Spin Master Toys Far East 44210TX27 RC Airplane User Manual
Spin Master Toys Far East Ltd. RC Airplane
User Manual
| Download: |  |
| Mirror Download [FCC.gov] | |
| Document ID | 667270 |
| Application ID | cvobns8rjyUCN3B5BWZi0g== |
| Document Description | User Manual |
| Short Term Confidential | No |
| Permanent Confidential | No |
| Supercede | No |
| Document Type | User Manual |
| Display Format | Adobe Acrobat PDF - pdf |
| Filesize | 44.77kB (559682 bits) |
| Date Submitted | 2006-06-12 00:00:00 |
| Date Available | 2006-06-12 00:00:00 |
| Creation Date | 2006-06-01 14:28:54 |
| Document Lastmod | 2006-06-01 14:38:57 |
| Document Title | User Manual |
The Air Hogs’ Ftoom Ratder‘“ is perlect tor . irrsl-ttme Ilyers There is no assembly required. ' All you need is an open space and srx AA 1.5v alkaline batteries (not included) to take lllghi. ADULT SUPERVISION RECOMMENDED PLEASE READTHESE INSTRUCTIONS BEFORE FLVING! Power/Charge Controller/ SWW‘ \ . ,, Charger \ Throttle INSTRUCTIONS Trigger Check to make sure contents are complete: 1 Air Hogs’ Ftoom Fielder” wttn Motor/Propeller t Controller/Charger l instruction Manual CONTROLLER/CHARGER BATTERY INS LATION IMPORTANT BATTERY INFORMATION —.\ I. use a PhllIlps screwdriver to unscrew and remove the - Batteries should always be replaced by an adult. battery holder trom the controller. _ Do not mix old and new bane'ies 2. install six AA 1.5V alkaline batteries (not included) ' in the controller, Be carelul to aIlgn the poslllve (+l and ' 9° "°‘ mix fl'kfl'm- “Md“ (°“m"'z'"°)v °’ negative t-l polarities With the corresponding markings Wharseflble (”WEI-Cadmium) bflfle'les» inside the battery holder - Non-rechargeable batteries are not to be recharged 3. Relnslall the battery holder and ttghten the screw . Rechargeable “genes are to be removed "cm the toy before being charged (it flammable). Controller . a, Battery - Rechargeable batterles are only to he charged under / Compartment adult supervision (it removable). - Dlflerent types of batteries or new and used batteries are not to be mixed. - Only batteries oi the same or equivalent type as recommended are to be used. Battery Holder ' Batterles are to be Inserted with the correct polarity. - Exhausted batteries are to be removed from the toy. S‘Xlfigllsv - The supply terminals are not to be short-circuited. Batteries \M% - Please retain thls lnlormatlon tor Iutura reterence. M .. ‘ CAUTION: Do not dispose or batteries in lire. Batteries % + may explode or leak. —) Familiarize yoursell with the position oi the "ON/OFF" switch, ING IN OORS and Charge Port. Location 7 Fly in a wide open room. away trom breakable items. Avord llying near vents and/or tans. as these may overpower the Room Raiderw and make it dltllcult to control. NOTE: Always get permission la tly your Room RaiderW indoors. WARNING: Never ity near your face Keep propeller away lrom your lingers. hair, eyes and other body parts. Always lift 0“ Item a flat surface Never hold the Room Haida!w by the bottom ltn. Do not launch jet near people or animals Stay away trom obstacles and electric hazards ”ON/OFF" Switch Charge Port CHARGING YO R ROOM RAIDER'“ 1. Open door on the controller to access the charge cable 2. Plug charge cable mto the charge port. 3. Stlde the power swnch art the controller to ”CHARGE" The charge Ilght wtll llash white chargtng and stop tlashtng when the battery ts lully charged 4. Remove the charge cable trom the charge port. store it tn the charger and close the storage door NOTE: For best tltgttt perlolmancen ttttty charge yottr Room Ratoer “ before each tllgt’tt FLVING VOUR ROOM RAIDER‘” tt Turn the let "ON/OFF" switch to "ON". tTlltfl the controller "ON". Proper Grip tor Launch 3. Hold the controller tn one hand and let as shown 4. scuecze the throttle Irlgger about 1/2 way and gently toss the Room Ratder’“ tnto the arr. The Room Raiderw wtll begtn tlytng tn ctrcles to the lett 5, Control the allltude by squeezing the throttle trtgger \ Do not held here FCC REQUIREMENTS Thts devtce compltes wtth part 15 at the FCC Flutes Operatton is subject to the following two condtltohs ttrhts devlco may not cause harmlul tnterterence 2) Thts devtce must accept any tnterterence recetvedn includlng tnterlerence that may cause undesired uperattoh WARNlNG Changes or modlllcatlons not expressly approved by the party responstble tor tts compliance could vote the user's atlthortly to operate the equtprrtent. TROUBLESHOOTING PROBLEM CAUSE SOLUTION Room Raider " 1 You have not set the motor switch to "ON“. 1 Push motor swltch switch to “ON" wlll not start or 2 Battery power ts low, 2 Replace the controller batteries has lost power 3 Batteries to) or (-) are not correctly placed 3 Be sure to altgn the (t) and (e) potartttes with the tnstae the battery compartment corresponding marktngs lrlslde the battery compartment 4 Room Ftatder'“ battery ts law 4 Recharge Floom Raiderm 5 Satety auto-cute" IS activated 5 Tum jet Ottr watt 3 seconds then turn back on Room Ratdor'” t Needs more power t Squeeze the throttle trigger more ls tlylrlg too low 2 The batteries in the controller are dratrled 2 lnstall new batterles 3 Room Hatder'“ battery ls low 3 Recharge Room Raider”. m cat trunt St rest rutttntt CNMSV lssctttteut w atttlezmtasrntt Mutttt tttl tn lm "ME“UC‘JA znuttttetttattrmt D'lva stttt lu’l [Jam-markQVSl'llltMaslelHfl l\ll rims-curved mm,“ “pun",wm , M ‘12 the tn bS/t D'Oduct satb'v Slindilds ASTM F963 03 lNWIDlt Wmurl'wt:5 tnth tnhttt tn ntttttt ht t tn tn ntttttntn my: gftfllggggggm rrltttu, ht rsttrtstntstrr Kuwtuflll HK lutttteretetertce Patentptttutnu ‘ ‘ O ‘ MADE lN chlltlA ”Mb” t ht t htn h ttrthtttn N q ‘to t Mb 622 ms ltrttt mm JJZ‘U—k‘l - 4K} .-n “lllll‘tt‘ttt’l rtrt montage tznootass RE‘lt item ”4210 A NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa- tion. This equipment generates, uses, and can radiate radio fre- quency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio com- munications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio /TV technician for help.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.3 Linearized : No XMP Toolkit : 3.1-701 Create Date : 2006:06:01 14:28:54Z Modify Date : 2006:06:01 14:38:57+08:00 Metadata Date : 2006:06:01 14:38:57+08:00 Format : application/pdf Document ID : uuid:a2cfe732-5cdf-46a5-9114-557e876795c2 Instance ID : uuid:8c02c894-4dc5-4e21-ac62-80bc6a5a67cd Page Count : 3EXIF Metadata provided by EXIF.tools