Spectralink RFP5-1G9 KIRK basestation User Manual Basestation KIRK1G8 1G9 2G4

Download:
Mirror Download [FCC.gov]
Document ID	1032273
Application ID	t+R8Tufb5d/k9UaIQnjmYg==
Document Description	UserMan
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	11.41kB (142611 bits)
Date Submitted	2008-11-19 00:00:00
Date Available	2008-11-19 00:00:00
Creation Date	2008-09-09 21:41:59
Producing Software	Acrobat Distiller 8.1.0 (Windows)
Document Lastmod	2008-09-09 21:48:10
Document Title	Basestation_KIRK1G8_1G9_2G4.book
Document Creator	FrameMaker 8.0
Document Author:	heskesen

Polycom® KIRK® Base Station
1.8/1.9 GHz
User Guide
1 Introduction
The base station is only intended for use with a
wireless server. The base station is not
intended to be connected directly to the PSTN
network. The base station is designed with
two internal antennas and supports antenna
diversity. The base station is also able to carry
out a handover between the RF channels
under the same base station, and handles four
DECT speech channels simultaneously. The
base station is able to frame synchronize with
other base stations under the same wireless
server.
Transmission lenght is up to 2 km/1.2 miles on
a twisted pair, e.g. cat.4, between the base station and wireless server. The base station is
also power supplied from this connection
(maximum supply 1.5 W). The DECT radius of
coverage is up to 600 meters/1960 feet with a
handset in free sight.
2 Installation
First you have to determine where to install
the base station to have the right coverage.
The average coverage within buildings is 75
meters/246 feet. The coverage depends on the
construction of the building, architecture and
choice of buildings materials. You may have to
use the Deployment Kit to optimize your
installation.
The base station is to be mounted vertically on
the wall.
To mount the base station on the wall:
Holes for wall mounted screws
Power supply
1
Use a twisted pair cable, e.g. cat.4 between
the base station and wireless server with
an RJ11 connector at the base station end of
the cable. Connect the cable to the plug
using the two inner connectors of the plug.
Mount the base station onto the wall using
the screws accompanyiing the base station.
Connect the base station to the wireless
server.
After the wireless server is powered up again,
a cable lenght measurement is needed.
Note: Cable dimensions min. as AWG 26.
Important Safety Instructions and Product Information
Before using your telephone equipment, you
should always follow basic safety instruction
to reduce the risk of fire, electrical shock and
injury to persons, and damage to property.
Read and understand all instructions
Follow all warnings and instructions
including those marked on the product
Unplug this product before cleaning. Do
not use liquid cleaners or aerosol cleaners.
Use damp cloth for cleaning
Do not install the telephone equipment in
the bathroom or near a wash bowl, kitchen
sink, or laundry tub, in a wet basement, or
near a swimming pool
5
Slots or openings in the cabinet back and
bottom of the equipment are provided for
ventilation to protect it from over-heating.
These openings must not be blocked or
covered.
The equipment is to be connected only to
the PoE networks without connection to
outside plant.
The equipment is to be connected to a UL
listed PoE server
Do not overload wall outlets and extension
cords as this can result in fire or electrical
shock.
Never push objects of any kind into this
product through cabinet slots as they may
touch dangerous voltage points or short
out parts that could result in fire, electrical
shock, or injury. Never spill liquid of any
kind into this product.
10 To reduce the risk of electrical shock or
burns, do not disassemble this product.
Opening or removing covers may expose
you to dangerous voltages, dangerous electrical current, or other risks. Incorrect reassemble can cause electrical shock when the
appliance is subsequently used. If the
product need repair, consult your dealer.
11 Refer servicing to qualified service personnel under the following conditions:
AQ If liquid has been spilled into the product
BQ If the product has been exposed to rain or
water
CQ If the product does not operate normally
when following the operating instructions
in the manual. Adjust only those controls
that are covered by the operation instructions. Improper adjustment of other controls may result in damage and will often
require extensive work by qualified service personnel to restore the product to
normal operation.
