TCL Technoly Electronics PS000024 Auvio Rugged Stereo Bluetooth Speaker User Manual
TCL Technoly Electronics (Huizhou) Co., Ltd. Auvio Rugged Stereo Bluetooth Speaker
User Manual
2 3 4 5 6 7 8 9
rugged stereo
bluetooth® speaker
We hope you enjoy your AUVIO Rugged Stereo Bluetooth
Speaker with True Wireless stereo sound capability. Tough
and water-resistant, this speaker is ideal for outdoors. It's also
designed with a built-in mic and speakerphone so you can take
calls as well as listen to music from your smartphone. Please
read this user's guide before using your new speaker.
Package Contents
• Speaker • USB Charging Cable
• User’s Guide
Specifications
Battery ................ Rechargeable 7.4V, 2200mAh lithium polymer
Battery Charging Voltage ...................................................DC 5V, 2A
Charging Time ............................................................. approx. 4 hours
Play Time ............................................................................ up to 6 hours
Frequency Response ............................. (speaker) 120 Hz – 20 KHz
Output Power.................................................................................2 × 8W
Impedance ................................................................................... 4 Ohms
Driver ................................................. 2 × 1.5 in" (38mm) neodymium
Bluetooth Protocol .............. V4.2 with A2DP, AVRCP, HFP Profile
Operation Range ................................................................ 33 ft. (10m)
Water resistance ...............................................................................IPX5
Specifications are subject to change and improvement
without notice. Actual product may vary from the images
found in this document. Charge Your Speaker
1. Lift the cover on the bottom to access the jacks. Then
connect the supplied charging cable to the DC IN jack
and a USB power source.
I LED lights red during charging and turns o when fully
charged.
2. Unplug after charging, and rmly replace the cover to
protect the jacks from water, dust or dirt.
User’s Guide
4000770
Notes:
• The speaker will disconnect and power down from your
device if they are too far apart, or left idle. To reconnect,
move the speaker closer to the device within 5 minutes.
• The last volume setting used on the speaker is memorized
after switching o.
• Music playback is paused during call functions and
resumes when the call is ended.
Clear Bluetooth Pairing
Your speaker automatically reconnects to the most recently
paired device when switched on. If you want to change to other
Bluetooth devices, or in case of problems pairing, press and
hold I and + for 3 seconds.
Multipoint Connection
This speaker is multipoint-enabled. This allows you to easily
access and play music or take a call through the speaker from
either one of two connected Bluetooth devices.
1. To use multipoint, make sure you pair each of your
devices separately. See Pairing a Bluetooth Device.
2. There is no need to switch o the speaker to pair your
second device. Press and hold
/ 2 seconds to start
Bluetooth pairing your second device. Bluetooth status
on your rst device will automatically disconnect.
3. After your second device is successfully paired and
connected, to enjoy multipoint, go to the Bluetooth
menu on your rst device to reactivate Bluetooth
connection status. Both your devices are now connected.
© 2016 General Wireless Operations Inc.
All rights reserved. AUVIO is a registered
trademark used by General Wireless
Operations Inc. dba RadioShack.
07A16
4000770
Printed
in China
Bottom View
DC IN
Connect the included USB
charging cable here to charge.
AUX
For line-in listening option.
/
Call functions on speakerphone
Start/disconnect Bluetooth pairing
Answer, end, reject and switch
between calls
LED Indicator
Flashes quickly - pairing / incoming
call, connecting Bluetooth / True
Wireless
Lights steadily - Bluetooth
connected, engaged in call
Using True Wireless Mode
To play your music from your smartphone or other Bluetooth-
enabled device, for best sound performance you'll need an
additional AUVIO BTS800 speaker. Conveniently, there is no
need to pair the second speaker.
True Wireless Activation
Before you start activation or when using True Wireless mode,
make sure of the following:
• Your rst speaker is paired before you setup True Wireless
mode.
• Both speakers are on and in stop mode.
• If you are using multipoint connection, you need to turn o
multipoint on one of your 2 Bluetooth devices.
1. Press the button on one speaker. The
/ LED
ashes quickly.
2. On another speaker, press the button, the
/
LED ashes quickly.
3. When True Wireless is successfully activated, the and
/ LEDs light steadily on both your speakers.
