Spectralink RFP4-1G9 Kirk Base Station 1.9 GHz User Manual KIRK BS 1G9 141432 qxp

Spectralink Corporation Kirk Base Station 1.9 GHz KIRK BS 1G9 141432 qxp

Manual

KIRK Base Station 1.9 GHzUser s GuideKIRK_BS_1G9_141432.qxp 03-08-2005 12:35 Side 1
1IntroductionThe base st ation is only intended for use with a wire -less server . The base st ation is not intended to beconnected directly to the PSTN network. The basest ation is designed with two internal antennas andsupport s antenna diversity. The base station is alsoable to carry out handover between the RF channelsunder the same base st ation, and handles four wire -less speech channels simult aneously. The base st ati -on is able to frame synchronise with other base st ati -ons under the same Wireless Server.T ransmission lenght is up to 1.2 miles on a twistedp air (in one building), e.g. cat.4, between the basest ation and wireless server . The base st ation is alsopower supplied from this connection (maximum sup -ply 1.5 W). The radius of coverage is up to 1960 feetwith a handset in free sight. It is possible to connecta maximum of 8 base st ations to a wireless serverwithout an exp ansion board, 16 base st ations with anexpansion board and 32 with a linked solution.2 Inst allationFirst you have to determine where to inst all the basest ation to have the right coverage. The averagecoverage within buildings is 246 feet. The coveragedepends on the construction of the building, archite -cture and choice of building material. Y ou may haveto use the base st ation coverage determination kit(Diagnostic Tooll) to optimize your inst allation. ThisDiagnostic Tool, consist s of a base st ation which hasno need for a wireless server . It can easily bemoved around in the building and 1 to 8 handset scan be connected.Pull the a/b wire from your inst allation through thewall suspension and then mount the wall suspensionon the wall.Connect the a/b wire to the plug at the rear of thebase st ation, using the 2 inner connectors of theplug.KIRK_BS_1G9_141432.qxp 03-08-2005 12:35 Side 2
If you need to remove the base st ation please sep a-rate it from the wall suspension with a gentle push ofa screwdriver.Click the base st ation on to the wall suspension.Af ter the wireless server is powered up again a cablelenght measurement is needed in order to find thecorrect Cable Delay Value (CDV).NOTE! Cable dimensions min. as A WG 26.KIRK_BS_1G9_141432.qxp 03-08-2005 12:35 Side 4
Important Safety Instructions and Product Infor -mationBefore using your telephone equipment, you shouldalways follow basic safety instruction to reduce therisk of fire, electrical shock and injury to persons,and damage to property.1Read and understand all instructions2Follow all warnings and instructions includingthose marked on the product3Unplug this product before cleaning. Do not useliquid cleaners or aerosol cleaners. Use dampcloth for cleaning4Do not inst all the telephone equipment in thebathroom or near a wash bowl, kitchen sink, orlaundry tub, in a wet basement, or near a swim -ming pool5Slot s or openings in the cabinet back and bot-tom of the equipment are provided for ventilationto protect it from over-heating. These openingsmust not be blocked or covered. 6The product should be operated only from thetype of power source indicated on the instruc-tions. If you are not sure of the type of powersupply, consult your dealer or local power com -pany.7Do not overload wall outlet s and extension cordsas this can result in fire or electrical shock.8Never push object s of any kind into this productthrough cabinet slot s as they may touch danger -ous volt age point s or short out p art s that couldresult in fire, electrical shock, or injury . Neverspill liquid of any kind into this product.9 T o reduce the risk of electrical shock or burns,do not disassemble this product. Opening orremoving covers may expose you to dangerousvolt ages, dangerous electrical current, or otherrisks. Incorrect reassemble can cause electricalshock when the appliance is subsequently used.If the product need rep air , consult your dealer .10 Refer servicing to qualified service personnelunder the following conditions:KIRK_BS_1G9_141432.qxp 03-08-2005 12:35 Side 6
