Remove all packaging attachments before giving the toy to a child.Not suitable for children under 3 years due to small parts that could be swallowed. Conforms to product safety standards ASTM F963. Keep instructions for future reference. Do not discard. This device complies with PART 15 of the FCC Rules. Operation is subject to the following two conditions. (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION: Changes or modifications to this unit not expressly approved by the party responsiblefor compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna - Increase the separation between the equipment and receiver - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected - Consult the dealer or an experienced radio/TV technician for help.This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.For Drone：This equipment should be installed and operated with minimum distance 20cm between the radiator& your body.When you use Spiderman Remote on hand, please keep 20cm from your body.
When you use Spiderman Remote on hand, please keep 20cm from your body.
Lorsque vous utilisez Spiderman Remote en main, gardez 20 cm de votre corps.

Navigation menu