Spectralink RFP5-1G9 KIRK basestation User Manual Basestation KIRK1G8 1G9 2G4

Spectralink Corporation KIRK basestation Basestation KIRK1G8 1G9 2G4

UserMan

Polycom® KIRK® Base Station 1.8/1.9 GHzUser Guide
1 IntroductionThe base station is only intended for use with a wireless server. The base station is not intended to be connected directly to the PSTN network. The base station is designed with two internal antennas and supports antenna diversity. The base station is also able to carry out a handover between the RF channels under the same base station, and handles four DECT speech channels simultaneously. The base station is able to frame synchronize with other base stations under the same wireless server. Transmission lenght is up to 2 km/1.2 miles on a twisted pair, e.g. cat.4, between the base sta-tion and wireless server. The base station is also power supplied from this connection
(maximum supply 1.5 W). The DECT radius of coverage is up to 600 meters/1960 feet with a handset in free sight.2 InstallationFirst you have to determine where to install the base station to have the right coverage. The average coverage within buildings is 75 meters/246 feet. The coverage depends on the construction of the building, architecture and choice of buildings materials. You may have to use the Deployment Kit to optimize your installation. The base station is to be mounted vertically on the wall. To mount the base station on the wall:
Holes for wall mounted screwsPower supply
1Use a twisted pair cable, e.g. cat.4 between the base station and wireless server with an RJ11 connector at the base station end of the cable. Connect the cable to the plug using the two inner connectors of the plug.2Mount the base station onto the wall using the screws accompanyiing the base station.3Connect the base station to the wireless server.After the wireless server is powered up again, a cable lenght measurement is needed.Note: Cable dimensions min. as AWG 26.
Important Safety Instructions and Product Infor-mationBefore using your telephone equipment, you should always follow basic safety instruction to reduce the risk of fire, electrical shock and injury to persons, and damage to property.1Read and understand all instructions2Follow all warnings and instructions including those marked on the product3Unplug this product before cleaning. Do not use liquid cleaners or aerosol cleaners. Use damp cloth for cleaning4Do not install the telephone equipment in the bathroom or near a wash bowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool
5Slots or openings in the cabinet back and bottom of the equipment are provided for ventilation to protect it from over-heating. These openings must not be blocked or covered.6The equipment is to be connected only to the PoE networks without connection to outside plant.7The equipment is to be connected to a UL listed PoE server8Do not overload wall outlets and extension cords as this can result in fire or electrical shock.9Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage points or short
out parts that could result in fire, electrical shock, or injury. Never spill liquid of any kind into this product.10 To reduce the risk of electrical shock or burns, do not disassemble this product. Opening or removing covers may expose you to dangerous voltages, dangerous elec-trical current, or other risks. Incorrect reas-semble can cause electrical shock when the appliance is subsequently used. If the product need repair, consult your dealer.11 Refer servicing to qualified service person-nel under the following conditions:AQ If liquid has been spilled into the productBQ If the product has been exposed to rain or water
CQ If the product does not operate normally when following the operating instructions in the manual. Adjust only those controls that are covered by the operation instruc-tions. Improper adjustment of other con-trols may result in damage and will often require extensive work by qualified ser-vice personnel to restore the product to normal operation.DQ If the product has been dropped or cabi-net has been damagedEQ If the product exhibits a distinct change in performance2Avoid using telephone during an electrical storm. There may be a risk of electrical shock from lightning
3Do not use the telephone to report a gas leak in the vicinity of the leak4Do not place the unit near microwave ovens, radio equipment, or non-ground connected televisions. These appliances may cause electrical interference to the base or handset5Installation must be performed in accor-dance with all relevant national wiring rules.6The system will not operate in the event of a blackout. Please keep a backup phone for emergencies Intrinsic safetyDo not install the unit in conditions where there is a danger of electrically ignited explosions.
Exposure to sunlight, heat and moistureDo not expose the unit to direct sunlight for long periods. Keep away from excessive heat and moisture.Spare parts and accessoriesUse only approved spare parts and accesso-ries. The operation of non-approved parts can-not be guaranteed and may even cause damage.Power failureIn the event of a power failure, you cannot use the wireless system to make or receive callsNOTICESNOTICE: Before installing this equipment,
users should ensure that it is permissible to be connected to the facilities of the local telecom-munications company. The equipment must also be installed using an acceptable method of connection. The customer should be aware that compliance with the above conditions may not prevent degradation of service in some situations.Repairs to certified equipment should be coor-dinated by a representative designated by the supplier. Any repairs or alterations made by the user to this equipment, or equipment mal-functions, may give the telecommunications company cause to request the user to discon-nect the equipment.Users should ensure for their own protection that the electrical ground connections of the
power utility, telephone lines and internal metallic water pipe system, if present, are con-nected together. This precaution may be par-ticularly important in rural areas.CAUTION: Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection authority, or electrician, as appropriate.Note: If your telephone equipment causes harm to the telephone network, the telephone company may ask you to disconnect the sys-tem from the line until the prob lem has been corrected or they may discontinue your service temporarily. If possible, they will notify you in advance, But if advance notice is not practical, you should be notified as soon as possible. You
