Somfy Systems TELIS1 Remote Control Transmitter User Manual FCC Statement

Somfy Systems Remote Control Transmitter FCC Statement

Contents

User Manual

INSTALLATION guide-Telis 11. Characteristics:•  Power: 3V lithium battery, CR 2430•  Operating Temperature: +5°C to +40°C•  Range: Minimum 90’•  Battery Life: 3 years assuming 4 operations per day2. Programming:•  While the RTS motor is in programming mode, pressthe PROG button located on the back of thetransmitter.•  A series of three beeps will be heard from the RTSmotor indicating the RTS motor has beensuccessfully programmed.•  Press the PROG button on the transmitter to exit theprogramming mode.3. Operation:•  Press the UP, STOP, or DOWN button for desiredoperation.•  During transmission, the LED on the front of thetransmitter will illuminate. If it doesn’t replace thebattery.
 Hand Held Transmitters (1810632, 1810643, 1810639, 1810650)  FCC Information  This device complies with Part 15 of the FCC Rules.  Operation is subject to the following two conditions: 1.  This device may not cause harmful interference, and 2.  This device must accept any interference received, including interference that may cause undesired operation.                Warning Changes or modifications not expressly approved buy the manufacturer could void the user’s authority to operate the equipment.   Note: This equipment has been tested and found to comply with the limits for a CLASS B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:  1.1 Reorient or relocate the receiving antenna. 1.2 Increase the separation between the equipment and receiver. 1.3 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 1.4 Consult the dealer or experienced radio/TV technician for help.

Navigation menu