DQ If the product has been dropped or cabinet has been damaged
EQ If the product exhibits a distinct change in
performance
Avoid using telephone during an electrical
storm. There may be a risk of electrical
shock from lightning
3
Do not use the telephone to report a gas
leak in the vicinity of the leak
Do not place the unit near microwave
ovens, radio equipment, or non-ground
connected televisions. These appliances
may cause electrical interference to the
base or handset
Installation must be performed in accordance with all relevant national wiring
rules.
The system will not operate in the event of
a blackout. Please keep a backup phone for
emergencies
Intrinsic safety
Do not install the unit in conditions where there
is a danger of electrically ignited explosions.
Exposure to sunlight, heat and moisture
Do not expose the unit to direct sunlight for
long periods. Keep away from excessive heat
and moisture.
Spare parts and accessories
Use only approved spare parts and accessories. The operation of non-approved parts cannot be guaranteed and may even cause
damage.
Power failure
In the event of a power failure, you cannot use
the wireless system to make or receive calls
NOTICES
NOTICE: Before installing this equipment,
users should ensure that it is permissible to be
connected to the facilities of the local telecommunications company. The equipment must
also be installed using an acceptable method of
connection. The customer should be aware
that compliance with the above conditions
may not prevent degradation of service in
some situations.
Repairs to certified equipment should be coordinated by a representative designated by the
supplier. Any repairs or alterations made by
the user to this equipment, or equipment malfunctions, may give the telecommunications
company cause to request the user to disconnect the equipment.
Users should ensure for their own protection
that the electrical ground connections of the
power utility, telephone lines and internal
metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas.
CAUTION: Users should not attempt to
make such connections themselves, but should
contact the appropriate electric inspection
authority, or electrician, as appropriate.
Note: If your telephone equipment causes
harm to the telephone network, the telephone
company may ask you to disconnect the system from the line until the prob lem has been
corrected or they may discontinue your service
temporarily. If possible, they will notify you in
advance, But if advance notice is not practical,
you should be notified as soon as possible. You
will be informed of your right to file a complaint with the FCC.
Your telephone company may make changes
in its facilities, equipment, operations, or procedures that could affect the proper functioning of your telephone system, If they do and it
is possible, you will be notified in advance to
give you an opportunity to mainta- in uninterrupted telephone service. If you experience
trouble with this telephone system, disconnect
it from the network until the problem has been
corrected or until you are sure that the equipment is not malfunctioning.
Note: This equipment has been tested and
found to comply with the limits for a class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off
and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the seperation between the equipment and receiver.
- Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/
TV technician for help.
FCC Note: This device complies with Part 15
of the FCC rules. Operation is subject to the
following two conditions: (1) This device may
not cause harmful interference, and (2) this
device must accept any interference received,
including interference that may may cause
undesired operation.
IC Note: Operation is subject to the following
two conditions: (1) This device may not cause
interference, and (2) this device must accept
any interference, including interference that
may cause undesired operation of the device.
The term “IC:” before the certification /registration number only signifies that the Industry
Canada technical specifications were met.
CAUTION: Privacy of communication may
not be ensured when using this phone.
Power Outage: In the event of a power outage,
your cordless telephone will not operate. The
cordless telephone requires electricity for operation. You should have a telephone which
does not require electricity available for use
during power outages.
Information to user: The users manual or
instruction manual for an intentional or unintentional radiator shall caution the user that
changes or modifications not expressly
approved by the party responsible for compli-
ance could void the user’s authority to operate
the equipment.
LIMITED WARRANTY
This limited, non-transferable warranty is provided to the original purchaser. The product is
warranted to be free from defects in materials
and workmanship under normal installation,
use and service for a period of one (1) year
from the date of purchase as shown on the
purchaser’s receipt.
Our obligation under this warranty is limited
to repair or replacement (at our option) of the
product or any part(s) which are defective provided that the product is returned to the original place of purchase or an authorized service
location during the warranty period. Products
returned must be accompanied by a copy of
the purchase receipt. In the absence of a purchase receipt, the warranty period shall be one
(1) year from the date of manufacture. Repair
or replacement of the product is your sole and
exclusive remedy.
