Powerboss Admiral 48 Ride On Sweeper Scrubber Operators Manual

2017-01-12

• Introduction
• Preface
• Intended use
• Notes on warranty
• Acceptance of the machine
• 1 Safety Information
  • 1.1 Safety and warning symbols
  • 1.2 General information
  • 1.3 Operating information
  • 1.4 Maintenance information
  • 1.5 Particular risks
    • 1.5.1 Electronics
    • 1.5.2 Batteries
  • 1.6 Environmental protection
  • 1.7 Labels on the vehicle
• 2 Starting Up
  • 2.1 Instruction
  • 2.2 Initial battery charge
  • 2.3 Prior to starting up for the first time
    • 2.3.1 Installing brushes and pads
    • 2.3.2 Installing and adjusting the squeegee
    • 2.3.3 Adjusting the driver's seat
  • 2.4 Before starting up daily
• 3 Operation
  • 3.1 Method of operation
    • 3.1.1 Pre-sweep/vacuum unit
    • 3.1.2 Scrubbing unit
    • 3.1.3 Squeegee
    • 3.1.4 Suction turbines (suction)
    • 3.1.5 Fresh water tank
    • 3.1.6 Recovery tank
    • 3.1.7 Traction drive
    • 3.1.8 Brakes
    • 3.1.9 Batteries and charger
    • 3.1.10 Options
  • 3.2 Operating and indicator elements
    • 3.2.1 Operating elements in the driver's cab
    • 3.2.2 Left-hand operating panel
    • 3.2.3 Right-hand operating panel
    • 3.2.4 Operating elements on the vehicle
  • 3.3 Operation
    • 3.3.1 Switching the vehicle on
    • 3.3.2 Accelerating
    • 3.3.3 Stopping and parking
    • 3.3.4 Cleaning
    • 3.3.5 Switching the vehicle off
    • 3.3.6 Loading and transporting the vehicle
  • 3.4 After finishing work
  • 3.5 Function faults
    • 3.5.1 Error code table
    • 3.5.2 Other function faults
• 4 Technical Data
• 5 Maintenance and Service
  • 5.1 PowerBoss system maintenance
  • 5.2 Maintenance report
  • 5.3 Maintenance schedule
    • 5.3.1 PowerBoss system maintenance, customer
    • 5.3.2 PowerBoss system maintenance I
    • 5.3.3 PowerBoss system maintenance II
    • 5.3.4 PowerBoss system maintenance III/S (safety check)
  • 5.4 Battery system
    • 5.4.1 Charging batteries
    • 5.4.2 Servicing the driving batteries
    • 5.4.3 Disassembling the battery
    • 5.4.4 Installing the battery
    • 5.4.5 Disposing of batteries
    • 5.4.6 Deep discharge signal transducer (BMS)
  • 5.5 Fresh water tank
    • 5.5.1 Filling the fresh water tank
    • 5.5.2 Emptying the fresh water tank
    • 5.5.3 Cleaning the draining hose cap
    • 5.5.4 Cleaning the fresh water filter
  • 5.6 Recovery tank
    • 5.6.1 Emptying the recovery tank
    • 5.6.2 Cleaning the recovery tank
    • 5.6.3 Cleaning the draining hose cap
    • 5.6.4 Cleaning the air intake filter
    • 5.6.5 Cleaning the openings to the fresh water tank
  • 5.7 Scrubbing unit
    • 5.7.1 Changing the brushes
    • 5.7.2 Installing new rubber deflector strips
  • 5.8 Squeegee
    • 5.8.1 Cleaning the squeegee
    • 5.8.2 Disassembling the squeegee
    • 5.8.3 Installing the squeegee
    • 5.8.4 Changing the sealing strips
    • 5.8.5 Adjusting the support rollers
  • 5.9 Pre-sweep/Vacuum unit
    • 5.9.1 Emptying the dirt hopper
    • 5.9.2 Dust vacuum
    • 5.9.3 Side brushes
    • 5.9.4 Cylindrical brush
  • 5.10 Wheels
    • 5.10.1 Changing the rear wheels
    • 5.10.2 Changing the front wheel
  • 5.11 Electrical installation
    • 5.11.1 Red control lamps
    • 5.11.2 Error codes
    • 5.11.3 Fuses
    • 5.11.4 Drive control relay
  • 5.12 Cleaning the vehicle
  • 5.13 Transport and towing
• PowerBoss Warranty
  • PowerBoss Made Simple Commercial Limited Warranty, page 1
  • PowerBoss Made Simple Commercial Limited Warranty, page 2
• notes
  • Notes 1
  • Notes 2