Sunray TEchnology 1022 Micro Power Wireless Data Module User Manual SRWF 1022 REV 6
Shanghai Sunray Technology Co., Ltd. Micro Power Wireless Data Module SRWF 1022 REV 6
SRWF-1022 User Manual REV 6
ShangHai Sunray Technology Co.,Ltd SRWF-1022 Series Low Power Wireless Transceiver Module User Manual ShangHai Sunray Technology Co.,Ltd China. Shanghai Tel:86-21-38953738/ 86-21-50275250 Fax:86-21-50270187 http://www.51sunray.com Page 1 of 6 ShangHai Sunray Technology Co.,Ltd SRWF-1022 User Manual (V1.1) I. SRWF-1022 SRWF-1022, the low-power wireless transceiver module is used as the wireless command transceiver in short-ranges, with the small size, weight and power consumption and good stability and reliability. Narrowband low power UHF wireless data transmitters: II. Feature of SRWF-1022 Low Power RF Module 1. Using oscillator instead of crystal. The work temperature with oscillator is -40℃ to 80℃(with crystal is -25℃ to 75℃). 2. High reliability, small and light Single chip radio - frequency integrated circuit and single chip MCU are used for lessened peripheral circuits, high reliability, and low false bit rate. 3. ISM frequency band, requiring on application of frequency point. Carrier frequency of 470.5~479.5MHz. 4. High anti- interference and low BER(Bit Error Rate) Based on the GFSK modulation mode, the high- efficiency forward error correction channel encoding technology is used to enhance data’s resistance to both burst interference and random interference and the actual bit error rate of 10-5~10-6 can be achieved when channel bit error rate is 10-2. 5. Low power consumption +5V supply power, receiving current is 30±3mA。 III. technology support and after service : Serial number Item Modulation mode GFSK Work frequency 470.5~479.5 MHz Receive sensitivity -117 dBm Transmitting current 90±10mA Receiving current 30±3mA Sleeping current 5±2uA Interface velocity 1200/2400/4800/9600/19200bps Interface mode VCC,GND,GPIOs China. Shanghai Parameter Tel:86-21-38953738/ 86-21-50275250 Fax:86-21-50270187 Note 1200bps@470.5MHz http://www.51sunray.com Page 2 of 6 ShangHai Sunray Technology Co.,Ltd Power supply +3.3~5VDC 10 Working temperature -40℃~80℃ 11 Working humidity 10%~90%(relative humidity without condensation) 12 Dimension 47mm×26mm×10mm Ⅳ.Use SRWF-1022 wireless transceiver module SRWF-1022 supply 9- pin connector, and its definitions as well as below. The connection method of each terminal is shown in Table 1. Table 1 Pin No Pin Name Description GND Grounding of Power Supply VCC Power supply DC RXD/TTL Level + 3.3 ~ 5.0V Serial data receiving end Serial data transmitting TXD/TTL end SGND Grounding of the signal A(TX) GPIO1 B(RX) GPIO2 SLEEP Sleep control (Input) TTL RESET Reset control (input) TTL Connected to Memo Terminal Grounding of Power Supply TTL TXD COM1 TTL RXD TTL TTL Sleep control signal input Reset signal input For button detect Low level enable t>15ms Negative pulse reset 1ms *** When the level of GPIOs(A and B terminal )changes, the 1022 module will send out the control command, and the remote receiver will act according to the command received. Ⅴ.Setting of the channel 1. Before using SRWF-1022, you have to make simple configuration of your China. Shanghai Tel:86-21-38953738/ 86-21-50275250 Fax:86-21-50270187 http://www.51sunray.com Page 3 of 6 ShangHai Sunray Technology Co.,Ltd system parameter, such as RF channels. channel √ 470.500 √ 475.500 √ 479.500 √ √ √ √ √ √ 10 √ √ 11 √ √ 12 √ √ 13 √ 15 √ 472.500 √ √ 471.500 472.000 √ 14 Frequency(MHz) 473.000 473.500 √ 474.000 √ 474.500 √ 476.000 √ 476.500 √ √ 477.000 √ √ √ 477.500 √ √ √ 478.000 16 478.500 China. Shanghai Tel:86-21-38953738/ 86-21-50275250 Fax:86-21-50270187 http://www.51sunray.com Page 4 of 6 ShangHai Sunray Technology Co.,Ltd Short circuit There is one group of 5-bit short-circuit wire (JP2) on the bottom right corner of SRWF-1022, defined as A、B、C、D、E respectively . A、B、C, D are used for channel selecting, but E is for parity format: E=0 (without shorter) parity 8E1/8O1/9N1 (default) E=1 (with shorter) parity 8N1 2: indicator function In transmitting mode, the red indicator light will twinkle. In receiving mode, the green indicator light will twinkle. Ⅶ.Sketch map of structural size (see below): China. Shanghai Tel:86-21-38953738/ 86-21-50275250 Fax:86-21-50270187 http://www.51sunray.com Page 5 of 6 ShangHai Sunray Technology Co.,Ltd Ⅷ. Technology support: We offer sufficient technology support for user use the module for free; mending broken module one year for free, always offer after service. To adapt different user structure, we can develop smaller module or various size modules ShangHai Sunray Technology Co.,Ltd ADDRASS: Floor8,No 560 Shengxia RD Zhangjiang Shanghai Pudong china Tel:+86-021-50275250/50275255 Fax:+86-021-50270187 Website: www.51sunray.com China. Shanghai Tel:86-21-38953738/ 86-21-50275250 Fax:86-21-50270187 http://www.51sunray.com Page 6 of 6 ShangHai Sunray Technology Co.,Ltd NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. FCC ID number is not visible when the module is installed inside host(s), then the outside of the host must display a label “Contains transmitter module FCC ID: RBC-1022” This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1)This device may not canse harmful interference, and (2)this device must accept any interference received,including interference that may cause undesired operation. Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : No Tagged PDF : No XMP Toolkit : Adobe XMP Core 4.2.1-c041 52.342996, 2008/05/07-20:48:00 Modify Date : 2014:05:13 17:05:44+08:00 Create Date : 2014:05:13 15:58:47+08:00 Metadata Date : 2014:05:13 17:05:44+08:00 Creator Tool : Acrobat PDFMaker 9.1 Word 版 Document ID : uuid:71dc1972-8903-4043-b5d1-7fb13c70e2ca Instance ID : uuid:e9efea29-17ab-463e-9232-d77cb60318b0 Subject : 79 Format : application/pdf Title : SRWF-505无线模块使用说明 Description : Creator : yingmz Producer : Adobe PDF Library 9.0 Keywords : Source Modified : D:20140513075841 Company : sunray Comments : Page Layout : OneColumn Page Count : 7 Author : yingmzEXIF Metadata provided by EXIF.tools