TCL Technoly Electronics PS000025 Realistic Stereo Bluetooth Speaker User Manual

TCL Technoly Electronics (Huizhou) Co., Ltd. Realistic Stereo Bluetooth Speaker

User Manual

2 3 4 5 6 7 8 9 10
stereo bluetooth® speaker
We hope you enjoy your REALISTIC Stereo Bluetooth Speaker
with True Wireless stereo sound capability. Sleek and water
resistant, this speaker is also designed with a built-in mic and
speakerphone so you can take calls as well as listen to music
from your smartphone. Please read this user's guide before
using your new speaker.
Package Contents
Speaker
USB Charging Cable
User’s Guide
Specifications
Battery...........................Rechargeable 7.4V 2200mAh lithium polymer
Battery Charging Voltage ............................................................. DC 5V, 2A
Battery Charging Time ....................................................... approx. 4 hours
Play Time ...................................................................................... up to 6 hours
Frequency Response.......................................(speaker) 120 Hz – 20 KHz
Output Power .......................................................................................10 W × 2
Impedance ............................................................................................. 4 Ohms
Driver ........................................................... 2 × 1.5 in. (38mm) neodymium
Bluetooth Protocol ........................V4.2 with A2DP, AVRCP, HFP Profile
Operation Range .......................................................................... 33 ft. (10m)
Microphone type...............................................................Echo cancellation
Water resistance .........................................................................................IPX5
Specifications are subject to change and improvement without
notice. Actual product may vary from the images found in this
document.
Charge Your Speaker
1. Lift the cover on the side to access the jacks. Then
connect the supplied charging cable to the DC IN jack
and a USB power source.
G indicator lights red during charging and turns o when
fully charged.
2. Unplug after charging, and rmly replace the cover to
protect the jacks from water, dust or dirt.
User’s Guide
4000771
Notes:
The speaker will disconnect from Bluetooth function and
power down from your device if they are too far apart, or
left idle. To reconnect, move the speaker closer to the
device within 5 minutes.
The last volume setting used on the speaker is memorized
after switching o.
Music playback is paused during call functions and
resumes when the call ends.
Clear Bluetooth Pairing
Your speaker automatically reconnects to the most recently
paired device when switched on. If you want to change to other
Bluetooth devices, or in case of problems with pairing, press
and hold G and + for 3 seconds. The indicator ashes
quickly and the speaker starts searching for another Bluetooth
device.
Multipoint Connection
This speaker is multipoint-enabled. This allows you to easily
access and play music or take a call through the speaker from
either one of two connected Bluetooth devices.
1. To use multipoint, make sure you pair each of your
devices separately. See Pairing a Bluetooth Device.
2. There is no need to switch o the speaker to pair your
second device. Press and hold 2 seconds to start
Bluetooth pairing your second device. Bluetooth status
on your rst device will automatically disconnect.
3. After your second device is successfully paired and
connected, to enjoy multipoint, go to the Bluetooth
menu on your rst device to reactivate Bluetooth
connection status. Both your devices are now connected.
© 2016 General Wireless Operations Inc.
All rights reserved. REALISTIC is a
registered trademark used by General
Wireless Operations Inc. dba RadioShack.
The Bluetooth® word mark and logos are owned by
Bluetooth SIG, Inc. and any use of such marks by
General Wireless Operations Inc. is under license.
06A16
4000771
Printed
in China
AUX
For line-in listening option,
use an ⅛" (3.5mm) audio
cable (not included).
Note: Bluetooth functionality is
automatically deactivated
when AUX
playing music via
Complies with the European Union’s
“Restriction of Hazardous Substances
Directive,” which protects the
environment by restricting specic
hazardous materials and products.
Using True Wireless Mode
To play your music from your smartphone or other Bluetooth-
enabled device, for best sound performance you'll need an
additional REALISTIC 4000771 speaker. Conveniently, there is
