Southco P310X Proximity reader User Manual J EA P3 01 M revA
Southco,. Inc Proximity reader J EA P3 01 M revA
Southco >
user manual
EA-P3 Proximity Reader Operating Instructions Package Contents Status LED The EA-P3-101 has on bi-color (red/green) LED to indicate status. EA-P3-01x Proximity Reader Wire Harness Mounting Screws (x2) User Instructions When power is first applied to the reader, the LED will turn red, blink green three times, then stay red. When a compatible prox card is presented to the reader, the LED will blink green once. EA-P3-101 Proximity Reader Weigand Output Signals The EA-P3-101 reader is capable of reading 26-bit 125kHZ FSK proximity cards. When a card is presented to the reader, the reader will convert the user card ID to Weigand format. The timing of the Weigand outputs is shown in the figure below: Data 1 Data 0 Features 2ms LED and buzzer indicators 26-bit Weigand output For indoor use only NOTE: The Weigand signals must be pulled high to a voltage level compatible with the controller connected to the EA-P3-101. Wire Harness Pinout Specifications Power: Transmit Frequency : Card Reading Range: Operating Temperature: Operating Humidity: Dimensions: 50ms 12VDC ± 10% 60mA maximum (no attached devices) 125kHz FSK up to 10 cm (depending on installation) 0-50 °C 20-90% RH, No condensation 94 mm x 43 mm x 15 mm Reader Mounting and Installation Please refer to Southco trade drawing J-EA-P3-01 for mounting and installation details. pin # wire color Red Black White Green Yellow Brown Orange Blue function VCC (12VDC) GND Data 1 Data 0 GND no function no function no function CAUTION: Product can be damaged if wired incorrectly. Follow wiring diagram above. For technical support of this product contact: info@southco.com or visit: www.southco.com This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the installation, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio / TV technician for help You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: 1) 2) This device may not cause harmful interference and This device must accept any interference received, including interference that may cause undesired operation. J-EA-P3-01-M_revA visit www.southco.com for latest version of this document Page 1 of 1
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No Creator : Microsoft Word - J-EA-P3-01-M_revA.doc Producer : ScanSoft PDF Create! 4 Create Date : 2011:05:03 11:53:13-05:00 Modify Date : 2011:05:03 11:53:14-05:00 Author : bargeb Title : Microsoft Word - J-EA-P3-01-M_revA.doc Page Count : 1 Page Mode : UseNone Page Layout : OneColumnEXIF Metadata provided by EXIF.tools