Summer Infant 02080T Video Baby Monitor User Manual 02080 4 1 rv eps
Summer Infant, Inc. Video Baby Monitor 02080 4 1 rv eps
users manual
PROBLEM SOLVING: Problem Solution - Make sure the TV Ts turned on - Make sure the AC Adapters are piugged Tn - Make sure the outiets are worang - Make sure the two Cameras are set on different channeis. Toggie the TV between one channei or the other (try usTng the thTrd channei to anTmTze Tnterference Tf necessary) - Make sure the antenna on the TV Ts fuliy extended No picture or sound on TV - Press the QuTck VTewNTdeo On/Off Button once to turn on Video mode - Try adTustlng the BrTghtness, Contrast and VertTcai Hoid dTais on the TV - Test receptTon by moang the TV and/or Camera to deferent iocatlons - Make sure the two Cameras are set on different channeis. Toggie the TV between one channei or the other (try usTng the thTrd channei to anTmTze Tnterference Tf necessary) - Make sure the antenna on the TV Ts fuliy extended Sound but no pTcture on TV PTcture but no sound - Turn up the voiume on the TV usTng the Voiume Dial - Make sure the two Cameras are set on different channeis. Toggie the TV between one channei or the other (try usTng the thTrd channei to anTmTze Tnterference Tf necessary) - Make sure the antenna on the TV Ts fuliy extended Picture not ciear - Make sure the two Cameras are set on different channeis. Toggie the TV between one channei or the other (try using the thTrd channel to anTmTze Tnterference if necessary) - PosTtTon the TV closer to the camera Tf necessan/ - Move TV away from other monTtors, cordiess phones, waik—talkTes, etc. - Try adTustlng the BrTghtness, Contrast and VertTcai Hoid dTais on the TV - Test receptTon by moang the TV and/or Camera to deferent iocatlons - Make sure the antenna on the TV Ts fuliy extended SqueaiTng sound - Move the Camera and the TV further away from each other If you experience a problem that is not noted in this manual, please do not return the product to the stores Our Customer Service Department may have a simple solution to your problem. Please contact us 1-300-268-6231 or e-mail us at customerservice@summerinfant.com. FCC information ThTs deVTce compiies with part i5 of the FCC Ruies. Operation is subject to the foiiowmg two conditTons. (i ) This device may not cause harmful Tnterference, and (2) this devTce must accept any interference received, Tnciuding Tnterference that may cause undesTred operation. CAUTION Changes or modeicatTons not expressiy approved by Summer infant may von the users authothy to operate this eqqument. NOTE: This eqqument has been tested and found to comply with the iTmTts for a Ciass B dithaI device, pursuant to part if: of the FCC Ruies. These ITmits are designed to prodee reasonabie protection agaTnst harmfui Tnterference Tn a resTdentTai instaiIatTon ThTs equipment generates, uses and can radiate radio frequency energy and, if not Tnstaiied and used in accordance with the instructTons, may cause harmfui interference to radTo communTcations. However, there iS no guarantee that Tnterference wiii not occur Tn a pamcuiar Tnstaiiation. If thTs equipment does cause harmfui Tnterference to radio or teIestTon receptTon, which can be deteraned by turnTng the equipment off and on, the user Ts encouraged to try to correct the Tnterference by one or more of the foIiowing measures 0 ReorTent or relocate the receiving antenna 0 increase the separatTon between the equipment and the receiver 0 Consuit the deaier or an experTenced radTo/TVtechnTcTan for heip © 9009 Summer infant, inc. We at Sumrner infant stand 6 Biackstone Vaiiey Piace bethd aii of our products SuTte 906 ifyou are not compieteiy LTncoin, Pi 09865 USA sathfTed Or have any questTons, LEGO—96843937 please Contact 0” wwwsummerTnfant corn P a g e Customer SeNTce Department at 180096876937 or ermaTi us at MADE '" CHM“ customerserVTce@sumrnerinfant.com Coiors and styies may vary. 10/0? Summer iNFANT Al ,- . rTruTrrn ' . i Jill/11m), ‘ r 4 , tum/up, 02080 Please read the following instructions carefully. ® Keep this instruction manual for future reference. Phillips heod screwdriver (not included). For Technical Support Call 1-800-268-6237 or E-Muil at customerservice©summerinfunt.com A WARNING: ThTs product contains smaii parts. Aduit assembiy requred. Exercise care when unpasking and assembiing product. INSTRUCTION MANUAL BABY’S QUIET SOUNDS” DUAL