Suncon Toys Industry 60202 Wireless Remote Control Toy Transmitter User Manual users manual

Download:
Mirror Download [FCC.gov]
Document ID	804733
Application ID	IYC+fC9B0zwKgBhfQR0Klg==
Document Description	users manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	108.29kB (1353652 bits)
Date Submitted	2007-06-18 00:00:00
Date Available	2007-06-18 00:00:00
Creation Date	2007-05-24 17:45:54
Producing Software	Adobe PDF Library 7.0
Document Lastmod	2007-06-06 15:10:21
Document Title	users manual
Document Creator	Adobe InDesign CS2 (4.0)

Driving Your Truck
Thank you for purchasing your 1:14 7F Dual
Power 4WD Toyota Tundra from RadioShack.
Built to 1:14 scale, it can reach speeds of
570 feet per minute and comes in one of two
frequencies (27 MHz or 49 MHz), so you can
race with a friend. Please read this user’s guide
before installing, setting up and using your
truck.
1. Thread the truck’s antenna wire through the supplied antenna tube. Then, insert the tube
into the antenna tube holder on the truck’s body.
Toyota Tundra
2. Make sure the transmitter and the truck are on the same band. Turn on the truck and
transmitter. Your truck comes in 3 frequencies(ABC) so you can play with friends. Set your
truck and transmitter to a frequency different to your friend’s.
3. Use the transmitter’s control levers to steer your truck.
What’s Included
4. Turn off the truck when you finish driving.
ON/OFF
lights when you turn on the truck.
Left
Straight
4WD Toyota
Truck Antenna Tube
User’s Guide
Right
Forward
Transmitter
AA Battery Tray
Safety and Care
• Do not use your truck near transmitters
with the same frequency (27 MHz or 49
MHz).
• A nearby CB can interfere with your truck’s
control. If this happens, move the truck
away from the CB.
• Never play with your truck in the street.
• Avoid high-impact collisions with people
and objects.
Stop
Reverse
RF Emissions Information
Band ABC
R / L – Turn toward R if the truck pulls to the
left, or toward L if it pulls to the right.
Battery Notes:
Installing Batteries
1. Turn off your truck.
2. Insert one 9V battery (not supplied) in the
transmitter battery compartment matching
the polarity symbols (+ and -) marked inside.
3. On the truck, turn the latches to open the
battery compartment.
• Use only fresh batteries of the required
size and recommended type. Do not mix
batteries of different types, capacities, or
chemistries.
• Do not burn or bury batteries.
OR
Load and connect a fully-charged 9.6V
battery pack (not supplied). The
��������������
connector
fits only one way. Do not force it.
Battery
compartment
• If you do not plan to use the truck for a week
or longer, remove the batteries from both the
truck and transmitter.
limited 90-day Warranty
• Position the battery connectors and wires so
they do not touch any moving parts.
5. Replace the battery door and secure the
latches.
60-155A.indd 1
Band ABC
ON/OFF
• To keep motor heat levels down, let the truck
cool at least ten minutes between battery
exchanges.
4. Load six AA batteries (not supplied) with
correct polarity into the supplied battery
compartment tray
©2007. RadioShack Corporation.
All rights reserved. RadioShack and
RadioShack.com are trademarks
used by RadioShack Corporation.
Latches
L / H – Switch to L when driving on rough
terrain, or to H when driving on smooth terrain.
60-155A
05A07
Printed in China
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment causes harmful interference to radio
or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult your local RadioShack store or an experienced
technician for help.
If you cannot eliminate the interference, the FCC requires that
you stop using your truck. Changes or modifications not expressly
approved by RadioShack may cause interference and void the
user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause
undesired operation.
This product is warranted by RadioShack against manufacturing
defects in material and workmanship under normal use for ninety
(90) days from the date of purchase from RadioShack companyowned stores and authorized RadioShack franchisees and
dealers. For complete warranty details and exclusions, check with
your local RadioShack store.
RadioShack Customer Relations
300 RadioShack Circle
Fort Worth, TX 76102			
www.radioshack.com
04/04
Actual product may vary from the images found in this document.
05/24/2007 17:46:00

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Create Date                     : 2007:05:24 17:45:54+08:00
Creator                         : Adobe InDesign CS2 (4.0)
Modify Date                     : 2007:06:06 15:10:21+08:00
Tagged PDF                      : Yes
About                           : 8d3d7da3-db42-11d8-8912-87323669aa26
Producer                        : Adobe PDF Library 7.0
Trapped                         : False
Creation Date                   : 2007:05:24 17:45:54+08:00
Mod Date                        : 2007:06:06 15:10:21+08:00
Metadata Date                   : 2007:06:06 15:10:21+08:00
Creator Tool                    : Adobe InDesign CS2 (4.0)
Thumbnail Format                : JPEG
Thumbnail Width                 : 256
Thumbnail Height                : 256
Thumbnail Image                 : (Binary data 12341 bytes, use -b option to extract)
Instance ID                     : uuid:afaf0865-2853-49cc-b305-419eb18dc3a4
Document ID                     : adobe:docid:indd:1afbaa65-8eb1-11db-b705-9d61c4031c9b
Rendition Class                 : proof:pdf
Derived From Instance ID        : 1afbaa64-8eb1-11db-b705-9d61c4031c9b
Derived From Document ID        : adobe:docid:indd:1afbaa63-8eb1-11db-b705-9d61c4031c9b
Manifest Link Form              : DirectStream, DirectStream, ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream
Manifest Placed X Resolution    : 72.00, 72.00, 300.00, 300.00, 300.00, 300.00
Manifest Placed Y Resolution    : 72.00, 72.00, 300.00, 300.00, 300.00, 300.00
Manifest Placed Resolution Unit : Inches, Inches, Inches, Inches, Inches, Inches
Manifest Reference Document ID  : uuid:f338099a-7f7c-460b-9e61-3ed074db1436, uuid:dc665038-2da2-4c42-bf88-cc0c3a2b01f9, uuid:A9BE3DBE5207DC1192C5A644E90EEE03, uuid:1B5DC9DD6907DC1192C5A644E90EEE03, uuid:1F5DC9DD6907DC1192C5A644E90EEE03, uuid:44D507A11708DC1180E8A27FC279EF47
Manifest Reference Instance ID  : uuid:AABE3DBE5207DC1192C5A644E90EEE03, uuid:1C5DC9DD6907DC1192C5A644E90EEE03, uuid:205DC9DD6907DC1192C5A644E90EEE03, uuid:45D507A11708DC1180E8A27FC279EF47
Format                          : application/pdf
Page Count                      : 1

EXIF Metadata provided by EXIF.tools