Contents
Users Manual 2
NSZ-GT1
4-196-880-11(1)
C:\work\btv\ReferenceGuide\Eagle\4196880111\4196880111BDP\010CO
V.fm
masterpage:Right
© 2010 Sony Corporation
4-196-880-11(1)
Reference Guide
NSZ-GT1
010COV.book Page 1 Friday, April 16, 2010 5:39 PM
2
NSZ-GT1
4-196-880-11(1)
C:\work\btv\ReferenceGuide\Eagle\4196880111\4196880111BDP\020WA
R.fm
masterpage:Left
To reduce the risk of fire or electric shock, do
not expose this apparatus to rain or moisture.
Batteries or batteries installed apparatus shall
not be exposed to excessive heat such as
sunshine, fire or the like.
CAUTION
The use of optical instruments with this product
will increase eye hazard. As the laser beam used
in this INTERNET TV BOX is harmful to eyes,
do not attempt to disassemble the cabinet. Refer
servicing to qualified personnel only.
This label is located on the laser protective
housing inside the enclosure.
This symbol is intended to alert
the user to the presence of
uninsulated “dangerous voltage”
within the product’s enclosure that
may be of sufficient magnitude to
constitute a risk of electric shock to persons.
This symbol is intended to alert
the user to the presence of
important operating and
maintenance (servicing)
instructions in the literature
accompanying the appliance.
These graphical symbols are located on the AC
adaptor.
NOTE
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the
equipment and receiver.
– Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
– Consult the dealer or an experienced radio/
TV technician for help.
Precautions
• To prevent fire or shock hazard, do not place
objects filled with liquids, such as vases, on
the apparatus.
• The set is not disconnected from the AC
power source (mains) as long as it is
connected to the wall outlet, even if the set
itself has been turned off.
• Install this unit so that the AC power cord can
be unplugged from the wall socket
immediately in the event of trouble.
• The nameplate is located on the bottom of the
unit.
Installing
• Do not install this equipment in a confined
space, such as a bookshelf or similar unit.
FCC WARNING
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate this
equipment.
This transmitter must not be co-located or
operated in conjunction with any other antenna
or transmitter.
The shielded Interface cable (LAN cable) must
be used with the equipment in order to comply
with the limits for a digital device pursuant to
Subpart B of Part 15 of FCC Rules.
FCC Radiation Exposure
Statement:
This equipment complies with FCC radiation
exposure limits set forth for uncontrolled
equipment and meets the FCC radio frequency
(RF) Exposure Guidelines in Supplement C to
OET65. This equipment should be installed and
operated with at least 20 cm and more between
the radiator and person's body (excluding
extremities: hands, wrists, feet and ankles).
When using the unit, use indoors.
Contains FCC ID : AK8NSZGT1
WARNING
Operation is subject to the following two
conditions;
(1) this device may not cause interference,
and
(2) this device must accept any interference
received,
including interference that may cause
undesired operation of the device.
010COV.book Page 2 Friday, April 16, 2010 5:39 PM
3
NSZ-GT1
4-196-880-11(1)
C:\work\btv\ReferenceGuide\Eagle\4196880111\4196880111BDP\020WA
R.fm
masterpage:Right
Important Safety
Instructions
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings.
Install in accordance with the
manufacturer’s instructions.
8) Do not install near any heat sources such
as radiators, heat registers, stoves, or
other apparatus (including amplifiers)
that produce heat.
9) Do not defeat the safety purpose of the
polarized or grounding-type plug. A
polarized plug has two blades with one
wider than the other. A grounding type
plug has two blades and a third
grounding prong. The wide blade or the
third prong are provided for your safety.
If the provided plug does not fit into your
outlet, consult an electrician for
replacement of the obsolete outlet.
10) Protect the power cord from being
walked on or pinched particularly at
plugs, convenience receptacles, and the
point where they exit from the apparatus.
11) Only use attachments/accessories
specified by the manufacturer.
12) Use only with the cart, stand, tripod,
bracket, or table specified by the
manufacturer, or sold with the apparatus.
When a cart is used, use caution when
moving the cart/apparatus combination
to avoid injury from tip-over.
13) Unplug this apparatus during lightning
storms or when unused for long periods
of time.
14) Refer all servicing to qualified service
personnel. Servicing is required when
the apparatus has been damaged in any
way, such as power-supply cord or plug
is damaged, liquid has been spilled or
objects have fallen into the apparatus,
the apparatus has been exposed to rain or
moisture, does not operate normally, or
has been dropped.
010COV.book Page 3 Friday, April 16, 2010 5:39 PM
4
NSZ-GT1
4-196-880-11(1)
C:\work\btv\ReferenceGuide\Eagle\4196880111\4196880111BDP\020WA
R.fm
masterpage:1C Left
Specifications
General
Power requirements AC adaptor: 120 V AC, 1.0 A, 60 Hz
(the unit: DC 19.5 V, xx A)
Power button symbol [/1 (on/standby)
Turns on the unit, or sets to standby mode.
010COV.book Page 4 Friday, April 16, 2010 5:39 PM
NSZ-GT1
4-196-880-11(1)
C:\work\btv\ReferenceGuide\Eagle\4196880111\4196880111BDP\020WA
R.fm
masterpage:Blank
010COV.book Page 5 Friday, April 16, 2010 5:39 PM
NSZ-GT1
4-196-880-11(1)
C:\work\btv\ReferenceGuide\Eagle\4196880111\4196880111BDP\030BC
O.fm
masterpage:Right
Printed in China
4-196-880-11(1)
010COV.book Page 6 Friday, April 16, 2010 5:39 PM