will be informed of your right to file a com-plaint with the FCC.Your telephone company may make changes in its facilities, equipment, operations, or pro-cedures that could affect the proper function-ing of your telephone system, If they do and it is possible, you will be notified in advance to give you an opportunity to mainta- in uninter-rupted telephone service. If you experience trouble with this telephone system, disconnect it from the network until the problem has been corrected or until you are sure that the equip-ment is not malfunctioning. Note: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interfer-ence in a residential installation. This equip-ment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interfer-ence will not occur in a particular installation. If this equipment does cause harmful interfer-ence to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the follow-ing measures: - Reorient or relocate the receiving antenna. - Increase the seperation between the equip-ment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help.FCC Note: This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may may cause undesired operation.IC Note: Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) this device must accept any interference, including interference that m a y c a u s e u n d e s i r e d o p e r a t i o n o f t h e d e v i c e .
The term “IC:” before the certification /regis-tration number only signifies that the Industry Canada technical specifications were met.CAUTION: Privacy of communication may not be ensured when using this phone.Power Outage: In the event of a power outage, your cordless telephone will not operate. The cordless telephone requires electricity for oper-ation. You should have a telephone which does not require electricity available for use during power outages.Information to user: The users manual or instruction manual for an intentional or unin-tentional radiator shall caution the user that changes or modifications not expressly approved by the party responsible for compli-
ance could void the user’s authority to operate the equipment.LIMITED WARRANTYThis limited, non-transferable warranty is pro-vided to the original purchaser. The product is warranted to be free from defects in materials and workmanship under normal installation, use and service for a period of one (1) year from the date of purchase as shown on the purchaser’s receipt. Our obligation under this warranty is limited to repair or replacement (at our option) of the product or any part(s) which are defective pro-vided that the product is returned to the origi-nal place of purchase or an authorized service location during the warranty period. Products
returned must be accompanied by a copy of the purchase receipt. In the absence of a pur-chase receipt, the warranty period shall be one (1) year from the date of manufacture. Repair or replacement of the product is your sole and exclusive remedy.If the product is repaired, reconditioned com-ponent parts or materials may be used. If the product is replaced, we may replace it with a new or reconditioned product of the same or similar design. The repaired product will be warranted for either (a) 90 days or (b) the remainder of the original one (1) year warranty period, whichever is longer.This warranty does not apply to the defects outside of our control, including but not lim-ited to acts of God, fire, flood and damage
while in transit to service facility. We do not warranty that the product will be compatible with any telephone equipment, systems or party lines.This warranty shall be void of the product is damaged as a result of defacement, misuse, abuse, neglect, accident, destruction or altera-tion of the serial number, improper electrical voltages or currents, repair, alteration or main-tenance by any person or party other than our authorized service facility, or any violation of instructions furnished by us.This warranty is also void if this product is removeds from the country in which it was purchased by the original purchaser, if it is used in a country in which it is not registered for use, or if it is used in a country for which it
was not designed. Due to variations in tele-phone systems and communications laws, this product may be illegal for use in some coun-tries. We assume no responsibilities for dam-ages or penalties incurred resulting from the use of this product in a manner or location other than that for which it was intended.THIS LIMITED WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES EXPRESS OR IMPLIED. ANY IMPLIED WARRANTIES INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF MERCHANT-ABILITY AND FITNESS FOR A PARTICU-LAR PURPOSE, SHALL BE LIMITED TO THE DURATION OF THIS WRITTEN LIMITED WARRANTY. WE DISCLAIM ANY LIABIL-ITY FOR DAMAGES FOR LOSS OF USE OF THE PRODUCTS, LOSS OF TIME, INCONVE-
NIENCE, INJURY TO ANY PERSON, OR DAMAGE TO PROPERTY CAUSED BY THE PRODUCT, LOSS OF REVENUE OR PROFIT OR DAMAGES FOR ANY FAILURE TO PER-FORM. IN NO EVENT SHALL WE BE LIABLE FOR ANY SPECIAL, INCIDENTAL, PUNI-TIVE OR CONSEQUENTIAL DAMAGES EVEN IF WE ARE ADVISED OF THE POSSI-BILITY OF SUCH DAMAGES.Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you. This war-ranty is the sole and exclusive warranty pro-vided for the product. There are no other express warranties. This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state.
Appropriate RFsafety/installation informationThe base station is intended to be installed by authorized personal. The base station shall be installed in accordance with FCC rules.The base station shall be placed at a location in such way, that there is at least 20 centime-ters/8 inches between the base transmitter and the users body or any other nearby per-sons.
International Regulatory InformationThis KIRK product has been marked with the CE mark. This mark indicates compliance with EEC Directives 89/336/EEC, 73/23/EEC 1999/5/EC. A full copy of the Declaration of conformity can be obtained from Polycom Ltd, 270 Bath Road, Slough, Berkshire, SL1 4DX, UK.The WEEE Marking on this equipment indicates that the product must not be disposed of with unsorted waste, but must be collected separately
Polycom (Denmark)Langmarksvej 34DK-8700 HorsensTlf. +45 7560 2850Fax +45 7560 2851www.polycom.com1405 7200-HD, ed.9

Navigation menu