Sony Engineering FFS-U RF glow-stick receiver User Manual FFS R
Sony Engineering Corporation RF glow-stick receiver FFS R
User Manual
![](/img.php?id=2288467&img=bg1.png)
4-545-184-01(1)
FreFlow® Instruction Manual
4-545-184-01(1)
©2014 Sony Engineering Corporation Printed in Japan
Before operating the product, please read this manual
thoroughly and retain it for future reference.
Design and specifications are subject to change without notice.
Information
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
You are cautioned that any changes or modifications not
expressly approved in this manual could void the user’s
authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
help.
Notes on Use
Do not put small parts or batteries in your mouth. Doing so
may lead to choking or serious injury.
Keep out of reach of children as there is a risk of choking or
serious injury due to accidental swallowing.
If batteries are swallowed, seek medical treatment
immediately.
Material leaked from batteries getting in the eyes, on skin, or
on clothing may lead to loss of sight or other injury. Flush any
battery material with large volumes of water, and consult a
physician.
Do not look into the light from the product or shine it directly
at eyes. Doing so may lead to vision disorders.
Do not disassemble or modify the product. Doing so may lead
to fire, injury, etc.
The product is not waterproof. Do not allow it to get wet nor
use it in water. Doing so may lead to electrical shock or
damage to the product.
Do not apply strong impact or swing the product around.
Doing so may lead to injury or damage to the product.
Do not use the product if malfunctioning or damaged. Doing
so may lead to shock or injury.
Immediately remove the batteries and discontinue use if...
the product is dropped or subjected to an impact in which
the interior is exposed.
the product emits a strange smell, heat, or smoke.
When dirty, this unit may be cleaned with a clean, dry cloth.
Do not allow this unit to come in contact with alcohol or other
chemicals.
Signal reception may be impaired in some wireless operating
environments.
If you feel ill while using the product, turn off the power and
discontinue use.
How to Use
Pull out insulation sheet.
Insulation sheet
Slide to power switch to the ON position, to turn on the light.
It may take a few seconds to light up.
Color change buttonPower switch
The light color set will change each time the color change
button is pressed.
![](/img.php?id=2288467&img=bg2.png)
4-545-184-01(1)
Operation With a FreFlow® Wireless System
Wait with the power switch set to ON. You do not need to
make any special operations. Operation will start
automatically when a wireless signal is received.
Light color will change by wireless command only in a venue
where a FreFlow® wireless system is set up.
Light color cannot be changed by the color change button
while a wireless signal is being received.
When a wireless signal is no longer received, you can
operate the product as you like.
How to Replace Batteries
Push the tab in the direction indicated by the arrow, and
remove the battery box cover.
Tab Cover
Insert the batteries, making sure the + and – terminals are in
the correct direction, and close the cover securely.
<Improper use of batteries may lead to leaking,
excessive heating, rupture, or damage. Please follow
the cautions below.>
Set the batteries with the + and – terminals in the correct
direction.
Remove the batteries when they are depleted or when not
using for a long period of time.
Do not use or leave in places with intense direct sunlight or in
hot locations such as a car in the sun.
Use new batteries when replacing the batteries. Do not mix
with old batteries, different types of batteries, etc.
Do not subject batteries to fire or high temperatures.
Tape over battery contacts to avoid short-circuit when
disposing of batteries, and follow local regulations for battery
disposal.
Specifications
Model Name: FFS-R series
Materials
Grip, cover: ABS / Cylinder: PET
Power Requirement
Two size AAA (LR03) alkaline batteries: 3.0 V DC
MADE IN VIETNAM
[For inquires]
Antinos Management America, Inc.
freflow.service@amaa-us.com
FreFlow® and its logo are trademarks or registered trademarks of
Sony Engineering Corporation.