Sony NSZGT1 INTERNET TV BOX User Manual NSZ GT1

Sony Corporation INTERNET TV BOX NSZ GT1

Users Manual 2

NSZ-GT14-196-880-11(1)C:\work\btv\ReferenceGuide\Eagle\4196880111\4196880111BDP\010COV.fmmasterpage:Right© 2010 Sony Corporation4-196-880-11(1)Reference GuideNSZ-GT1010COV.book Page 1 Friday, April 16, 2010 5:39 PM
2NSZ-GT14-196-880-11(1)C:\work\btv\ReferenceGuide\Eagle\4196880111\4196880111BDP\020WAR.fmmasterpage:LeftTo reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.Batteries or batteries installed apparatus shall not be exposed to excessive heat such as sunshine, fire or the like.CAUTIONThe use of optical instruments with this product will increase eye hazard. As the laser beam used in this INTERNET TV BOX is harmful to eyes, do not attempt to disassemble the cabinet. Refer servicing to qualified personnel only.This label is located on the laser protective housing inside the enclosure.This symbol is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.These graphical symbols are located on the AC adaptor.NOTEThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:– Reorient or relocate the receiving antenna.– Increase the separation between the equipment and receiver.– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.– Consult the dealer or an experienced radio/TV technician for help.Precautions• To prevent fire or shock hazard, do not place objects filled with liquids, such as vases, on the apparatus.• The set is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the set itself has been turned off.• Install this unit so that the AC power cord can be unplugged from the wall socket immediately in the event of trouble.• The nameplate is located on the bottom of the unit.Installing• Do not install this equipment in a confined space, such as a bookshelf or similar unit.FCC WARNINGYou are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment.This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.The shielded Interface cable (LAN cable) must be used with the equipment in order to comply with the limits for a digital device pursuant to Subpart B of Part 15 of FCC Rules.FCC Radiation Exposure Statement:This equipment complies with FCC radiation exposure limits set forth for uncontrolled equipment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65. This equipment should be installed and operated with at least 20 cm and more between the radiator and person's body (excluding extremities: hands, wrists, feet and ankles).When using the unit, use indoors.Contains FCC ID : AK8NSZGT1WARNINGOperation is subject to the following two conditions;(1) this device may not cause interference, and(2) this device must accept any interference received,including interference that may cause undesired operation of the device.010COV.book Page 2 Friday, April 16, 2010 5:39 PM
3NSZ-GT14-196-880-11(1)C:\work\btv\ReferenceGuide\Eagle\4196880111\4196880111BDP\020WAR.fmmasterpage:RightImportant Safety Instructions1) Read these instructions.2) Keep these instructions.3) Heed all warnings.4) Follow all instructions.5) Do not use this apparatus near water.6) Clean only with dry cloth.7) Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.9) Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.10) Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.11) Only use attachments/accessories specified by the manufacturer.12) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.13) Unplug this apparatus during lightning storms or when unused for long periods of time.14) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.010COV.book Page 3 Friday, April 16, 2010 5:39 PM
4NSZ-GT14-196-880-11(1)C:\work\btv\ReferenceGuide\Eagle\4196880111\4196880111BDP\020WAR.fmmasterpage:1C LeftSpecificationsGeneralPower requirements AC adaptor: 120 V AC, 1.0 A, 60 Hz(the unit: DC 19.5 V, xx A)Power button symbol [/1 (on/standby)Turns on the unit, or sets to standby mode.010COV.book Page 4 Friday, April 16, 2010 5:39 PM
NSZ-GT14-196-880-11(1)C:\work\btv\ReferenceGuide\Eagle\4196880111\4196880111BDP\020WAR.fmmasterpage:Blank010COV.book Page 5 Friday, April 16, 2010 5:39 PM
NSZ-GT14-196-880-11(1)C:\work\btv\ReferenceGuide\Eagle\4196880111\4196880111BDP\030BCO.fmmasterpage:RightPrinted in China4-196-880-11(1)010COV.book Page 6 Friday, April 16, 2010 5:39 PM

Navigation menu