4. To swap left/right channel sound on your two speakers,
press and hold button for 2 seconds on either
speaker.
5. To exit True Wireless, press the button on either
speaker.
Notes:
• Smart Power O: During True Wireless playback, press
and hold I for 2 seconds on either speaker to switch o
both speakers simultaneously.
• Smart True Wireless: Once activated, True Wireless is
memorized by your speakers. True Wireless is the default
playback mode when you next switch on the two speakers.
•Troubleshooting TW Activation: In case of diculty
activating, turn o each speaker. Then switch the rst
speaker on again, followed by the second speaker, and
start playing a song. Wait a few seconds to hear if True
Wireless has been activated. If not, repeat True Wireless
Activation and complete steps 1-3 above within 3
minutes.
Connecting with AUX
For device players without Bluetooth functionality, use an ⅛"
(3.5mm) audio cable (not included) to connect to the speaker’s
AUX jack.
Note: Bluetooth functionality is automatically deactivated
when playing music via AUX port.
Resetting the Speaker
In case the speaker's buttons are not functioning properly
during operation, press and hold + and - at the same time
for 5 seconds to reset and switch o the speaker. Any previous
TW activation will not be lost.
FCC Information
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o and
To... Button Press
Turn on/ o speaker I
...and hold 2 sec
Start Bluetooth pairing
/
Disconnect Bluetooth pairing
Volume up/ down +/ −...quickly, or press
and hold
Calls
Answer/ end call
/×1
Reject an incoming call
/...and hold 2 sec
Switch to an incoming call and
end the current call
EQ
Select outdoor/indoor EQ I×1
True Wireless (TW)
Activate on rst speaker
×1Activate on 2nd speaker
Deactivate True Wireless
Swap left/ right channel ...and hold 2 sec
Controls Overview
+/−
Adjust volume
Mic
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from
that to which the receiver is connected.
• Consult your dealer or an experienced radio/TV technician for
help.
If you cannot eliminate the interference, the FCC requires that you
stop using your equipment. Changes or modications not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Limited Warranty
Go to www.radioshack.com/help for details.
RadioShack Customer Relations
300 RadioShack Circle, Fort Worth, TX 76102
I
Turn on/o speaker
LED Indicator
Red - Charging
Flashes red slowly - low battery
Blue - Outdoor EQ is selected.
O - Indoor EQ
Activate / deactivate True
Wireless
Swap L/R channels
when two speakers are
connected
LED Indicator
Lights steadily - True
Wireless activated
Complies with the European Union’s
“Restriction of Hazardous Substances
Directive,” which protects the environment
by restricting specic hazardous materials
and products.
www.radioshack.com
Notes:
• You can charge the speaker and use it at the same time.
• When the battery is low, the I LED ashes red slowly, and
the speaker will eventually automatically turn o.
Lithium Battery Notes:
• Charge batteries on a reproof surface away from
ammable items or liquids. Follow the instructions for
charging the speaker and do not charge longer than
recommended.
• Recycle lithium batteries. Do not dispose of them in the
trash. Do not burn or bury batteries. Do not puncture or
crush. Do not disassemble.
• If the electrolyte in the cells should get on your skin,
thoroughly wash with soap and water. If in the eyes, rinse
thoroughly with cool water. Immediately seek medical
attention.
Pairing to a Bluetooth Device
1. Press and hold I for 2 seconds to turn on the speaker.
The
/LED ashes blue quickly as your speaker
searches for Bluetooth devices.
2. When pairing to a device for the rst time, press and hold
/ for 2 seconds to start Bluetooth pairing.
3. Activate your device’s Bluetooth function (refer to your
device’s user’s guide). When your device locates AUVIO
BTS800, select this from the device list. When paired, the
/indicator lights blue steadily.
4. Use the controls on your device to play music. To adjust
volume, you can use the speaker's +/− buttons, or your
device's controls.
5. During playback, press I to toggle between two EQ
options for indoor/ outdoor listening.
The Bluetooth® word mark and logos are owned by Bluetooth SIG,
Inc. and any use of such marks by General Wireless Operations Inc.
is under license.
AUX
4000770_UG_EN.indd All Pages 7/5/2016 11:53:15 AM