AQ If liquid has been spilled into the productBQ If the product has been exposed to rain or waterCQ If the product does not operate normally whenfollowing the operating instructions in the manu -al. Adjust only those controls that are coveredby the operation instructions. Improper adjust -ment of other controls may result in damage andwill of ten require extensive work by qualified ser -vice personnel to restore the product to normaloperation.DQ If the product has been dropped or cabinet hasbeen damagedEQ If the product exhibit s a distinct change in per -formance11 A void using telephone during an electricalstorm. There may be a risk of electrical shockfrom lightning12 Do not use the telephone to report a gas leak inthe vicinity of the leak13 Do not place the unit near microwave ovens,radio equipment, or non-ground connected tele -visions. These appliances may cause electricalinterference to the base or handset14 The unit must be inst alled on a hard, plane sur -face and connected to a functional 120 volt ACpower net adapter and plug the adapter into thepower outlet15 The system will not operate in the event of ablackout. Please keep a backup phone for emer -genciesIntrinsic safetyDo not inst all the unit in conditions where there is adanger of electrically ignited explosions.Exposure to sunlight, heat and moistureDo not expose the unit to direct sunlight for longperiods. Keep away from excessive heat and moisture.S p are p art s and accessoriesUse only approved sp are p art s and accessories. Theoperation of non-approved p art s cannot be guarante -ed and may even cause damage. KIRK_BS_1G9_141432.qxp 03-08-2005 12:35 Side 8
Power failureIn the event of a power failure, you cannot use thewireless solution to make or receive callsNOTICESNOTICE: Before inst alling this equipment, users sho -uld ensure that it is permissible to be connected tothe facilities of the local telecommunications comp a -ny. The equipment must also be inst alled using anaccept able method of connection. The customer sho -uld be aware that compliance with the above conditi -ons may not prevent degradation of service in somesituations.Repairs to certified equipment should be coordinatedby a represent ative designated by the supplier . Anyrep airs or alterations made by the user to this equi -pment, or equipment malfunctions, may give the tele -communications company cause to request the userto disconnect the equipment.Users should ensure for their own protection that theelectrical ground connections of the power utility,telephone lines and internal met allic water pipesystem, if present, are connected together. This pre -caution may be p articularly import ant in rural areas.CAUTIONS: Users should not attempt to make suchconnections themselves, but should cont act theappropriate electric inspection authority, or electrici -an, as appropriate.If your telephone equipment causes harm to the tele -phone network, the telephone operator may ask youto disconnect the system from the line until the pro -blem has been corrected or they may discontinueyour service temporarily. If possible, they will notifyyou in advance, But if advance notice is not practi -cal, you should be notified as soon as possible. Y ouwill be informed of your right to file a complaint withthe FCC.Your telephone operator may make changes in it sfacilities, equipment, operations, or procedures thatcould af fect the proper functioning of your telephonesystem, If they do and it is possible, you will be noti -fied in advance to give you an opportunity to maint a -KIRK_BS_1G9_141432.qxp 03-08-2005 12:35 Side 10
in uninterrupted telephone service. If you experiencetrouble with this telephone system, disconnect it fromthe network until the problem has been corrected oruntil you are sure that the equipment is not malfu -nctioning.Note: This equipment has been tested and found tocomply with the limit s for a class B digit al device,pursuant to Part 15 of the FCC Rules. These limit sare designed to provide reasonable protection aga -inst harmful interference in a residential inst allation.This equipment generates, uses and can radiateradio frequency energy and, if not inst alled and usedin accordance with the instructions, may causeharmful interference to radio communications.However, there is no guarantee that interference willnot occur in a p articular inst allation. If this equipmentdoes cause harmful interference to radio or televisionreception, which can be determined by turning theequipment of f and on, the user is encouraged to tryto correct the interference by one or more of the fol -lowing measures:- Reorient or relocate the receiving antenna.- Increase the seperation between the equiomentand receiver.- Connect the equipment into an outlet on a circuitdif ferent from that to which the receiver is connec-ted.- Consult the dealer or an experienced radio/TVtechnician for help.Power Outage: In the event of a power out age, yourcordless telephone will not operate. The cordlesstelephone requires electricity for operation. Y ou sho -uld have a telephone which does not require electri -city available for use during power out ages.Information to user: The users manual or instructi -on manual for an intentional or unintentional radiatorshall caution the user that changes or modificationsnot expressly approved by the p arty responsible forcompliance could void the user s authority to operatethe equipment.KIRK_BS_1G9_141432.qxp 03-08-2005 12:35 Side 12