VIDEO MONITOR Thank you for buying the 900 MHZ Baby's Quiet Sounds“ Dual Video Monitor from Summer infant. Now you can hearand see your babyi ideal for oider chiidren too — monitor piayroom activitTesi Two cameras aliows parents to visualiy monitor 9 different locations in the home at the same time by switcthg channels QUICK SET UP: Read the Tnstruction manual for more detaried instructrons and expianations. - Place one Camera in nursery and posrtion facing chb (do not piace Tn crib or Within chiid’s reach). Tiit the MuitT—Positio Camera/Microphone so Tt is faCTng baby as much as pOSSTbie. Use Security Clips inciuded to secure Cameras cord away from baby's reach. - Plug smail AC Adapter into Camera’s AC Adapter Jack and other end of cord Tnto a standard electricai outiet. - Turn Camera on and seiect channel by setting the Channei Selector (Off/A/B/C) to channel A. 0 Position TV in the room from which you will monitor baby. Piug large AC Adapter Tnto TV’s AC Adapter Jack and plug the other end into a standard electricai outiet. Fuiiy extend the TV's antenna. - Turn TV on using Power OnNqume Dial. Set Channei Selector to channei A. You should now be able to see a View of the nursery and hear any sounds in the nursery. If you don't get a pTcture, press the Quick View/Video On/Off Button. 0 If the picture is not ciear, try switching both the Camera and the TV to Channei B or channel C. Sometimes a siTght adjustment to the Camera, TV and antenna can make a Significant difference in reception - AdTust the voiume on the TV as needed. - To use the second Camera, set it up in another iocation, and ensure that the Channel Seiector is set to Channei B or C. AWARNING: THIS PRODUCT CANNOT REPLACE RESPONSIBLE ADULT SUPERVISION. - Prevent cord entanglement— do not place Camera in crib or within arm’s reach of baby. Use enclosed Security Clips to help secure cords away from baby’s reach. Never use extension cords with AC adapters. Only use the AC Adapters provided. - When an AC Adapter is plugged into an electrical outlet, do not touch the exposed end. - Test monitor before first use, periodically, and when changing location of the Camera. ACAUTION: KEEP SMALL PARTS OUT OF CHILD’S REACH. 0 Do not use monitor near water (such as bathtub, sink, etc) 0 Keep monitor away from heat sources (such as stoves, radiators, etc) and make sure there is proper ventilation (not on sofas, cushions, beds, etc which may block ventilation) - Nursery monitors use public airwaves to transmit signals. This monitor may pick up signals from other monitors or similar devices and vice versa. FEATURES & COMPONENTS: SET UP & USE: Quick View/Video Onloff Button (Video/On/Off) Channel Switch CAMERAS (two): (OfffA/B/C) TV; Antenna 1 Night Time lED’s (for dark room) Channel Selector— On! (Off/ win, Volume NB/O - Dial \ - Speaker CameraIMicrophone P°W¢' Sound Lights On [ED Vldeo On Light TV (BACK VIEW): - Carrying Handle II II III Ito i—-"11:rltdical — TV AC Adapter (large) I .‘ 9.“ AC Adapter Brightness ' , f {A- lack Contrast — Camera Screw AC Adapter (one) (small) (two) ’ Security a e P 29 Clips (six) Camera 0 Table Top or Wall Mounting: Tilt Camera/Microphone up, and pull up (see Figure A). Determine a location for the Camera that Will provide the best view of your baby in his crib, Place the Camera on a flat surface, such as a dresser, bureau, or shelf. Or mount the Camera on a wall. Be sure to test reception and Camera positio ing before mounting to a wall (see “Testing Your Initial Set Up“ section). Fiounso .v__ x \ To Wall Mount: a) Pre—drill a hole in the wall (3/i6", 4.8mm, drill bit), See Figure B. b) Insert the wall anchor (included) into the hole and with a hammer, tap gently on the end until the Wall anchor is flush with the wall. c) Insert the screw (included) into the wall anchor and tighten screw until only i/4“ (6.9mm) of the screw is exposed. d)lnsert smaller AC Adapter into the Cameras AC Adapter Jack. e) Slide the back of the Camera down onto the screw until the Camera is secure to the wall. f) Plug the AC Adapter into a standard C electrical outlet, 3) Secure the cord to the wall using the 6 Security Clips included to keep cord away from baby's reach (see Figure C) SET UP & USE(continued): To Adjust Camera: Place camera on a hard, well ventilated surface approximately 4 a 6 feet from the child or viewing object Pivot camera lens upward until it is standing upright in the base, For additional height gently pull the camera lens up until you hear a click. For full extension, gently pull it up again until you hear another click. Adjust camera by turning left to right i80 degrees and tilting forward or backward for optimal Viewing positions. 