Sure Wave CQZ194-B Aluminum Bluetooth Speaker User Manual
Sure Wave (HongKong) Limited Aluminum Bluetooth Speaker
User manual
CQZ194-B Bluetooth Speaker
Instruction Manual (Read before proceeding)
Power
Powered by internal recharg eable Li thium ion b attery. When there is no enough
power, the item will turn off automatically.
Charging process:
Take off the top plastic cover
Using a DC 5V adaptor(not included) or USB cable (included), insert the jack into
the 3.5mm DC hole located on top of the unit for charging while no power.
A red light in front will indicate the charging situation. When battery power is full,
the red light will off automatically.
Bluetooth Speaker Operation
Turn on the unit by pushing the ON/OFF switch at the bottom to ON position, direction
light in Green indicates the power situation.
A Blue light will start blinking to indicate the speaker is in paring mode and searching
for your Bluetooth mobile device.
Bluetooth speaker device name is “SB-01”. The Blue light will begin to flashing four
times every 3 seconds after pairing successfully. (pairing code is 0000 if requested.)
Start playing music on your device. Keep your device within 33feet (10m) of your
speaker.
Adjust the volume of your device to a comfortable level.
Turn off the unit when not in used.
Universal Speaker Operation
For other music devices without Bluetooth, use the attached audio input cable. Insert
the 3.5mm jacks into the “LINE-IN” hole and the earphone hole on your device.
Turn on the unit and start playing music.
Caution:
This is not a toy. Please keep away from small children.
Please keep away from water / heat.
Low power may cause poor connection even no working of Bluetooth.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:.
This equipment complies with FCC radiation exposure requirement.
The device canbe used in portable exposure condition without RF striction.