If the product is repaired, reconditioned component parts or materials may be used. If the
product is replaced, we may replace it with a
new or reconditioned product of the same or
similar design. The repaired product will be
warranted for either (a) 90 days or (b) the
remainder of the original one (1) year warranty
period, whichever is longer.
This warranty does not apply to the defects
outside of our control, including but not limited to acts of God, fire, flood and damage
while in transit to service facility. We do not
warranty that the product will be compatible
with any telephone equipment, systems or
party lines.
This warranty shall be void of the product is
damaged as a result of defacement, misuse,
abuse, neglect, accident, destruction or alteration of the serial number, improper electrical
voltages or currents, repair, alteration or maintenance by any person or party other than our
authorized service facility, or any violation of
instructions furnished by us.
This warranty is also void if this product is
removeds from the country in which it was
purchased by the original purchaser, if it is
used in a country in which it is not registered
for use, or if it is used in a country for which it
was not designed. Due to variations in telephone systems and communications laws, this
product may be illegal for use in some countries. We assume no responsibilities for damages or penalties incurred resulting from the
use of this product in a manner or location
other than that for which it was intended.
THIS LIMITED WARRANTY IS IN LIEU OF
ALL OTHER WARRANTIES EXPRESS OR
IMPLIED. ANY IMPLIED WARRANTIES
INCLUDING BUT NOT LIMITED TO THE
IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, SHALL BE LIMITED TO THE
DURATION OF THIS WRITTEN LIMITED
WARRANTY. WE DISCLAIM ANY LIABILITY FOR DAMAGES FOR LOSS OF USE OF
THE PRODUCTS, LOSS OF TIME, INCONVE-
NIENCE, INJURY TO ANY PERSON, OR
DAMAGE TO PROPERTY CAUSED BY THE
PRODUCT, LOSS OF REVENUE OR PROFIT
OR DAMAGES FOR ANY FAILURE TO PERFORM. IN NO EVENT SHALL WE BE LIABLE
FOR ANY SPECIAL, INCIDENTAL, PUNITIVE OR CONSEQUENTIAL DAMAGES
EVEN IF WE ARE ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
Some states do not allow limitations on how
long an implied warranty lasts, so the above
limitations may not apply to you. This warranty is the sole and exclusive warranty provided for the product. There are no other
express warranties. This warranty gives you
specific legal rights, and you may also have
other rights, which vary from state to state.
Appropriate RFsafety/installation
information
The base station is intended to be installed by
authorized personal. The base station shall be
installed in accordance with FCC rules.
The base station shall be placed at a location
in such way, that there is at least 20 centimeters/8 inches between the base transmitter
and the users body or any other nearby persons.
International Regulatory Information
This KIRK product has been marked
with the CE mark. This mark indicates
compliance with EEC Directives 89/
336/EEC, 73/23/EEC 1999/5/EC. A
full copy of the Declaration of
conformity can be obtained from
Polycom Ltd, 270 Bath Road, Slough,
Berkshire, SL1 4DX, UK.
The WEEE Marking on this equipment
indicates that the product must not be
disposed of with unsorted waste, but
must be collected separately
1405 7200-HD, ed.9
Polycom (Denmark)
Langmarksvej 34
DK-8700 Horsens
Tlf. +45 7560 2850
Fax +45 7560 2851
www.polycom.com

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Page Mode                       : UseOutlines
XMP Toolkit                     : Adobe XMP Core 4.0-c316 44.253921, Sun Oct 01 2006 17:14:39
Creator Tool                    : FrameMaker 8.0
Modify Date                     : 2008:09:09 21:48:10Z
Create Date                     : 2008:09:09 21:41:59Z
Format                          : application/pdf
Title                           : Basestation_KIRK1G8_1G9_2G4.book
Creator                         : heskesen
Producer                        : Acrobat Distiller 8.1.0 (Windows)
Document ID                     : uuid:ee147f9e-f037-4d13-b518-ff6337f0449c
Instance ID                     : uuid:e9746e55-acf8-4fca-ac0f-e7e3d984f650
Page Count                      : 25
Author                          : heskesen

EXIF Metadata provided by EXIF.tools