0 Set Channel Selector to channel A. The Power On LED will illuminate solid green. 0 Repeat for second Camera in another location, set to channel B or C. TV 0 Position TV in the room from Which you will monitor your baby in the other location. Pull up the antenna until it is fully extended 0 Plug the larger AC Adapter into the TV's AC Adapter Jack. Plug the other end into a standard electrical outlet. 0 Turn the TV on uSing the On/Volume Dial. The Power On LED Will illuminate green. Set the Channel Selector to channel A, Press the Quick View/Video On/Off Button (labeled "Video ON/OFF“) once for a view of the nursery. Switch to channel B or C to vieW the other location. When Video mode is on, the Video On tight will illuminate green. 0 Adjust the volume as needed using the Volume Dial. Adjust picture uSing the Contrast, Brightness, and Vertical Hold Dials on the back of the TV. 0 For audio and no Video, press the Quick View/ Video On/Off Button again to shut off the video mode, 0 To turn the W off completely, use the ONNolume Dial, Testing Your Initial Setup: Be sure to test your monitor's reception before initial use. We also recommend testing your monitor's reception periodically. Please keep in mind that the Baby's Quiet Sounds “ Video Monitor Will not provide the same level of picture quality as your television With cable, satellite dish, or digital serVice, To test receptlon you will need two adults. One adult should view the picture on the TthiIe the other is in the nursery to adjust the Camera. Often the quality of the reception can be improved by slightly repositioning the Camera, TV, or both. It may help to place a stuffed animal or doll in the crib to simulate the position and Size of your baby. Adiust the picture quality on the TV as needed by using the Contrast, Brightness and Vertical Hold dials. To test sound quality, have one adult speak in both a normal tone and a Whisper near the crib Adjust volume on the TVs Volume Dial as needed. TIPS FOR IMPROVING RECEPTION: 0 Change the channel on both the TV and the Camera, Always make sure they are set to the same channel (both on A, both on B or both on C). Always make sure that each Camera is on a different Channel (i.e, one on Channel A, one on Channel B. - Position the TV closer to the camera if necessary. ° Move TV away from other monitors, cordless phones, walk—talkies, etc.; even slightly could greatly improve reception. 0 If you heara feedback or squealing noise, move the Camera and the TV further away from each other. SPECIAL FEATURES: 0 Sound Lights: The 5 Sound Lights Will illuminate on the TV depending on the level of your baby's sounds. For example, if your child is just coomg, only one or two lights Will illuminate. lfyour baby is crying, several Will illuminate, depending on how loud she is crying. This feature is particularly helpful if you are in a noisy room. 0 Quick View/Video OnIOff Button: This button turns the video mode on. lfyou only want to hear your baby, press the Quick View/Nideo On/Off Button again to shut off the video. The Quick ViewNideo On/Off Button is ideal for easily turning on the video option in the middle of the night. ° Night Vision: ln a darkened room the monitor Will automatically use its infrared LED’s to transmit a clear image of baby, so you can see your child at night! - Multi-Position Camera/Microphone: The Camera/ Microphone should be positioned so it is facing baby as much as posSible. This multi—position feature is unique to Summer Infant nursery monitors. It allows the microphone to focus on baby's voice While filtering out other household noises. - Channel Switch: Three channels allows parents to view two different locations, With the option of page selecting channels that minimize interference. 3
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.3 Linearized : No Create Date : 2002:10:11 12:00:50 Producer : Acrobat Distiller 4.0 for Macintosh Author : walt g petrosky Creator : Adobe Illustrator(R) 8.0 Title : 02080 4/1 rv.eps Modify Date : 2002:12:12 19:44:23-05:00 Page Count : 2EXIF Metadata provided by EXIF.tools