LIMITED WARRANTYThis limited, non-transferable warranty is provided tothe original purchaser . The product is warranted tobe free from defect s in materials and workmanshipunder normal inst allation, use and service for a peri -od of one (1) year from the date of purchase asshown on the purchaser s receipt. Our obligation under this warranty is limited to rep airor replacement (at our option) of the product or anyp art(s) which are defective provided that the productis returned to the original place of purchase or anauthorized service location during the warranty peri -od. Product s returned must be accomp anied by acopy of the purchase receipt. In the absence of apurchase receipt, the warranty period shall be one(1) year from the date of manufacture. Rep air orreplacement of the product is your sole and exclusi -ve remedy.If the product is rep aired, reconditioned componentpart s or materials may be used. If the product isreplaced, we may replace it with a new or reconditio -ned product of the same or similar design. The rep ai -red product will be warranted for either (a) 90 days or(b) the remainder of the original one (1) year warrantyperiod, whichever is longer .This warranty does not apply to the defect s out side ofour control, including but not limited to act s of God,fire, flood and damage while in transit to service facili -ty . W e do not warranty that the product will be comp a -tible with any telephone equipment, systems or p artylines.This warranty shall be void of the product is damagedas a result of defacement, misuse, abuse, neglect,accident, destruction or alteration of the serial num -ber , improper electrical volt ages or current s, rep air ,alteration or maintenance by any person or p artyother than our authorized service facility , or any viola -tion of instructions furnished by us.This warranty is also void if this product is removedfrom the country in which it was purchased by the ori -ginal purchaser, if it is used in a country in which it isKIRK_BS_1G9_141432.qxp 03-08-2005 12:35 Side 14
not registered for use, or if it is used in a country forwhich it was not designed. Due to variations in tele -phone systems and communications laws, this pro -duct may be illegal for use in some countries. W eassume no responsibilities for damages or penaltiesincurred resulting from the use of this product in amanner or location other than that for which it wasintended. THIS LIMITED WARRANTY IS IN LIEU OF ALLOTHER WARRANTIES EXPRESS OR IMPLIED.ANY IMPLIED WARRANTIES INCLUDING BUTNOT LIMITED TO THE IMPLIED WARRANTIES OFMERCHANTABILITY AND FITNESS FOR A PARTI -CULAR PURPOSE, SHALL BE LIMITED TO THEDURATION OF THIS WRITTEN LIMITED WARRAN-TY. WE DISCLAIM ANY LIABILITY FOR DAMAGESFOR LOSS OF USE OF THE PRODUCTS, LOSSOF TIME, INCONVENIENCE, INJURY TO ANYPERSON, OR DAMAGE TO PROPERTY CAUSEDBY THE PRODUCT, LOSS OF REVENUE OR PRO-FIT OR DAMAGES FOR ANY FAILURE TO PER-FORM. IN NO EVENT SHALL WE BE LIABLE FORANY SPECIAL, INCIDENTAL, PUNITIVE OR CON-SEQUENTIAL DAMAGES EVEN IF WE ARE ADVI-SED OF THE POSSIBILITY OF SUCH DAMAGES.Some states do not allow limit ations on how long animplied warranty last s, so the above limit ations maynot apply to you.This warranty is the sole and exclusive warranty pro -vided for the product. There are no other expresswarranties. This warranty gives you specific legal rig -ht s, and you may also have other right s, which varyfrom st ate to st ateThe product must not be disposed of with unsortedwaste, but must be collected sp aretelyKIRK_BS_1G9_141432.qxp 03-08-2005 12:35 Side 16
Appropriate RF safty/inst allationinformation The Base Station is intended to be inst alled byauthorized personal. The Base Station shall beinst alled in accordance with FCC rules. The Base Station shall be placed at a location insuch way, that there is at least 20 centimetresbetween the base transmitter and the users bodyor any other nearby persons.The product must not be disposed of with uns -orted waste, but must be collected sep arately .KIRK_BS_1G9_141432.qxp 03-08-2005 12:35 Side 18
141432-HD, ed.1 . Reklame & Tryk A/S . 75 50 26 66KIRK telecom A/SLangmarksvej 34 • DK-8700 Horsens • DenmarkTlf. +45 7560 2850 • Fax +45 7560 2851kirk@kirktelecom.comwww.kirktelecom.comKIRK_BS_1G9_141432.qxp 03-08-2005 12:35 Side 20

Navigation menu