Sunrex Technology EBT203A Bluetooth Touchpad User Manual EBT 203A Manual

Sunrex Technology Corp Bluetooth Touchpad EBT 203A Manual

User Manual

Bluetooth Touchpad (EBT-203A / KST-S01BT / 19025) User Manual Important Information For Windows® 8 operating system, you can use the keyboard immediately after plugging the dongle (receiver) into the USB port. Hardware Installation 1. Make sure the batteries of the keyboard is installed correctly. Please follow the polarity signs in the battery compartment. 2. Please make sure the power switch on the back of the Touchpad is switched to “ON” before using the Touchpad. When not in use, please turn the power switch to “OFF” for power saving. ID Pairing Procedure • Now the radio connection between computer and Touchpad must beestablished (Pairing). Press the keys “ Left Button + Right Button” and Power ON your Touchpad simultaneously. After 2 seconds pairing starts, the pairing LED is blinking. Pairing can take several seconds and is finished, when the LED above the trackball goes off. Should the pairing process break off (LED goes off) without getting a connection, try it again. Probably, it can be necassary to switch the rear sliding switch off and on again. • On your screen the Bluetooth assistent opens and shows all Bluetooth devices, which are located near your computer. Select your Touchpad and confirm with „Continue“. • The Touchpad is still not identified, press „Continue“.
Note: -Make sure your PC is ON and running when doing the pairing procedure. -You don’t have to pair ID again after changing batteries. If it can’t work, please follow the steps above to pair ID. Import Usage Information  Battery: 1. We recommend using alkaline batteries for a longer battery life. 2. Don’t mix different types of batteries or new and old batteries together. Always replaced old batteries with new and same type batteries. 3. Remove batteries after long periods of non-use. Battery leakage or corrosion may damage the device quality and cause danger.  Rating: Keyboard: 3VDC 35mA  Max. operating temperature: 40∘C CAUTION This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the authority to operate equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. Industry Canada Notice Operation is subject to the following two conditions: (1) this device may not cause interference and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

Navigation menu