no need to pair the second speaker.
True Wireless Activation
Before you start activation or when using True Wireless mode,
make sure of the following:
Your rst speaker is paired before you setup True Wireless
mode.
Both speakers are on and in stop mode.
If you are using multipoint connection, you need to turn o
multipoint on one of your 2 Bluetooth devices.
1. Press the button on one speaker. The indicator
ashes quickly.
2. On another speaker, press the button, the
indicator ashes quickly.
3. When True Wireless is successfully activated, the and
indicators light steadily on both your speakers.
4. To swap left/right channel sound on your two speakers,
press and hold button for 2 seconds on either
speaker.
5. To exit True Wireless, press the button on either
speaker.
Notes:
Smart Power O: During True Wireless playback, press
and hold G on either speaker for 2 seconds to switch o
both speakers simultaneously.
Smart True Wireless: Once activated, True Wireless is
memorized by your speakers. True Wireless is the default
playback mode when you next switch on the two speakers.
Troubleshooting TW Activation: In case of diculty
activating, turn o each speaker. Then switch the rst
speaker on again, followed by the second speaker, and
start playing a song. Wait a few seconds to hear if True
Wireless has been activated. If not, repeat True Wireless
Activation and complete steps 1-3 above within 3
minutes.
Resetting the Speaker
In case the speaker's buttons are not functioning properly
during operation, press and hold + and - at the same time
for 5 seconds to reset and switch o the speaker. Any previous
TW activation will not be lost.
FCC Information
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit dierent
from that to which the receiver is connected.
To... Button Press
Turn on/ o speaker G...and hold 2 sec
Start Bluetooth pairing ...and hold 2 sec
Disconnect Bluetooth pairing
Volume up / down +/ ...quickly, or
press and hold
Calls
Answer / end call ×1
Reject an incoming call
...and hold 2 sec
Switch to an incoming call and
end the current call
True Wireless
Activate on rst speaker
×1Activate on 2nd speaker
Deactivate True Wireless
Swap left/ right channel ...and hold 2 sec
Controls Overview
+/
Adjust volume
G
Turn on/o speaker
G Indicator
Lights steadily - speaker is on
Flashes quickly - incoming call
Red - charging
Activate / deactivate True Wireless
Select L/R channels when two
speakers are connected
Indicator
Lights steadily - True Wireless
activated
Enters Bluetooth pairing mode
Clear Bluetooth pairing
Indicator
Flashes quickly - pairing Bluetooth,
connecting True Wireless
Flashes slowly - pairing time-out
Lights steadily - Bluetooth connected
§
Play / pause music
Answer, end, reject and switch
between calls
Indicator
Flashes quickly - receiving a call
Lights steadily- during a call
Notes:
You can charge the speaker and use it at the same time.
When the battery is low, the G indicator ashes red slowly,
and the speaker will eventually automatically turn o.
Lithium Battery Notes:
Charge batteries on a reproof surface away from
ammable items or liquids. Follow the instructions for
charging the speaker and do not charge longer than
recommended.
Recycle lithium batteries. Do not dispose of them in the
trash. Do not burn or bury batteries. Do not puncture or
crush. Do not disassemble.
If the electrolyte in the cells should get on your skin,
thoroughly wash with soap and water. If in the eyes, rinse
thoroughly with cool water. Immediately seek medical
attention.
Pairing a Bluetooth Device
1. Press and hold G 2 seconds to turn on the speaker. The
G indicator lights.
2. Press and hold to enter pairing mode if your speaker
doesn't enter automatically. The indicator ashes
quickly as your speaker searches for Bluetooth devices.
3. Activate your device’s Bluetooth function (refer to
your device’s user’s guide). When your device locates
REALISTIC BTS1000, select this from the device list.
When paired, the indicator lights steadily.
4. Use the controls on your device to play music. To adjust
volume, you can use the speakers +/ buttons, or those
on your device.
DC IN
Connect the included
USB charging cable
here to charge.
www.radioshack.com
Consult your dealer or an experienced radio/TV technician
for help.
Changes or modications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
Limited Warranty
Go to www.radioshack.com/help for details.
RadioShack Customer Relations
300 RadioShack Circle, Fort Worth, TX 76102
4000771_UG_EN.061616.indd All Pages 6/24/2016 10:29:25 AM
port.

Navigation menu