Spectrum 924 Router Plugin Unit User Manual

Kwikset Corporation Router Plugin Unit

User Manual

Bluetooth Enabled Gateway SetupBluetooth Enabled Gateway Setup61844 / 01Requirements: • Internet service • Internet router with available Ethernet port• Active Kevo Plus membershipRequirements: • Internet service • Internet router with available Ethernet port• Active Kevo Plus membershipConnect and fully tighten the antenna to the back of the gateway. Bend the antenna so that it points straight up. Connect and fully tighten the antenna to the back of the gateway. Bend the antenna so that it points straight up. Plug the USB cable’s power jack end into the gateway. Plug the USB connector into the power adapter. Plug the power adapter into a power outlet.Plug the USB cable’s power jack end into the gateway. Plug the USB connector into the power adapter. Plug the power adapter into a power outlet.Make sure the lights on the gateway are functioning. See the Light Ring Colors on page 2. Follow the instructions inside the Kevo app to congure your gateway.Make sure the lights on the gateway are functioning. See the Light Ring Colors chart on page 2. Follow the instructions inside the Kevo app to congure your gateway.Once congured, you may control the gateway with the Kevo app or mykevo.comOnce congured, you may control the gateway with the Kevo app or mykevo.com.Plug one end of the Ethernet cable into the gateway. Plug the other end into your internet router.Plug one end of the Ethernet cable into the gateway. Plug the other end into your internet router.1324©2014 Kwikset Corporation
ColorColorReasonReasonWhiteWhiteBooting upBooting upBlueBlueNormal operation Normal operationRedRedNot connected to Kevo PlusNot connected to Kevo PlusMagentaMagentaNot connected to Kevo deadboltNot connected to Kevo deadboltAustraliaToll Free: 1800 623 118Email: info@spectrumbrands.com.auWebsite: www.spectrumbrands.com.auSpectrum Brands Australia Pty LtdLocked Bag 3004 Braeside, Victoria 3195 AustraliaNew ZealandToll Free: 0800 736 776Email: service@spectrumbrands.co.nzWebsite: www.spectrumbrands.co.nzSpectrum Brands New Zealand LtdPO Box 9817 Newmarket, Auckland 1149 New ZealandUSA & Canada1-800-327-5625Chile56-229382400Colombia57-13441460México52-8141709475Australia WarrantyOur goods come with guarantees that cannot be excluded under Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. The benets provided by this warranty are in addition to all other rights and remedies in respect of this product which you may have under Australian Consumer Law or otherwise.If your product is defective, you can have it repaired or replaced under our Lifetime warranty. To claim under our warranty, please return the defective item along with the packaging, the original receipt, your address and your signature by pre paid postage to Spectrum Brands Australia Pty Ltd at the address on pack at any time following purchase. Spectrum Brands Australia Pty Ltd will then replace or repair the item and return it to you at our cost.Light Ring ColorsLight Ring ColorsKevo SupportKevo SupportRegulatory ComplianceRegulatory ComplianceThis product complies with standards established by the following regulatory bodies:• Federal Communications Commission (FCC)• Industry CanadaFCCThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: ( 1 ) this device may not cause harmful interference, and ( 2 ) this device must accept any interference received, including interference that may cause undesired operation.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.IMPORTANT! Changes or modications not expressly approved by the manufacturer could void the user’s authority to operate the equipment.Industry CanadaThis device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: ( 1 ) this device may not cause interference, and ( 2 ) this device must accept any interference, including interference that may cause undesired operation of the device.Este producto cumple con las normas establecidas por los siguientes organismos reguladores:• Comisión Federal de Comunicaciones (FCC)• Industry CanadaFCCEste dispositivo cumple con la 15ª parte del reglamento de la FCC. Su funcionamiento está sujeto a las siguientes dos condiciones: ( 1 ) este dispositivo no deberá causar ninguna interferencia dañina, y ( 2 ) este dispositivo deberá aceptar cualquier interferencia recibida, incluyendo aquélla que podría causar un funcionamiento no deseado.Se realizaron pruebas a este equipo cuyos resultados revelaron que cumple con los límites establecidos para un dispositivo digital de la Clase B, conforme a la 15ª parte del reglamento de la FCC. Estos límites han sido impuestos para proporcionar protección razonable contra interferencias dañinas en una instalación residencial. Este equipo genera, utiliza y puede irradiar energía de radiofrecuencia y, si no se instala y utiliza según lo que indican las instrucciones, podría causar interferencia dañina en radiocomunicaciones. Sin embargo, no hay garantía de que la interferencia no ocurrirá en determinadas instalaciones. Si este equipo efectivamente causa interferencia en la recepción de radio o televisión, la cual puede determinarse encendiendo y apagando el equipo, sugerimos al usuario que intente corregir dicha interferencia tomando una o más de las siguientes medidas:• Volver a orientar o ubicar la antena receptora.• Incrementar la distancia entre el equipo y el recibidor.• Conectar el equipo a una toma de corriente en un circuito distinto del circuito en el cual esté conectado el recibidor.• Consultar con el distribuidor o un técnico de radio y TV con experiencia para obtener su ayuda.¡IMPORTANTE! Todo cambio o modicación no aprobado expresamente por el fabricante podría desautorizar al usuario para operar el equipo.Industria de CanadaEste dispositivo cumple con las normas de la Industria de Canada licencia-exenta RSS. Su funcionamiento está sujeto a las siguientes dos condiciones: ( 1 ) este dispositivo no deberá causar ninguna interferencia dañina, y ( 2 ) este dispositivo deberá aceptar cualquier interferencia, incluyendo aquélla que podría causar el funcionamiento no deseado del dispositivo.www.kwikset.com/kevo/supportNote: It is normal to see red and magenta during rst time setup.Note: It is normal to see red and magenta during rst time setup.

Navigation menu